RESUMEN
We demonstrate a 417â W, 175â kHz Innoslab chirped pulse amplification laser compressible to short and clean 406â fs pulse duration. A spectral bandwidth (full width at half maximum, FWHM) of â¼3â nm was maintained at full pump power, and the pulses exhibited good pulse quality in a wide tunable pulse energy range from 1.7â mJ to a maximum of 2.38â mJ. At the maximum output power, the compressed pulses were nearly pedestal free. The comprehensive effects of residual high-order dispersion from the front end, the gain shaping effects of the amplifier, and the slight mismatch of third-order dispersion (TOD) between the stretcher (CFBG) and the gating compressor, along with the small nonlinear phase shift accumulated in the amplifier, could have facilitated the high pulse quality. To the best of our knowledge, this is the shortest pulse duration from the Innoslab amplifiers at hundreds of watts average power in the millijoule energy regime.
RESUMEN
A high-power regenerative amplifier (RA) based on dual-slab Yb:KGd(WO4)2 (Yb:KGW) was demonstrated, which provided a maximum average power of 33.7â W at a repetition rate of 75-200â kHz before compression with a central wavelength of 1039â nm, corresponding to an optical-to-optical conversion efficiency of 51.4%. To the best of our knowledge, this is the highest average power from the Yb:KGW solid-state RA. The compressed pulse duration of 205â fs was realized under the maximum output power. By adjusting the gain of the crystals, respectively, the spectral shaping can be achieved. A combination spectrum with root-mean-square (RMS) bandwidth of 4.5â nm was generated with a central wavelength of 1035â nm at an output power of 20â W, the compressed pulse duration was 159â fs. Meanwhile, effective mitigation of thermal effects by dual-slab configuration guaranteed the nearly diffraction-limited beam quality: M x2 = 1.17 and M y2 = 1.20.
RESUMEN
In this Letter, we experimentally investigate a new kind of nanosecond pre-pulse, which originates from the bidirectional scattering of crystals in traditional Ti:sapphire multi-pass amplifiers. The experimental results demonstrate that the intensity of scattering-induced pre-pulses is very sensitive to the scattering angle, and the delay time between the pre-pulse and the main pulse is an integer multiple of the light path in each pass of the amplifier. An optimized multi-pass amplifier configuration is proposed, for what is believed to be the first time, to suppress the scattering-induced pre-pulses. The contrast ratio between pre-pulses and the main pulse is enhanced by more than two orders of magnitude, reaching a level of 10-10. This novel multi-pass amplifier configuration is very simple and economical, and provides an effective solution for the temporal contrast enhancement in the nanosecond range.
RESUMEN
Double deformable mirrors (DMs) with different actuator densities are cascaded to optimize the wavefront aberrations to improve the focus intensity of the Shanghai super-intense ultrafast laser facility (SULF), which plans to generate 10 PW laser pulse. The beam aberrations near the focal spot are corrected from 0.556 um to 0.112 um in RMS by a 300-mm DM with a large stroke installed after the compressor. After then, it is further optimized to 0.041 um using a 130-mm DM with a high spatial resolution working after the main amplifier. The corrected beam is focused to 2.75 × 2.87 um2 at the full width at half maximum (FWHM) with an f/2.5 off-axis parabolic mirror (OAP), which contains approximately 27.69% energy. A peak intensity of 2 × 1022 W/cm2 is achieved at the output of 5.4 PW, and it could exceed 1023 W/cm2 in the SULF 10 PW laser facility using an f/1.8 OAP.
RESUMEN
We report on the laser pulse output of 339 J centered at 800 nm from a chirped-pulse amplification (CPA) Ti:sapphire laser system at the Shanghai Superintense Ultrafast Laser Facility. The experimental results demonstrated that the parasitic lasing as well as the transverse amplified spontaneous emission of the homemade 235-mm-diameter Ti:sapphire final amplifier were suppressed successfully via the temporal dual-pulse pumped scheme and the index-matching liquid cladding technique. The maximum pump-to-signal conversion efficiency of 32.1% was measured for the final amplifier. With a compressor transmission efficiency of 64% and a compressed pulse duration of 21 fs obtained for the sample light at a lower energy level, this laser system could potentially generate a compressed laser pulse with a peak power of 10.3 PW. The experimental results represent significant progress with respect to the CPA laser.
RESUMEN
A grism pair is utilized to control the high-order dispersion of the Shanghai Superintense Ultrafast Lasers Facility, which is a large-scale project aimed at delivering 10-PW laser pulses. We briefly present the characteristics of the laser system and calculate the cumulative B-integral, which determines the nonlinear phase shift influence on material dispersion. Three parameters are selected, grism separation, angle of incidence and slant distance of grating compressor, to determine their optimal values through an iterative searching procedure. Both the numerical and experimental results confirm that the spectral phase distortion is controlled, and the recompressed pulse with a duration of 24 fs is obtained in the single-shot mode. The distributions and stabilities of the pulse duration at different positions of the recompressed beam are also investigated. This approach offers a new feasible solution for the high-order dispersion compensation of femtosecond petawatt laser systems.
RESUMEN
We report on an experimental and theoretical study of a large-aperture Ti:Sapphire (Ti:S) amplifier pumped with a novel temporal dual-pulse scheme to suppress the parasitic lasing (PL) and transverse amplified spontaneous emission (TASE) for high-energy chirped-pulse amplification (CPA). The pump energy distribution was optimized and the time delay between each pump pulse was controlled precisely. Both the numerical and experimental results confirm that the temporal dual-pulse pump technique can effectively suppress PL and TASE. The maximum output energy of 202.8 J was obtained from the final 150-mm-diameter Ti:S booster amplifier with a pump energy of 320.0 J, corresponding to a conversion efficiency of 49.3%. The compressed pulse duration of 24.0 fs was measured with a throughput efficiency of 64%, leading to a peak power of 5.4 PW. This novel temporal dual-pulse pump technique has potential applications in a 10 PW CPA laser system.
RESUMEN
We report on the generation of 192.3 J centered at 800 nm wavelength from a chirped-pulse amplification (CPA) Ti:sapphire laser system. The experimental results demonstrate that parasitic lasing can be suppressed successfully in the final amplifier based on a Ti:sapphire crystal of 150 mm in diameter. An over 50% pump-to-signal conversion efficiency was measured for the final amplifier by optimizing the time delay of two pump pulses and enhancing the injected seed energy. With 72% compressor throughput efficiency and 27 fs long compressed pulse duration obtained at a lower energy level, this laser could potentially support a compressed laser pulse of 5.13 PW peak power. The experimental results represent notable progress regarding the CPA laser.
RESUMEN
In this Letter, we present a study of high-energy and high-conversion-efficiency broadband optical parametric chirped-pulse amplification (OPCPA) system with a 100 mm×100 mm×17 mm LBO crystal near 800 nm. The results showed that the back-conversion was sensitively affected by the pump intensity and the injected signal intensity. It occurred when the injected signal was above 0.82 J with a pump energy of 170 J, and this effect also reshaped the amplified spectrum. After optimization, an amplified energy of 45.3 J was achieved with a conversion efficiency of 26.3% by the OPCPA. The peak power of the hybrid CPA-OPCPA laser system reached 1.02 PW with a compressed duration of 32 fs, which is the first reported OPCPA peak power higher than 1 PW, to the best of our knowledge.
RESUMEN
Based on the polarized-dependent absorption characteristic of Ti:S crystals, we propose a method to reduce the absorption coefficient of Ti:S by using a σ-polarized pump. For Ti:S crystals, the absorption cross section of σ-polarized pump light is approximately half that of π-polarized pump light, which reduces the excited state density near the surface of the amplifier crystal, resulting in reduced transverse parasitic lasing and amplified spontaneous emission. The experimental results based on a diameter of 80 mm Ti:S confirmed the proposed method with different index-matched cladding materials [ethanol and bromonaphthalene (BN)]. In the case of an ethanol cladding, the maximum amplified output energies for π- and σ-polarized pumping are 20.8 J and 26.8 J, respectively-corresponding to 28.8% energy improvement achieved by the σ-polarized pump. In the case of a BN cladding, the maximum amplified output energies achieved by π- and σ-polarized pumping are 40 J and 44 J, respectively; this result corresponds to about 10% energy improvement achieved by the σ-polarized pump. This method can be used in larger size Ti:S amplifiers.