RESUMEN
Tokamak operational regimes with small edge localized modes (ELMs) could be a solution to the problem of large transient heat loads in fusion reactors. A ballooning mode near the last closed flux surface governed by the pressure gradient and the magnetic shear there has been proposed for small ELMs. In this Letter, we experimentally investigate several stabilizing effects near the last closed flux surface and present linear ideal simulations that indeed develop ballooninglike fluctuations there and connect them with nonlinear resistive simulations. The dimensionless parameters of the small ELM regime in the region of interest are very similar to those in a reactor, making this regime the ideal exhaust scenario for a future device.
RESUMEN
The Thermal Helium Beam (THB) is a diagnostic for simultaneously measuring the electron temperature and density profiles of the plasma edge and scrape off layer (SOL). It exploits the line ratio technique of selected He line intensities, emitted by He gas puffed inside the plasma, to locally estimate the plasma properties through a dedicated collisional radiative model (CRM). Standard THB diagnostics used in nuclear fusion devices measure three HeI emission lines: 667.8, 706.5, and 728.1 nm. For the RFP experiment RFX-mod2, a new THB is designed and tested for the first time at the TCV tokamak. It acquires an additional emission line at 501.6 nm, which is exploited to estimate the radiation re-absorption, which is not negligible in regions of large neutral He densities (leading to high re-absorption) and simultaneously low electron density and temperature (lack of other excitation channels). It affects the measurements most strongly at the far SOL, while the significance of re-absorption decreases as it approaches the separatrix. In this paper, plasma density and temperature profiles of the plasma edge at the outboard midplane of TCV, measured with this newly designed THB, are presented. For the first time, the effect of radiation re-absorption on the estimation of electron temperature and density profiles is experimentally measured in a tokamak using the 501 nm line emission intensity. Different CRMs are compared with and without radiation re-absorption, showing good agreement when re-absorption is included and demonstrating how it plays an important role in the far SOL, as expected.
RESUMEN
We introduce a new correlation analysis technique for thermal helium beam (THB) diagnostics. Instead of directly evaluating line ratios from fluctuating time series, we apply arithmetic operations to all available He I lines and construct time series with desired dependencies on the plasma parameters. By cross-correlating those quantities and by evaluating ensemble averages, uncorrelated noise contributions can be removed. Through the synthetic data analysis, we demonstrate that the proposed analysis technique is capable of providing the power spectral densities of meaningful plasma parameters, such as the electron density and the electron temperature, even under low-photon-count conditions. In addition, we have applied this analysis technique to the experimental THB data obtained at the ASDEX Upgrade tokamak and successfully resolved the electron density and temperature fluctuations up to 90 kHz in a reactor relevant high power scenario.
RESUMEN
A multichannel spectroscopic diagnostic based on the Stark effect on helium lines was developed and implemented in IShTAR (Ion Cyclotron Sheath Test ARrangement) to measure the spatial distribution of electric fields across the radio frequency sheaths of the ion cyclotron antenna. Direct measurements of the DC electric fields in the antenna sheaths are an important missing component in understanding the antenna-plasma edge interactions in magnetically confined fusion plasmas since they will be used to benchmark theoretical models against real antenna operation. Along with the high-resolution Czerny-Turner monochromator and a detector with an intensifier, the hardware relies on the 2 chained set of linear-to-linear fiber bundles that provide seven optical channels capable of resolving an 8.4 mm region in the vicinity of the antenna's box. The diagnostic is supported with local helium gas puff, enabling it to operate in nonhelium plasmas. Spatially resolved electric field was measured for two discharge configurations, one with and one without the ICRF antenna. The results show a clear difference in the shape of the DC electric field's spatial profile for the two cases studied, with the elevated values when the ICRF antenna was operating. This demonstrates the ability of the diagnostic to measure even small relative changes in the intensity of the electric field.
RESUMEN
The thermal helium beam edge diagnostic has recently been upgraded at the ASDEX Upgrade (AUG) tokamak experiment. Line ratio spectroscopy on neutral helium is a valuable tool for simultaneous determination of the electron temperature and density of plasmas. The diagnostic now offers a temporal resolution of 900 kHz with a spatial resolution of up to 3 mm at 32 lines of sight (LOS) simultaneously. The LOS covers a radial region of 8.5 cm, starting at the limiter radius and reaching into the confined region beyond the separatrix. Two components are of particular importance for the aforementioned hardware improvements. The first is the optical head, which collects the light from the experiment. Equipped with an innovative clamping system for optical fiber ends, an arbitrary distribution pattern of LOS can be achieved to gain radial and poloidal profiles. The second major development is a new polychromator system that measures the intensity of the 587 nm, 667 nm, 706 nm, and 728 nm helium lines simultaneously for 32 channels with filter-photomultiplier tube arrays. Thus, the thermal helium beam diagnostic supplements the AUG edge diagnostics, offering fast and spatially highly resolved electron temperature and density profile measurements that cover the plasma edge and scrape-off layer region. Plasma fluctuations, edge localized modes, filaments, and other turbulent structures are resolved, allowing analysis of their frequency and localization or their propagation velocity.
RESUMEN
A new high speed gas valve was developed for disruption mitigation studies in the tokamak ASDEX Upgrade. The valve was designed to operate inside the vacuum vessel to reduce the time of flight of the injected gas and to prevent dispersion of the gas cloud before the gas reaches the plasma. A spring-driven mechanism was chosen for the valve as it is robust against the high magnetic fields and electromagnetic disturbances inside the vessel. The internal gas reservoir (128 cm3) of the valve, which holds the mitigation gas, is opened within 1.5 ms, and the maximal stroke between the valve plate and nozzle (diameter 13 mm) is 4.5 mm. This allows a peak flow rate of 72 kPam3/s after 1 ms which was determined both analytically and numerically. The highest gas velocity (approximately 560 m/s) is reached 0.6 ms after the valve is opened. The gas cloud expands in a pear shape with an opening angle of 49°.
RESUMEN
In magnetically confined fusion plasmas controlled gas injection is crucial for plasma fuelling as well as for various diagnostic applications such as active spectroscopy. We present a new, versatile system for the injection of collimated thermal gas beams into a vacuum chamber. This system consists of a gas pressure chamber, sealed by a custom made piezo valve towards a small capillary for gas injection. The setup can directly be placed inside of the vacuum chamber of fusion devices as it is small and immune against high magnetic fields. This enables gas injection close to the plasma periphery with high duty cycles and fast switch on/off times â² 0.5 ms. In this work, we present the design details of this new injection system and a systematic characterization of the beam properties as well as the gas flowrates which can be accomplished. The thin and relatively short capillary yields a small divergence of the injected beam with a half opening angle of 20°. The gas box is designed for pre-fill pressures of 10 mbar up to 100 bars and makes a flowrate accessible from 1018 part/s up to 1023 part/s. It hence is a versatile system for both diagnostic as well as fuelling applications. The implementation of this system in ASDEX Upgrade will be described and its application for line ratio spectroscopy on helium will be demonstrated on a selected example.