Chemical and Reactive Transport Processes Associated with Hydraulic Fracturing of Unconventional Oil/Gas Shales.

Hydraulic fracturing of unconventional oil/gas shales has changed the energy landscape of the U.S. Recovery of hydrocarbons from tight, hydraulically fractured shales is a highly inefficient process, with estimated recoveries of <25% for natural gas and <5% for oil. This review focuses on the complex chemical interactions of additives in hydraulic fracturing fluid (HFF) with minerals and organic matter in oil/gas shales. These interactions are intended to increase hydrocarbon recovery by increasing porosities and permeabilities of tight shales. However, fluid-shale interactions result in the dissolution of shale minerals and the release and transport of chemical components. They also result in mineral precipitation in the shale matrix, which can reduce permeability, porosity, and hydrocarbon recovery. Competition between mineral dissolution and mineral precipitation processes influences the amounts of oil and gas recovered. We review the temporal/spatial origins and distribution of unconventional oil/gas shales from mudstones and shales, followed by discussion of their global and U.S. distributions and compositional differences from different U.S. sedimentary basins. We discuss the major types of chemical additives in HFF with their intended purposes, including drilling muds. Fracture distribution, porosity, permeability, and the identity and molecular-level speciation of minerals and organic matter in oil/gas shales throughout the hydraulic fracturing process are discussed. Also discussed are analysis methods used in characterizing oil/gas shales before and after hydraulic fracturing, including permeametry and porosimetry measurements, X-ray diffraction/Rietveld refinement, X-ray computed tomography, scanning/transmission electron microscopy, and laboratory- and synchrotron-based imaging/spectroscopic methods. Reactive transport and spatial scaling are discussed in some detail in order to relate fundamental molecular-scale processes to fluid transport. Our review concludes with a discussion of potential environmental impacts of hydraulic fracturing and important knowledge gaps that must be bridged to achieve improved mechanistic understanding of fluid transport in oil/gas shales.

Manganese Oxidation States in Volcanic Soils across Annual Rainfall Gradients.

Manganese (Mn) exists as Mn(II), Mn(III), or Mn(IV) in soils, and the Mn oxidation state controls the roles of Mn in numerous environmental processes. However, the variations of Mn oxidation states with climate remain unknown. We determined the Mn oxidation states in highly weathered bulk volcanic soils (primary minerals free) across two rainfall gradients covering mean annual precipitation (MAP) of 0.25-5 m in the Hawaiian Islands. With increasing MAP, the soil redox conditions generally shifted from oxic to suboxic and to anoxic despite fluctuating at each site; concurrently, the proportions of Mn(IV) and Mn(II) decreased and increased, respectively. Mn(III) was low at both low and high MAP, but accumulated substantially, up to 80% of total Mn, in soils with prevalent suboxic conditions at intermediate MAP. Mn(III) was likely hosted in Mn(III,IV) and iron(III) oxides or complexed with organic matter, and its distribution among these hosts varied with soil redox potentials and soil pH. Soil redox conditions and rainfall-driven leaching jointly controlled exchangeable Mn(II) in soils, with its concentration peaking at intermediate MAP. The Mn redox chemistry was at disequilibrium, with the oxidation states correlating with long-term average soil redox potentials better than with soil pH. The soil redox conditions likely fluctuated between oxic and anoxic conditions more frequently at intermediate than at low and high MAP, creating biogeochemical hot spots where Mn, Fe, and other redox-sensitive elements may be actively cycled.

Tunable Manipulation of Mineral Carbonation Kinetics in Nanoscale Water Films via Citrate Additives.

We explored the influence of a model organic ligand on mineral carbonation in nanoscale interfacial water films by conducting five time-resolved in situ X-ray diffraction (XRD) experiments at 50 °C. Forsterite was exposed to water-saturated supercritical carbon dioxide (90 bar) that had been equilibrated with 0-0.5 m citrate (C6H5O7-3) solutions. The experimental results demonstrated that greater concentrations of citrate in the nanoscale interfacial water film promoted the precipitation of magnesite (MgCO3) relative to nesquehonite (MgCO3·3H2O). At the highest concentrations tested, magnesite nucleation and growth were inhibited, lowering the carbonation rate constant from 9.1 × 10-6 to 3.6 × 10-6 s-1. These impacts of citrate were due to partial dehydration of Mg2+(aq) and the adsorption of citrate onto nuclei and magnesite surfaces. This type of information may be used to predict and tailor subsurface mineralization rates and pathways.

Impacts of organic ligands on forsterite reactivity in supercritical CO2 fluids.

Subsurface injection of CO2 for enhanced hydrocarbon recovery, hydraulic fracturing of unconventional reservoirs, and geologic carbon sequestration produces a complex geochemical setting in which CO2-dominated fluids containing dissolved water and organic compounds interact with rocks and minerals. The details of these reactions are relatively unknown and benefit from additional experimentally derived data. In this study, we utilized an in situ X-ray diffraction technique to examine the carbonation reactions of forsterite (Mg2SiO4) during exposure to supercritical CO2 (scCO2) that had been equilibrated with aqueous solutions of acetate, oxalate, malonate, or citrate at 50 °C and 90 bar. The organics affected the relative abundances of the crystalline reaction products, nesquehonite (MgCO3 · 3H2O) and magnesite (MgCO3), likely due to enhanced dehydration of the Mg(2+) cations by the organic ligands. These results also indicate that the scCO2 solvated and transported the organic ligands to the forsterite surface. This phenomenon has profound implications for mineral transformations and mass transfer in the upper crust.

Nanoscale Interfacial Smoothing and Dissolution during Unconventional Reservoir Stimulation: Implications for Hydrocarbon Mobilization and Transport.

Hydraulic fracturing of low-permeability rocks significantly enhances hydrocarbon production from unconventional reservoirs. However, fluid transport through low-permeability rocks and the influence of geochemical transformations on pore networks are poorly constrained. Mineral reactivity during interactions with injected water may alter the physical nature of the rock, which may affect hydrocarbon mobility. To assess alterations to the rock, we have previously conducted a hydrothermal experiment that reacted cubed rock samples (1 cm3) with synthetic hydraulic fracturing fluid (HFF) to simulate physicochemical reactivity during hydraulic fracturing. Here, we analyze unreacted and reacted rocks by small-angle neutron scattering and high-pressure mercury intrusion to determine how the pore networks of unconventional reservoir rocks are influenced by the reaction with hydraulic fracturing injectates. Our results suggest that fluid-rock interactions exhibit a two-fold influence on hydrocarbon recovery, promoting both hydrocarbon mobilization and transport. Pore-matrix interfaces smooth via the removal of clay mineral surface asperities, reducing the available surface area for hydrocarbon adsorption by 12-75%. Additionally, HFF-induced dissolution creates new pores with diameters ranging from 800-1400 nm, increasing the permeability of the rocks by a factor of 5-10. These two consequences of mineral dissolution likely act in concert to release hydrocarbons from the host rock and facilitate transport through the rock during unconventional reservoir production.

Anomalously low activation energy of nanoconfined MgCO3 precipitation.

Magnesite (MgCO3) precipitation within the nanoconfined space of adsorbed H2O films (∼5 monolayers) was determined to have an apparent activation energy of only 36 ± 6 kJ mol-1, suggesting that Mg2+ under nanoconfinement adopts a hydration configuration that mimics that of aqueous Ca2+, at least energetically, if not also specifically in hydration structure.

Development of a hybrid process and system model for the assessment of wellbore leakage at a geologic CO2 sequestration site.

Sequestration of CO2 in geologic reservoirs is one of the promising technologies currently being explored to mitigate anthropogenic CO2 emissions. Large-scale deployment of geologic sequestration will require seals with a cumulative area amounting to hundreds of square kilometers per year and will require a large number of sequestration sites. We are developing a system-level model, CO2-PENS, that will predict the overall performance of sequestration systems while taking into account various processes associated with different parts of a sequestration operation, from the power plant to sequestration reservoirs to the accessible environment. The adaptability of CO2-PENS promotes application to a wide variety of sites, and its level of complexity can be increased as detailed site information becomes available. The model CO2-PENS utilizes a science-based-prediction approach by integrating information from process-level laboratory experiments, field experiments/observations, and process-level numerical modeling. The use of coupled process models in the system model of CO2-PENS provides insights into the emergent behavior of aggregate processes that could not be obtained by using individual process models. We illustrate the utility of the concept by incorporating geologic and wellbore data into a synthetic, depleted oil reservoir. In this sequestration scenario, we assess the fate of CO2 via wellbore release and resulting impacts of CO2 to a shallow aquifer and release to the atmosphere.

Beryllium in the environment: a review.

Beryllium is an important industrial metal because of its unusual material properties: it is lighter than aluminum and six times stronger than steel. Often alloyed with other metals such as copper, beryllium is a key component of materials used in the aerospace and electronics industries. Beryllium has a small neutron cross-section, which makes it useful in the production of nuclear weapons and in sealed neutron sources. Unfortunately, beryllium is one of the most toxic elements in the periodic table. It is responsible for the often-fatal lung disease, Chronic Beryllium Disease (CBD) or berylliosis, and is listed as a Class A EPA carcinogen. Coal-fired power plants, industrial manufacturing and nuclear weapons production and disposal operations have released beryllium to the environment. This contamination has the potential to expose workers and the public to beryllium. Despite the increasing use of beryllium in industry, there is surprisingly little published information about beryllium fate and transport in the environment. This information is crucial for the development of strategies that limit worker and public exposure. This review summarizes the current understanding of beryllium health hazards, current regulatory mandates, environmental chemistry, geochemistry and environmental contamination.