Improved analysis of folpet and captan in foods using liquid chromatography-triple quadrupole linear ion trap mass spectrometry: applying mass filtering, collision, and trapping conditions.

Accurate and highly sensitive analysis of folpet and captan was accomplished using liquid chromatography-triple quadrupole linear ion trap mass spectrometry (LC-QqQIT) with selective ion mode; mass filtering, collision, and trapping condition. Dimensional mass spectrometry (MS3) parameters were optimized for the residue detection of folpet and captan in six food commodities (apples, tomatoes, sweet pepper, wheat flour, sesame seeds, and fennel seeds). The sample preparation method was based on the known QuEChERS protocol, except a mixture of acetonitrile/acetone was used for the sample extraction from the sesame seeds. The robustness and reliability of the developed MS3 method were demonstrated by performing a full validation, according to SANTE/11312/2021, at 0.01-0.25 mg/kg. Recovery ranged from 83 to 118% with a relative standard deviation below 19% in all the tested commodities, and limits of quantifications (LOQs) were 0.01 mg/kg in apples and tomatoes; 0.03 mg/kg in sweet pepper; and 0.05 mg/kg in wheat flour, sesame seeds, and fennel seeds. Monitoring results showed that about 90% of apples contained captan residue, and in sweet pepper, concentrations of captan and folpet as high as 1.57 and 0.97 mg/kg were found, respectively. The novel developed MS3 method enabled more reliable identification of these commonly problematic fungicides at lower LOQs than previously reported methods.

Metal Ion Removal from Wastewaters by Sorption on Activated Carbon, Cement Kiln Dust, and Sawdust.

This study assessed the efficiency of activated carbon, cement kiln dust (CKD), and sawdust for the removal of cadmium (Cd), copper (Cu), lead (Pb), and zinc (Zn) from aqueous solutions under mono-metal and competitive sorption systems and the removal of Cd, Cu, and Zn from different industrial wastewaters. Batch equilibrium experiments were conducted in a mono-metal and competitive sorption system. The efficiency of the sorbents in the removal of Cd, Cu, and Zn from industrial wastewaters was also investigated. Cement kiln dust expressed the highest affinity for the metals followed by activated carbon and sawdust. Competition among the metals changed their distribution coefficient (Kd) with the sorbents. Sorption of Pb and Cu was higher than Cd and Zn. The average metal removal from the wastewaters varied from 74, 61, and 60% for Cd, Cu, and Zn, respectively, to nearly 100%. The efficiencies of CKD and activated carbon in removing metals were higher than sawdust, suggesting their potential as low-cost sorbents for the removal of toxic metals from wastewaters.

Heavy metals removal from aqueous solutions and wastewaters by using various byproducts.

Water contamination with heavy metals (HM) represents a potential threat to humans, animals and plants, and thus removal of these metals from contaminated waters has received increasing attention. The present study aimed to assess the efficiency of some low cost sorbents i.e., chitosan (CH), egg shell (ES), humate potassium (HK), and sugar beet factory lime (SBFL) for removal of cadmium (Cd), copper (Cu), lead (Pb) and zinc (Zn) from wastewaters. For this purpose batch equilibrium experiments were conducted with aqueous solutions containing various concentrations of the metals and sorbents in a mono-metal and competitive sorption system. Sorption isotherms were developed, and sorption parameters were determined. The potential applicability of the tested sorbents in the removal of Cd, Cu, and Zn from contaminated wastewaters was also investigated by equilibrating different sorbents and water ratios. Chitosan expressed the highest affinity for the metals followed by SBFL, ES, and HK. Nearly 100% of the metals were removed from aqueous solutions with the lowest initial metal concentrations by the sorbents especially CH and SBFL. However, the sorption efficiency decreased as the initial metal concentrations increased. Competition among the four metals changed significantly their distribution coefficient (Kd) values with the sorbents. The selectivity sequence of the metals was: Pb > Cu > Zn > Cd. The metal removal from the wastewaters varied from 72, 69, and 60 to nearly 100% for Cd, Cu and Zn, respectively. The efficiency of the studied byproducts in removing metals from the wastewaters differed based on the source of contamination and metal concentrations. Cadmium removal percentages by HK and CH were higher than SBFL and ES. The HK and CH exhibited the highest removal percentage of Cu from water with high concentrations. The SBFL and ES revealed the highest removal percentage of Zn from water with high concentrations. The results, demonstrate a high potential of CH, SBFL, HK, and ES for the remediation of HM contaminated wastewaters.

Size-exclusion chromatography selective cleanup of aflatoxins in oilseeds followed by HPLC determination to assess the potential health risk.

Aflatoxins (AFs) are one of the most harmful carcinogenic natural toxins that affect food. Crops containing reasonably high oil content may be affected by Aspergillus species and consequently by AF contamination. In this study, a proposed testing method for AF detection in oilseed was developed, validated, and used for a market survey to assess the probabilistic risk exposure caused by consuming contaminated oilseeds including corn, sunflower seed, and soybean. The test method was optimized for selective extraction and then validated for fitness of purpose; the limits of quantification (LOQs) were 0.2, 0.4, 0.2, and 0.2 µg kg-1 for aflatoxin G1 (AFG1), aflatoxin B1 (AFB1), aflatoxin G2 (AFG2), and aflatoxin B2 (AFB2), respectively. The method was linear from the LOQs up to 20 µg kg-1, and its budget of measurement uncertainties were estimated at 25, 24, 26, and 30 for AFG1, AFB1, AFG2, and AFB2, respectively. The contamination levels were from  10,000 body weight (BW) day-1, respectively. The main finding of the present study highlights the possibility of some risk of AF exposure from corn consumption, which may represent a health concern.

Histopathology and cytotoxicity as biomarkers in treated rats with cadmium and some therapeutic agents.

The present study aimed to investigate the protective role of ascorbic acid (vitamin C) and zinc (Zn) against cadmium (Cd) induced histopathological changes in tissues of liver, kidney, lung and testis of rats as well as chromosomal aberrations. For this purpose, 60 male albino rats were divided into six groups; each group contained 10 animals. The first group served as control and was given only distilled water. The second and third groups received distilled water supplemented with 2 g ascorbic acid/l and 500 mg Zn/l, respectively. The fourth group received a daily oral dose containing 3 mg Cd/kg b.w. (1/30 LD50). The fifth group received Cd + ascorbic acid (3 mg Cd/kg b.w. + 2 g ascorbic acid/l), while the sixth group received Cd + Zn (3 mg Cd/kg b.w. +500 mg Zn/l). The treatment in all groups lasted for 90 consecutive days. Rats exposed to cadmium showed severe histopathological changes in the liver, kidney, lung and testicular tissues as well as chromosomal aberrations such as: break, ring, centromeric separation and polyploidy. Co-treatment with zinc partially improved the histopathological changes and chromosomal aberrations while co-treatment with vitamin C exhibited a more protective role and markedly reduced tissues damage induced by Cd.