RESUMEN
Recently, titanium-based nanostructures with high nonlinear optical properties have found use in ultrafast photonic system applications. Here, we report a study of the third-order nonlinear optical property of the ${{\rm CuCo}_{0.5}}{{\rm Ti}_{0.5}}{{\rm O}_2}$CuCo0.5Ti0.5O2 (CCoTO) nanostructure synthesized via a simple chemical route. The 40-70 nm CCoTO nanoparticles with centrosymmetric crystalline structure show strong absorption in the 325-850 nm wavelength range due to the presence of different crystalline phases and surface vacancies. A Z-scan technique is used to study the electronic third-order nonlinearity of the synthesized nanoparticles, where a low-repetition-rate 120 fs laser source is employed to minimize thermal agitation-related nonlinearity. The CCoTO nanoparticles possess high surface defects due to oxygen- and copper-related vacancies, which are able to enhance the exciton oscillator strength resulting from the high value of third-order optical nonlinearity. The estimated values of nonlinear refractive index (${n_2}$n2) and nonlinear absorption coefficient ($\beta $ß) of the CCoTO are $ - {1.24}\; \times \;{{10}^{ - 15}}$-1.24×10-15 and ${3.79} \times {{10}^{ - 11}}$3.79×10-11, respectively, under ${188}\,\,{{\rm GW/cm}^2}$188GW/cm2 incident intensity. The intensity-dependent nonlinear optical property of the synthesized nanoparticles is also studied under different incident laser irradiation (62.7, 93, and ${188}\,\,{{\rm GW/cm}^2}$188GW/cm2). In the two-photon absorption (TPA)-dominated third-order nonlinear optical process, the values of ${n_2}$n2 and $\beta $ß of CCoTO are increased with intensifying the incident laser irradiation. The obtained high value of third-order optical nonlinearity of the synthesized nanostructure can be exploited in optical power limiters, pulse power reshaping, and optical switching applications.
RESUMEN
Because of the superior optical and electrical properties, copper-impregnated size tuneable high-temperature stable manganese dioxide semiconductor quantum dots (SQDs) have been successfully synthesized by a modified chemical synthesis technique. Their size-dependent dielectric properties, semiconducting properties, and current-voltage ( I- V) characteristics have been investigated. X-ray diffraction pattern and Raman spectra confirmed that the required phase is present. Because of the different sintering temperature tuneable size of SQDs has been found and confirmed by high-resolution transmission electron microscopy. The band gap energy of the material is found to be 1.25-1.67 eV, measured from Tauc plot using UV-vis absorbance spectrum and their semiconducting properties have been confirmed by the non linear current-voltage ( I- V) behavior. Most intense green emission peak of photoluminescence (PL) spectroscopy confirms the oxygen vacancy defect state. The stoke shifting of Raman spectra, UV absorption, and PL emission are the footprint of quantum confinement effect. Incorporation of a little amount of Cu in tetragonal hollandite structure of α-MnO2 generates strain within that structure. This leads to create sufficient crystal defect state as well as rise in dielectric constant accompanied with low dielectric loss and higher ac conductivity. All these highly desirable properties make the SQDs a potential candidate for developing multifunctional photo-electronic devices. Owing to the tuneable band gap and electronic transport of the SQDs, we realized that the controllable size paves the way for designing SQDs possessing unique properties for optical and electronic device applications. Using this material as a high dielectric separator, a high-performance supercapacitor has been successfully fabricated which can light up 15 light-emitting diodes for 47 min 23 s after charging them only for 30 s.