RESUMEN
In this work, the adsorption height of Ag adatoms on the Fe3O4(001) surface after exposure to CO was determined using normal incidence x-ray standing waves. The Ag adatoms bound to CO (Ag1 CO) are found to be pulled out of the surface to an adsorption height of 1.15 Å ± 0.08 Å, compared to the previously measured height of 0.96 Å ± 0.03 Å for bare Ag adatoms and clusters. Utilizing DFT+vdW+U calculations with the substrate unit cell dimension fixed to the experimental value, the predicted adsorption height for Ag1 CO was 1.16 Å, in remarkably good agreement with the experimental results.
RESUMEN
We have experimentally determined the lateral registry and geometric structure of free-base porphine (2H-P) and copper-metalated porphine (Cu-P) adsorbed on Cu(111), by means of energy-scanned photoelectron diffraction (PhD), and compared the experimental results to density functional theory (DFT) calculations that included van der Waals corrections within the Tkatchenko-Scheffler approach. Both 2H-P and Cu-P adsorb with their center above a surface bridge site. Consistency is obtained between the experimental and DFT-predicted structural models, with a characteristic change in the corrugation of the four N atoms of the molecule's macrocycle following metalation. Interestingly, comparison with previously published data for cobalt porphine adsorbed on the same surface evidences a distinct increase in the average height of the N atoms above the surface through the series 2H-P, Cu-P, and cobalt porphine. Such an increase strikingly anti-correlates the DFT-predicted adsorption strength, with 2H-P having the smallest adsorption height despite the weakest calculated adsorption energy. In addition, our findings suggest that for these macrocyclic compounds, substrate-to-molecule charge transfer and adsorption strength may not be univocally correlated.
RESUMEN
We demonstrate here that theory-assisted near-edge X-ray absorption fine-structure (NEXAFS) spectroscopy enables the site-sensitive monitoring of on-surface chemical reactions, thus, providing information not accessible by other techniques. As a prototype example, we have used free-base 5,10,15-tris(pentafluorophenyl)corroles (3H-TpFPC) adsorbed on Ag(111) and present a detailed investigation of the angle-dependent NEXAFS of this molecular species as well as of their thermally induced derivatives. For this, we have recorded experimental C and N K-edge NEXAFS spectra and interpret them based on XAS cross-section calculations by using a continuous fraction approach and core-hole including multiprojector PAW pseudopotentials within DFT. We have characterized the as-deposited low temperature (200â K) phase and unraveled the subsequent changes induced by dehydrogenation (at 330â K) and ring-closure reactions (at 430â K). By exemplarily obtaining profound insight into the on-surface chemistry of free-base corrolic species adsorbed on a noble metal this work highlights how angle-dependent XAS combined with accurate theoretical modeling can serve for the investigation of on-surface reactions, whereby even highly similar molecular structures, such as tautomers and isomers, can be distinguished.
RESUMEN
The normal incidence X-ray standing wave (NIXSW) technique has been used to follow the evolution of the adsorption geometry of Ni adatoms on the Fe3O4(001)-(â2 × â2)R45° surface as a function of temperature. Two primary surface region sites are identified: a bulk-continuation tetrahedral site and a sub-surface octahedral site, the latter site being preferred at higher annealing temperatures. The ease of incorporation is linked to the presence of subsurface cation vacancies in the (â2 × â2)R45° reconstruction and is consistent with the preference for octahedral coordination observed in the spinel compound NiFe2O4.
RESUMEN
The adsorption of thymine, a pyrimidine based nucleobase, was studied on the (110) termination of rutile titanium dioxide in order to understand the thermal stability and gross structural parameters of the interaction between a strongly polar adsorbate and a highly corrugated transition metal oxide surface. Near-edge X-ray absorption fine structure (NEXAFS), X-ray photoelectron spectroscopy (XPS), temperature programmed XPS and temperature programmed desorption indicated the growth of a room temperature stable bilayer, which could only be removed by annealing to 450 K. The remaining first layer was remarkably robust, surviving annealing up to 550 K before undergoing N-H bond scission. The comparison to XPS of a sub-monolayer exposure of 1-methyluracil shows that the origin of the room temperature stable bilayer is not intermolecular interactions. This discovery, alongside the deprotonation of one of the first layer's pyrimidinic nitrogen atoms at room temperature, suggests that the thymine molecules in the first layer bind to the undercoordinated surface Ti atoms, and the second layer thymine molecules coordinate with the bridging oxygen atoms which protrude above the Ti surface plane on the (110) surface. The NEXAFS results indicate an almost upright orientation of the molecules in both layers, with a 30 ± 10° tilt away from the surface normal.
RESUMEN
We report on the adsorption and self-metalation of a prototypic tetrapyrrole compound, the free-base porphine (2H-P), on the Cu(111) surface. Our multitechnique study combines scanning tunneling microscopy (STM) results with near-edge X-ray absorption fine-structure (NEXAFS) and X-ray photoelectron spectroscopy (XPS) data whose interpretation is supported by density functional theory calculations. In the first layer in contact with the copper substrate the molecules adsorb coplanar with the surface as shown by angle-resolved NEXAFS measurements. The quenching of the first resonance in the magic angle spectra of both carbon and nitrogen regions indicates a substantial electron transfer from the substrate to the LUMO of the molecule. The stepwise annealing of a bilayer of 2H-P molecules sequentially transforms the XP and NEXAFS signatures of the nitrogen regions into those indicative of the coordinated nitrogen species of the metalated copper porphine (Cu-P), i.e., we observe a temperature-induced self-metalation of the system. Pre- and post-metalation species are clearly discriminable by STM, corroborating the spectroscopic results. Similar to the free-base porphine, the Cu-P adsorbs flat in the first layer without distortion of the macrocycle. Additionally, the electron transfer from the copper surface to the molecule is preserved upon metalation. This behavior contrasts the self-metalation of tetraphenylporphyrin (2H-TPP) on Cu(111), where both the molecular conformation and the interaction with the substrate are strongly affected by the metalation process.
RESUMEN
The two-dimensional (2D) Co oxide monolayer phase with (9 × 2) structure on Pd(100) has been investigated experimentally by scanning tunneling microscopy (STM) and theoretically by density functional theory (DFT). The high-resolution STM images reveal a complex pattern which on the basis of DFT calculations is interpreted in terms of a coincidence lattice, consisting of a CoO(111)-type bilayer with significant symmetry relaxation and height modulations to reduce the polarity in the overlayer. The most stable structure displays an unusual zig-zag type of antiferromagnetic ordering. The (9 × 2) Co oxide monolayer is energetically almost degenerate with the c(4 × 2) monolayer phase, which is derived from a single CoO(100)-type layer with a Co(3)O(4) vacancy structure. Under specific preparation conditions, the (9 × 2) and c(4 × 2) structures can be observed in coexistence on the Pd(100) surface and the two phases are separated by a smooth interfacial boundary line, which has been analyzed at the atomic level by STM and DFT. The here described 2D Co oxide nanolayer systems are characterized by a delicate interplay of chemical, electronic, and interfacial strain interactions and the associated complexities in the theoretical description are emphasized and discussed.
RESUMEN
By exploiting an established on-surface metallation strategy, we address the ability of the corrolic macrocycle to stabilise transition metal ions in high-valent (III) oxidation states in metal-supported molecular layers. This approach offers a route to engineer adsorbed metal complexes that cannot be easily fabricated by organic synthesis methods and bear a vacant axial coordination site for catalytic conversions.
RESUMEN
Utilising normal incidence X-ray standing waves we rigourously scrutinise the "inverted model" as the adsorption structure of free-base tetraphenyl porphyrin on Cu(111). We demonstrate that the iminic N atoms are anchored at near-bridge adsorption sites on the surface displaced laterally by 1.1 ± 0.2 Å in excellent agreement with previously published calculations.
RESUMEN
The surface stabilized MnO(100)-like monolayer, characterized by a regular c(4 x 2) distribution of Mn vacancies, is studied by hybrid functionals and discussed in the light of available scanning tunneling microscopy and high-resolution electron energy loss spectroscopy data. We show that the use of hybrid functionals is crucial to account for the intermingled nature of magnetic interactions, electron localization, structural distortions, and surface phonons. The proposed Pd(100) supported Mn(3)O(4) structure is excellently compatible with the experiments previously reported in literature.
RESUMEN
Two-dimensional manganese oxide layers have been grown on Pd(100) and have been characterized by means of scanning tunnelling microscopy, low energy electron diffraction and x-ray photoelectron spectroscopy (XPS). The complex surface phase diagram of MnO(x) on Pd(100) is reported, where nine different novel Mn oxide phases have been detected as a function of the chemical potential of oxygen µ(O). Three regions of the chemical potential of oxygen can be identified, in which structurally related oxide phases are formed, often in coexistence at the surface. The different regions of µ(O) are reflected in the oxidation states of the respective Mn oxide nanolayers as revealed by the Mn 2p and O 1s XPS binding energies. The MnO(x) nanolayers form two-dimensional wetting layers and it is speculated that they mediate the epitaxial growth of MnO on Pd(100) by providing structurally graded interfaces.
RESUMEN
We demonstrate that chemically well-defined aromatic self-assembled monolayers (SAMs) bonded via a carboxylate head group to surfaces of ferromagnetic (FM = Co, Ni, Fe) transition metals can be prepared at ambient temperature in ultra-high vacuum and are thermally stable up to 350-400 K (depending on the metal). The much superior stability over thiolate-bonded SAMs, which readily decompose above 200 K, and the excellent electronic communication guaranteed by the carboxylate bonding render benzoate/FM-metal interfaces promising candidates for application in spintronics.
RESUMEN
The growth of ultrathin two-dimensional manganese oxide nanostripes on vicinal Pd(1 1 N) surfaces leads to particular stable configurations for certain combinations of oxide stripe and substrate terrace widths. Scanning tunneling microscopy and high-resolution low-energy electron diffraction measurements reveal highly ordered nanostructured surfaces with excellent local and long-range order. Density functional theory calculations provide the physical origin of the stabilization mechanism of 'magic width' stripes in terms of a finite-size effect, caused by the significant relaxations observed at the stripe boundaries.
RESUMEN
Scanned-energy mode photoelectron diffraction results show the adsorption site of molecular water on TiO2(110) to be atop under-coordinated surface Ti atoms, confirming the results of total energy calculations and STM imaging. However, the Ti-O(water) bond length is 2.21 +/- 0.02 A, much longer than Ti-O bond lengths in strongly chemisorbed species on this surface, but significantly shorter than found in most total energy calculations. The need for theory to describe this weak bond effectively may be a key factor in the controversial problem of understanding this important surface reaction system.
RESUMEN
The results of experimental measurements and theoretical simulations of circular dichroism in the angular dependence (CDAD) of photoemission from atomic core levels of each of the enantiomers of a chiral molecule, alanine, adsorbed on Cu(110) are presented. Measurements in, and out of, substrate mirror planes distinguish CDAD due to the chirality of the sample and the experimental geometry. The effect due to sample chirality is relatively weak, so such measurements may not provide a routine spectral fingerprint of adsorbate chirality.