Dental long axes using digital dental models compared to cone-beam computed tomography.

OBJECTIVE: Standard methods of evaluating tooth long axes are not comparable (digital dental models [DDMs], panoramic and cephalometric radiographs) or expose patients to more radiation (cone-beam computed tomography [CBCT]). This study aimed to compare angular changes in tooth long axes using DDMs vs using CBCTs. SETTINGS AND SAMPLE POPULATION: Secondary data analysis of DDMs and CBCTs, taken before and after orthodontic treatment with piezocision of 24 patients. METHODS: Angular changes in tooth long axes were evaluated using landmarks on first molars (centre of the occlusal surface and centre of the furcation), canines and incisors (cusp tip and centre of the root at the cementoenamel junction). Wilcoxon test, intraclass correlation coefficient (ICC) and Bland-Altman plots were used to test intra- and inter-rater agreement and compare DDM and CBCT measurements. RESULTS: The mesiodistal angulation and buccolingual inclination DDM measurements were reproducible. Overall mean differences between DDM and CBCT measurements of mesiodistal angulation, 1.9°±1.5°, and buccolingual inclination, 2.2 ± 2.2°, were not significant for all teeth. ICC between DDM and CBCT measurements ranged from good (0.85 molars) to excellent (0.94 canines; 0.96 incisors). The percentages of measurements outside the range of ±5 were 17.4% for molars, 13.8% for canines and 4.5% for incisors. CONCLUSIONS: DDM assessment of changes in tooth long axes has good reproducibility and yields comparable measurements to those obtained from CBCT within a 5° range. These findings lay the groundwork for machine learning approaches that synthesize crown and root canal information towards planning tooth movement without the need for ionizing radiation scans.

Presurgical orthodontic decompensation with clear aligners.

INTRODUCTION: Orthodontists, surgeons, and patients have taken an interest in using clear aligners in combination with orthognathic surgery. This study aimed to evaluate the accuracy of tooth movements with clear aligners during presurgical orthodontics using novel 3-dimensional superimposition techniques. METHODS: The study sample consisted of 20 patients who have completed presurgical orthodontics using Invisalign clear aligners. Initial (pretreatment) digital dental models, presurgical digital dental models, and ClinCheck prediction models were obtained. Presurgical models were superimposed onto initial ones using stable anatomic landmarks; ClinCheck models were superimposed onto presurgical models using surface best-fit superimposition. Five hundred forty-five teeth were measured for 3 angular movements (buccolingual torque, mesiodistal tip, and rotation) and 4 linear movements (buccolingual, mesiodistal, vertical, and total scalar displacement). The predicted tooth movement was compared with the achieved amount for each movement and tooth, using both percentage accuracy and numerical difference. RESULTS: Average percentage accuracy (63.4% ± 11.5%) was higher than in previously reported literature. The most accurate tooth movements were buccal torque and mesial displacement compared with lingual torque and distal displacement, particularly for mandibular posterior teeth. Clinically significant inaccuracies were found for the buccal displacement of maxillary second molars, lingual displacement of all molars, intrusion of mandibular second molars, the distal tip of molars, second premolars, and mandibular first premolars, buccal torque of maxillary central and lateral incisors, and lingual torque of premolars and molars. CONCLUSIONS: Superimposition techniques used in this study lay the groundwork for future studies to analyze advanced clear aligner patients. Invisalign is a treatment modality that can be considered for presurgical orthodontics-tooth movements involved in arch leveling and decompensation are highly accurate when comparing the simulated and the clinically achieved movements.