Environmental risk assessment of metformin and its transformation product guanylurea: II. Occurrence in surface waters of Europe and the United States and derivation of predicted no-effect concentrations.

Metformin (MET), CAS 1115-70-4 (Metformin hydrochloride), is an antidiabetic drug with high usage in North America and Europe and has become the subject of regulatory interest. A pharmaceutical industry working group investigated environmental risks of MET. Environmental fate and chronic effects data were collated across the industry for the present risk assessment. Predicted environmental concentrations (PECs) for MET were modeled for the USA and Europe using the PhATE and GREAT-ER models, respectively. PECs were compared with measured environmental concentrations (MECs) for the USA and Europe. A predicted no effect concentration (PNEC) of 1 mg/L for MET was derived by deterministic procedures, applying an assessment factor of 10 to the lowest no observed effect concentration (i.e., 10 mg/L) from multiple chronic studies with algae, daphnids and fish. The PEC/PNEC and MEC/PNEC risk characterization ratios were <1, indicating no significant risk for MET with high Margins of Safety (MOS) of >868. MET is known to degrade during wastewater treatment to guanylurea (GUU, CAS 141-83-3), which we have shown to further degrade. There are no GUU toxicity data in the literature; hence, chronic studies for GUU were conducted to derive a PNEC of 0.16 mg/L. PECs were derived for GUU as for MET, plus MECs were retrieved from the literature. The PEC/PNEC and MEC/PNEC risk characterization ratios for GUU were also <1, with an MOS of >6.5. Based on standard risk assessment procedures for both MET and its transformation product GUU, there is no significant risk to aquatic life.

Environmental risk assessment of metformin and its transformation product guanylurea. I. Environmental fate.

Metformin (MET) is a pharmaceutical with very high use worldwide that is excreted in unchanged form, leading to concern about potential aquatic life impacts associated with MET, and its primary transformation product guanylurea (GUU). This study presents, in two companion papers, a risk assessment following internationally accepted guidelines of MET and GUU in surface water based on literature data, previously unpublished studies, and a new degradation test that resolves conflicting earlier results. Previous studies have shown that MET is removed during sewage treatment, primarily through transformation to GUU. In addition, measurements in WWTPs suggest that MET is not only transformed to GUU, but that GUU is further biodegraded. A prolonged inherent biodegradation test strongly suggests not only primary transformation of MET to GUU, but also subsequent full mineralization of GUU, with both degradation phases starting after a clear lag phase. MET may partition from surface water to sediment, where both transformation to GUU and in part mineralization is possible, depending on the presence of competent degrading microorganisms. In addition, MET may form non-extractable residues in sediments (12.8-73.5%). Both MET and GUU may be anaerobically degraded during sludge digestion, in soils or in sediments. Bioconcentration factor (BCF) values in crops and most plants are close to 1 suggesting low bioaccumulation potential, moreover, at least some plants can metabolize MET to GUU; however, in aquatic plants higher BCFs were found, up to 53. Similarly, neither MET nor GUU are expected to bioaccumulate in fish based on estimated values of BCFs ≤3.16.

A risk-based approach to managing active pharmaceutical ingredients in manufacturing effluent.

The present study describes guidance intended to assist pharmaceutical manufacturers in assessing, mitigating, and managing the potential environmental impacts of active pharmaceutical ingredients (APIs) in wastewater from manufacturing operations, including those from external suppliers. The tools are not a substitute for compliance with local regulatory requirements but rather are intended to help manufacturers achieve the general standard of "no discharge of APIs in toxic amounts." The approaches detailed in the present study identify practices for assessing potential environmental risks from APIs in manufacturing effluent and outline measures that can be used to reduce the risk, including selective application of available treatment technologies. These measures either are commonly employed within the industry or have been implemented to a more limited extent based on local circumstances. Much of the material is based on company experience and case studies discussed at an industry workshop held on this topic.