RESUMEN
It is currently not possible to directly measure the lateral pressure of a biomembrane. Mechanoresponsive fluorescent probes are an elegant solution to this problem but it requires first the establishment of a direct correlation between the membrane surface pressure and the induced color change of the probe. Here, we analyze planarizable dithienothiophene push-pull probes in a monolayer at the air/water interface using fluorescence microscopy, grazing-incidence angle X-ray diffraction, and infrared reflection-absorption spectroscopy. An increase of the lateral membrane pressure leads to a well-packed layer of the 'flipper' mechanophores and a clear change in hue above 18 mN/m. The fluorescent probes had no influence on the measured isotherm of the natural phospholipid DPPC suggesting that the flippers probe the lateral membrane pressure without physically changing it. This makes the flipper probes a truly useful addition to the membrane probe toolbox.
RESUMEN
In this report, "fluorescent flippers" are introduced to create planarizable push-pull probes with the mechanosensitivity and fluorescence lifetime needed for practical use in biology. Twisted push-pull scaffolds with large and bright dithienothiophenes and their S,S-dioxides as the first "fluorescent flippers" are shown to report on the lateral organization of lipid bilayers with quantum yields above 80% and lifetimes above 4 ns. Their planarization in liquid-ordered (Lo) and solid-ordered (So) membranes results in red shifts in excitation of up to +80 nm that can be transcribed into red shifts in emission of up to +140 nm by Förster resonance energy transfer (FRET). These unique properties are compatible with multidomain imaging in giant unilamellar vesicles (GUVs) and cells by confocal laser scanning or fluorescence lifetime imaging microscopy. Controls indicate that strong push-pull macrodipoles are important, operational probes do not relocate in response to lateral membrane reorganization, and two flippers are indeed needed to "really swim," i.e., achieve high mechanosensitivity.
Asunto(s)
Membrana Celular/química , Membrana Celular/metabolismo , Colorantes Fluorescentes/química , Fenómenos Mecánicos , Fenómenos Biomecánicos , Diseño de Fármacos , Liposomas Unilamelares/químicaRESUMEN
This article assembles pertinent insights behind the concept of planarizable push-pull probes. As a response to the planarization of their polarized ground state, a red shift of their excitation maximum is expected to report on either the disorder, the tension, or the potential of biomembranes. The combination of chromophore planarization and polarization contributes to various, usually more complex processes in nature. Examples include the color change of crabs or lobsters during cooking or the chemistry of vision, particularly color vision. The summary of lessons from nature is followed by an overview of mechanosensitive organic materials. Although often twisted and sometimes also polarized, their change of color under pressure usually originates from changes in their crystal packing. Intriguing exceptions include the planarization of several elegantly twisted phenylethynyl oligomers and polymers. Also mechanosensitive probes in plastics usually respond to stretching by disassembly. True ground-state planarization in response to molecular recognition is best exemplified with the binding of thoughtfully twisted cationic polythiophenes to single- and double-stranded oligonucleotides. Molecular rotors, en vogue as viscosity sensors in cells, operate by deplanarization of the first excited state. Pertinent recent examples are described, focusing on λ-ratiometry and intracellular targeting. Complementary to planarization of the ground state with twisted push-pull probes, molecular rotors report on environmental changes with quenching or shifts in emission rather than absorption. The labeling of mechanosensitive channels is discussed as a bioengineering approach to bypass the challenge to create molecular mechanosensitivity and use biological systems instead to sense membrane tension. With planarizable push-pull probes, this challenge is met not with twistome screening, but with "fluorescent flippers," a new concept to insert large and bright monomers into oligomeric probes to really feel the environment and also shine when twisted out of conjugation.
Asunto(s)
Membrana Celular/química , Colorantes Fluorescentes/química , Membrana Dobles de Lípidos/química , Polímeros/química , Tiofenos/química , Animales , Fenómenos Biomecánicos , Visión de Colores , Humanos , Fenómenos Mecánicos , Modelos Moleculares , Nephropidae/química , Nephropidae/fisiología , Oligonucleótidos/química , Pigmentación , Pigmentos Biológicos/análisis , Alimentos Marinos/análisis , ViscosidadRESUMEN
We report design, synthesis and evaluation of push-pull quaterthiophene amphiphiles containing one 3,4-ethylenedioxythiophene (EDOT) and a single strong twist in the scaffold. Planarizable push-pull oligothiophene amphiphiles have been introduced recently as conceptually innovative fluorescent probes that sense the fluidity and the potential of lipid bilayer membranes. The "hyper-twisted" EDOT probes respond to planarization and restricted rotational freedom with a red shift and changes in vibrational finestructure in the excitation spectrum, respectively. In solution, comparably weak solvatochromism and significant thermochromism are found. Planarization and restricted rotational freedom afford exquisite sensitivity toward nature and fluidity of lipid bilayer membranes, including ratiometric detection of phase transitions. The sensing of membrane potentials is weakened by these unique properties but remains possible.
Asunto(s)
Tiofenos/química , Tiofenos/síntesis química , Estructura MolecularRESUMEN
Oxidation mechanisms in air nonthermal plasma (NTP) at room temperature and atmospheric pressure were investigated in a corona reactor energized by +dc, -dc, or +pulsed high voltage.. The two bromomethanes CF(2)Br(2) and CH(2)Br(2) were chosen as model organic pollutants because of their very different reactivities with OH radicals. Thus, they served as useful mechanistic probes: they respond differently to the presence of humidity in the air and give different products. By FT-IR analysis of the postdischarge gas the following products were detected and quantified: CO(2) and CO in the case of CH(2)Br(2), CO(2) and F(2)C â O in the case of CF(2)Br(2). F(2)C â O is a long-lived oxidation intermediate due to its low reactivity with atmospheric radicals. It is however removed from the NTP processed gas by passage through a water scrubber resulting in hydrolysis to CO(2) and HF. Other noncarbon containing products of the discharge were also monitored by FT-IR analysis, including HNO(3) and N(2)O. Ozone, an important product of air NTP, was never detected in experiments with CF(2)Br(2) and CH(2)Br(2) because of the highly efficient ozone depleting cycles catalyzed by BrOx species formed from the bromomethanes. It is concluded that, regardless of the type of corona applied, CF(2)Br(2) reacts in air NTP via a common intermediate, the CF(2)Br radical. The possible reactions leading to this radical are discussed, including, for -dc activation, charge exchange with O(2)(-), a species detected by APCI mass spectrometry.
Asunto(s)
Contaminantes Atmosféricos/química , Clorofluorocarburos de Metano/química , Hidrocarburos Bromados/química , Aire , Dióxido de Carbono/química , Monóxido de Carbono/química , Óxido Nitroso/química , Oxidación-Reducción , Espectroscopía Infrarroja por Transformada de Fourier , Ácidos Sulfúricos/químicaRESUMEN
Monomers with large surface area and high quantum yield, that is fluorescent flippers, have been engineered into twisted push-pull oligomers to create membrane probes with high mechanosensitivity and long fluorescence lifetime. Here, the synthesis and characterization of thieno[3,4]pyrazines and 2,1,3-benzothiadiazoles are described in comparison with the original dithienothiophene S,S-dioxides. Dithienothiophene S,S-dioxide flippers are confirmed as the best reported so far, and poor results with single flipper probes support that two flippers are needed for the probe to really "swim", that is, for high mechanosensitivity.
RESUMEN
(13)C-isotope labelling is presented as a novel tool for the study of complex chemical systems. (13)C-isotope labelling permits the quantification of all 26 members of a dynamic library from a single (13)C NMR spectrum without the need for advanced instrumentation or sophisticated experimental protocols.