RESUMEN
Combined processes of light-emitting diodes ultraviolet (LED UV) and chlorination (Cl2) are alternative disinfection technologies in drinking water, while the formation of disinfection by-products (DBPs) needs to be evaluated. This study investigated the impacts of critical water matrix factors on the DBP formation in the combined processes. Moreover, the correlation between the degraded natural organic matter (NOM) and the formed DBP was studied. Simultaneous UV/Cl2 outperformed single Cl2 and sequential combined processes in degrading humic acids (HA) and resulted in the highest DBP yield. Iodide at 5-20 µg/L and bromide at 0.05-0.2 mg/L slightly affected the degradation of organics, while increased the formation of brominated DBPs up to 36.6 µg/L. pH 6 was regarded as the optimum pH, achieving high efficiency of HA degradation and a lower level of total DBP formation than pH 7 and 8 by 11 % and 24 %, respectively. Compared to HA samples (46.8-103.9 µg/L per mg/L DOC), NOM in canal water were less aromatic and yielded fewer DBPs (19.6 and 21.2 µg/L per mg/L DOC). However, the extremely high bromide in site 1 samples (18.6 mg/L) shifted the chlorinated DBPs to their brominated analogues, posting around 1 order of magnitude higher levels of toxicities than HA samples. The reduction of absorbance at 254 nm (UV254) correlated with all DBP categories in HA samples, while the correlation coefficients were compromised when included in the canal samples. For the first time, this study found that parallel factor analysis (PARAFAC) would neglect the fluorescence change caused by iodide/bromide in UV/Cl2, while the changes could be captured by self-organising map (SOM) trained with full fluorescence spectra. Fluorescence Ex/Em pairs were proposed to predict DBP formation, suggesting a potential method to develop an online monitoring system for DBPs.