RESUMEN
Higher-order mode fiber amplifiers have demonstrated effective areas as large as 6000 µm2, allowing for high pulse energy and peak power amplification. Long-period gratings are used to convert the fundamental mode to the higher-order mode at the entrance to the amplifier, and reconvert back to the fundamental at the exit, to achieve a diffraction limited beam. However, long period gratings are susceptible to nonlinearity at high peak power. In this work, we propose and demonstrate axicons for linear bulk-optic mode conversion at the output of higher order mode amplifiers. We achieve an M2 of less than 1.25 for 80% mode conversion efficiency. Experiments with pulsed amplifiers confirm that the mode conversion is free from nonlinearity. Furthermore, chirp pulse amplifier experiments confirm that HOM amplifiers plus axicon mode convertors provide energy scalability in femtosecond pulses, compared to smaller effective area, fundamental mode fiber amplifiers. We also propose and demonstrate a route towards fiber integration of the axicon mode convertor by fabricating axicons directly on the tip of the fiber amplifier end-cap.
RESUMEN
We demonstrate parallel fabrication of seven fiber distributed feedback (DFB) lasers in a hexagonally arrayed multicore core Er doped fiber with 40 µm core spacing. DFB grating cavities 8 cm long and operating near 1545 nm were fabricated with a single UV inscription exposure. We observed dual polarization, single longitudinal mode operation with a linewidth below 300 kHz for each laser.
RESUMEN
Cw-operation, gain-switched, and passively Q -switched mode locking of Cr(4+): YAG microchip lasers with output powers of several hundred milliwatts is demonstrated experimentally in the eye-safe region near 1.5microm . Requirements for cw mode locking of such lasers are investigated by numerical simulations.