Local Structure and Short-Range Order in a NiCoCr Solid Solution Alloy.

Multielement solid solution alloys are intrinsically disordered on the atomic scale, and many of their advanced properties originate from the local structural characteristics. The local structure of a NiCoCr solid solution alloy is measured with x-ray or neutron total scattering and extended x-ray absorption fine structure (EXAFS) techniques. The atomic pair distribution function analysis does not exhibit an observable structural distortion. However, an EXAFS analysis suggests that the Cr atoms are favorably bonded with Ni and Co in the solid solution alloys. This short-range order (SRO) may make an important contribution to the low values of the electrical and thermal conductivities of the Cr-alloyed solid solutions. In addition, an EXAFS analysis of Ni ion irradiated samples reveals that the degree of SRO in NiCoCr alloys is enhanced after irradiation.

Optical emission of biaxial ZnO-ZnS nanoribbon heterostructures.

The electronic structure and optical properties of biaxial ZnO-ZnS heterostructure nanoribbons (NRs) have been investigated using x-ray absorption near-edge structures (XANES) and x-ray excited optical luminescence (XEOL). The XANES were recorded in total electron yield and wavelength-selected photoluminescence yield across the K- and L(3,2)-edges of zinc and sulfur and the K-edge of oxygen. The XEOL from the NRs exhibit a very weak band-gap emission at 392 nm and two intense defect emissions at 491 and 531 nm. The synchrotron x-ray pulse ( approximately 100 ps, 153 ns repetition rate) was used to track the optical decay dynamics from ZnO-ZnS NR, which can be described by two lifetimes (7.6 and 55 ns). Comparison with similar measurements for ZnO and ZnS nanowires reveals that the luminescence from ZnO-ZnS NRs was dominated by the ZnO component of the NR as the ZnS component contributes little. The implication of this observation is discussed.

The effect of the surface of SnO2 nanoribbons on their luminescence using x-ray absorption and luminescence spectroscopy.

X-ray excited optical luminescence (XEOL) and x-ray absorption near-edge structure in total electron, x-ray fluorescence, and photoluminescence yields at Sn M5,4-, O K-, and Sn K-edges have been used to study the luminescence from SnO2 nanoribbons. The effect of the surface on the luminescence from SnO2 nanoribbons was studied by preferential excitation of the ions in the near-surface region and at the normal lattice positions, respectively. No noticeable change of luminescence from SnO2 nanoribbons was observed if the Sn ions in the near-surface region were excited selectively, while the luminescence intensity changes markedly when Sn or O ions at the normal lattice positions were excited across the corresponding edges. Based on the experimental results, we show that the luminescence from SnO2 nanoribbons is dominated by energy transfer from the excitation of the whole SnO2 lattice to the surface states. Surface site specificity is not observable due to its low concentration and weak absorption coefficient although the surface plays an important role in the emission as a luminescence center. The energy transfer and site specificity of the XEOL or the lack of the site specificity from a single-phase sample is discussed.