Direct Quantification of Attogram Levels of Strontium-90 in Microscale Biosamples Using Isotope Dilution-Thermal Ionization Mass Spectrometry Assisted by Quadrupole Energy Filtering.

Although thermal ionization mass spectrometry (TIMS) has been employed for the high-precision analysis of isotope ratios, direct quantification of artificial mono-nuclide in the environment is difficult by even using isotope dilution (ID) due to the coexistence of the great magnitude of natural stable nuclides or isobars. In traditional TIMS and ID-TIMS, a sufficient amount of stable Sr doped on a filament is required to realize a stable and adequate ion-beam intensity (i.e., thermally ionized beams). However, the background noise (BGN) at m/z 90, detected by an electron multiplier, disturbs 90Sr analysis at low concentration levels due to peak tailing of a significant 88Sr ion beam dependent on the 88Sr-doping amount. Here, TIMS assisted by quadruple energy filtering was successfully employed for the direct quantification of attogram levels of an artificial monoisotopic radionuclide strontium-90 (90Sr) in microscale biosamples. Direct quantification was achieved by integrating the ID quantification of natural Sr and simultaneous 90Sr/86Sr isotope ratio analysis. Additionally, the measurement amount calculated by the combination of the ID and intercalibration was corrected for the net result amount of 90Sr by subtracting dark noise and the detected amount derived from the survived 88Sr, which are equivalent with the BGN intensity at m/z 90. Background correction revealed that the detection limits were in the range of 6.15 × 10-2-3.90 × 10-1 ag (0.31-1.95 µBq), depending on the concentration of natural Sr in a 1 µL sample, and the quantification of 0.98 ag (5.0 µBq) of 90Sr in 0-300 mg/L of natural Sr was successful. This method could analyze small sample quantities (1 µL), and the quantitative results were verified against authorized radiometric analysis techniques. Furthermore, the amount of 90Sr in actual teeth was successfully quantified. This method will be a powerful tool for measuring 90Sr in the measurement of micro-samples, which are required to assess and understand the degree of internal radiation exposure.

Mass-spectrometric determination of iodine-129 using O2-CO2 mixed-gas reaction in inductively coupled plasma tandem quadrupole mass spectrometry.

This paper presents a mass-spectrometric method for determining the radionuclide iodine-129 (129I) from the significant amount of interference in inductively coupled plasma tandem quadrupole mass spectrometry (ICP-MS/MS) using a dynamic reaction cell passing a mixture gas of O2 and CO2. Thus far, mass spectrometry analysis of trace amounts of 129I has been hampered by the presence of xenon-129 (129Xe) and the formation of polyatomic ions from excess amounts of stable isotope 127I. In this study, flowing a mixture gas of O2 and CO2 into the dynamic reaction cell (Q2) successfully removed both 129Xe interference and polyatomic interference (127IH2) in the analysis of 129I in ICP-MS/MS. The resulting ratio of (background noise of m/z 129)/127I was 4.6 × 10-10 ± 3.3 × 10-10, which enables the analysis of 10 mBq/L of 129I in the presence of 100 mg/L of stable 127I without chemical separation. The detection limit of this method was 0.73 mBq/L (= 0.11 ng/L) with an APEX-Q sample inlet desolvation device. For demonstration purposes, spike and recovery analysis of rainwater was performed, and good agreement between the spiked and recovered amounts was achieved.

A part per trillion isotope ratio analysis of 90Sr/88Sr using energy-filtered thermal ionization mass spectrometry.

Strontium-90 is a major radioactive nuclide released by nuclear accidents and discharge waste. Input of such radioactive nuclide into earth surface environment causes potential threat of long-term internal exposure when taken up by organism. Rapid and precise measurement of 90Sr in variety of environmental sample is important to understand the distribution and dynamics of 90Sr in the local environment after the accident and to assess the effect of radioactive nuclide inputs on bodies. However, previous 90Sr measurement techniques have drawbacks such as long measurement times for radiometry and high detection limits for mass spectrometry. Here we present a technique to accurately measure a significantly small amount of 90Sr in natural environmental samples using an energy-filtered thermal ionization mass spectrometry. Our technique achieved a 90Sr detection limit of 0.23 ag, which corresponds to a 90Sr activity of 1.2 µBq. The detection limit was lowered by two orders of magnitude compared with the previous mass spectrometric 90Sr analyses. The ability of our technique will expand the applicability of mass spectrometric 90Sr survey not only to the rapid 90Sr survey upon nuclear accidents but also to study a long-term environmental diffusion of radioactive materials using size-limited environmental and biological samples.

Adsorption Behavior of Pu(IV), Am(III), Cm(III), and U(VI) on Desferrioxamine B-immobilized Micropolymer and Its Applications in the Separation of Pu(IV).

The adsorption properties of Pu(IV), Am(III), Cm(III), and U(VI) on desferrioxamine B-immobilized micropolymeric resin (DMPs) and adsorbed species were elucidated using thermodynamic constants and log ß values. This allowed the determination of adsorption characteristics (91, 95, 88, and 97% for Pu(IV), Am(III), Cm(III), and U(VI), respectively) and individual pH-independent adsorption properties. Pu(IV) could be separated from Am(III), Cm(III), and U(VI) at pH 2. The separation of Pu(IV) from Am(III), Cm(III), and U(VI) was achieved by controlling the pH of the solution using a single resin.