RESUMEN
There is increasing concern over the presence of per- and polyfluoroalkyl substances (PFAS) in biosolids, while sales in commercially available biosolid-based products used as soil amendments are also increasing. Here, the occurrence of 17 perfluoroalkyl acids (PFAAs) present in 13 commercially available biosolid-based products, six organic composts (manure, mushroom, peat, and untreated wood), and one food and yard waste compost were studied. The PFAA concentration ranges observed are as follows: biosolid-based products (9.0-199 µg/kg) > food and yard waste (18.5 µg/kg) > other organic products (0.1-1.1 µg/kg). Analysis of 2014, 2016, and 2018 bags produced from one product line showed a temporal decrease in the total PFAAs (181, 101, and 74 µg/kg, respectively). The total oxidizable precursor (TOP) assay revealed the presence of PFAA precursors in the biosolid-based products at much higher levels, when the soluble carbon was removed by the ENVI-Carb clean-up prior to the TOP assay. Time-of-flight mass spectrometry confirmed the presence of three sulfonamides, two fluorotelomer sulfonates, and several polyfluoroalkyl phosphate diesters. Pore-water concentrations of water-saturated products were primarily of short-chain PFAAs and increased with increasing PFAA concentrations in the products. A strong positive log-linear correlation between organic carbon (OC)-normalized PFAA partition coefficients and the number of CFn units indicates that OC is a good predictor of PFAA release concentrations.
Asunto(s)
Fluorocarburos , Contaminantes Químicos del Agua , Biosólidos , Monitoreo del Ambiente , Fluorocarburos/análisis , Suelo , Agua , Contaminantes Químicos del Agua/análisisRESUMEN
Per- and polyfluoroalkyl substances (PFAS) have been used in a variety of consumer and industrial products and are known to accumulate in sewage sludge due to sorption and their recalcitrant nature. Treatment processes ensure safe and high-quality biosolids by reducing the potential for adverse environmental impacts such as pathogen levels; however, they have yet to be evaluated for their impact on the fate of PFAS. The objective of this study was to compare PFAS concentrations in four commercially available biosolid-based products that received different types of treatments: heat treatment, composting, blending, and thermal hydrolysis. Seventeen perfluoroalkyl acids (PFAAs) were quantified using liquid chromatography with tandem quadrupole time-of-flight mass spectrometry followed by screening for 30 PFAA precursors. Treatment processes did not reduce PFAA loads except for blending, which served only to dilute concentrations. Several PFAA precursors were identified with 6:2 and 8:2 fluorotelomer phosphate diesters in all samples pre- and post-treatment. PRACTITIONER POINTS: Heat treatment and composting increased perfluoroalkyl acid (PFAA) concentrations. Only dilution from blending with non-PFAS material decreased PFAA concentrations. Thermal hydrolysis process had no apparent effect on PFAA concentrations. PFAS sources are a greater driver of PFAS loads in biosolid-based products than treatment processes.