Lithium-ion batteries towards circular economy: A literature review of opportunities and issues of recycling treatments.

Nowadays, Lithium-ion batteries are widely used in advanced technological devices and Electric and Hybrid Vehicles, due to their high energy density for weight, reduced memory effect and significant number of supported charging/discharging cycles. As a consequence, the production and the use of Lithium-ion batteries will continuously increase in the near future, focusing the global attention on their End-of-Life management. Unfortunately, wasted Lithium-ion batteries treatments are still under development, far from the optimization of recycling processes and technologies, and currently recycling represents the only alternative for the social, economic and environmental sustainability of this market, able to minimize toxicity of End-of-Life products, to create a monetary gain and to lead to the independence from foreign resources or critical materials. This paper analyses the current alternatives for the recycling of Lithium-ion batteries, specifically focusing on available procedures for batteries securing and discharging, mechanical pre-treatments and materials recovery processes (i.e. pyro- and hydrometallurgical), and it highlights the pros and cons of treatments in terms of energy consumption, recovery efficiency and safety issues. Target metals (e.g. Cobalt, Nickel and Lithium) are listed and prioritized, and the economic advantage deriving by the material recovery is outlined. An in-depth literature review was conducted, analysing the existing industrial processes, to show the on-going technological solutions proposed by research projects and industrial developments, comparing best results and open issues and criticalities.

Characterization of Fine Metal Particles Derived from Shredded WEEE Using a Hyperspectral Image System: Preliminary Results.

Waste of electric and electronic equipment (WEEE) is the fastest-growing waste stream in Europe. The large amount of electric and electronic products introduced every year in the market makes WEEE disposal a relevant problem. On the other hand, the high abundance of key metals included in WEEE has increased the industrial interest in WEEE recycling. However, the high variability of materials used to produce electric and electronic equipment makes key metals' recovery a complex task: the separation process requires flexible systems, which are not currently implemented in recycling plants. In this context, hyperspectral sensors and imaging systems represent a suitable technology to improve WEEE recycling rates and the quality of the output products. This work introduces the preliminary tests using a hyperspectral system, integrated in an automatic WEEE recycling pilot plant, for the characterization of mixtures of fine particles derived from WEEE shredding. Several combinations of classification algorithms and techniques for signal enhancement of reflectance spectra were implemented and compared. The methodology introduced in this study has shown characterization accuracies greater than 95%.

UV-Assisted 3D Printing of Polymer Composites from Thermally and Mechanically Recycled Carbon Fibers.

Despite the growing global interest in 3D printed carbon fiber reinforced polymers, most of the applications are still limited to high-performance sectors due to the low effectiveness-cost ratio of virgin carbon fibers. However, the use of recycled carbon fibers in 3D printing is almost unexplored, especially for thermoset-based composites. This paper aims to demonstrate the feasibility of recycled carbon fibers 3D printing via UV-assisted direct ink writing. Pyrolyzed recycled carbon fibers with a sizing treatment were firstly shredded to be used as a reinforcement of a thermally and photo-curable acrylic resin. UV-differential scanning calorimetry analyses were then performed to define the material crosslinking of the 3D printable ink. Because of the poor UV reactivity of the resin loaded with carbon fibers, a rheology modifier was added to guarantee shape retention after 3D printing. Thanks to a customized 3D printer based on a commercial apparatus, a batch of specimens was successfully 3D printed. According to the tensile tests and Scanning Electron Microscopy analysis, the material shows good mechanical properties and the absence of layer marks related to the 3D printing. These results will, therefore, pave the way for the use of 3D printed recycled carbon fiber reinforced polymers in new fields of application.