RESUMEN
High-power solid-state lasers with good beam quality are attracting great attention on account of their important applications in industry and military. However, the thermal effects generated in the laser host materials seriously limit power scaling and degrade the beam quality. Thermal lensing and thermally induced wavefront deformation are the main causes of the beam quality deterioration. Here we investigate the performance of a zero thermal expansion (ZTE) solid-state laser gain material. In a proof-of-principle experiment, an ${a}$-cut rod ${\rm Nd}\!:\!{{\rm YAlO}_3}$ (Nd:YAP) perovskite crystal is chosen to be the gain medium for ZTE around 180 K. The laser performance spanning the temperature range from 80 to 290 K is studied. The maximum output power and minimum threshold pump power were obtained at a temperature of 180 K. Moreover, the measured thermal focal power and peak-to-valley value of the wavefront distortion also reach a minimum at this temperature, an additional benefit from the crystal's ZTE coefficient. We envisage that these results will open a new route towards the development of high-power and high-beam-quality lasers through the use of ZTE gain materials.
RESUMEN
The flexible organic amine cations on the interfaces of two-dimensional (2D) hybrid organic-inorganic perovskite nanosheets could form relaxed structures, which would lead to exotic optoelectronic properties but are hard to understand. Here, the unusual interfacial relaxation of nanosheets exfoliated from an orthorhombic 2D lead halide perovskite, [(C6H5CH2NH3)2]PbCl4, is interrogated via ultrafast second-harmonic generation (SHG) spectroscopy. The in-plane SHG intensity anisotropy of these nanosheets is found to decrease with reducing layer thickness. Combined first-principles calculations and Monte Carlo simulations reveal that the induced second-order polarization arises primarily from the (C6H5CH2NH3)+ cations; and these organic amine cations form significantly reorganized conformations with decreasing nanosheet thickness due to weakened van der Waals interactions. Because the orientations of organic components at the interface determine their electric properties and specifically the dipolar susceptibility, the resulting structure leads to striking changes in the SHG properties.
RESUMEN
Four Hg-based IR nonlinear-optical materials, AHgSnQ4 (A = Sr, Ba; Q = S, Se), were discovered and investigated systematically. Their structures are built of two-dimensional [HgSnQ4]2- layers, which are assembled alternately by distorted (HgQ4 and SnQ4) tetrahedra and separated by eight-coordinated A2+ cations. The two sulfides AHgSnS4 (A = Ba, Sr) exhibit large second-harmonic-generation (SHG) responses (2.8 and 1.9 × AgGaS2 at 2.09 µm), as well as large band gaps (2.77 and 2.72 eV). The two selenides AHgSnSe4 (A = Ba, Sr) show even stronger SHG responses, about 5 times that of AgGaS2. Furthermore, all four compounds show phase-matching behavior, and the results of first-principles calculation elucidate the key role of the HgQ4 group in the enhanced SHG effect in ß-BaHgSnS4 and BaHgSnSe4.
RESUMEN
Visible-light-driven conversion of CO2 to CO and high-value-added carbon products is a promising strategy for mitigating CO2 emissions and reserving solar energy in chemical form. We report an efficient system for CO2 transformation to CO catalyzed by bare CoP, hybrid CoP/carbon nanotubes (CNTs), and CoP/reduced graphene oxide (rGO) in mixed aqueous solutions containing a Ru-based photosensitizer, under visible-light irradiation. The in situ prepared hybrid catalysts CoP/CNT and CoP/rGO show excellent catalytic activities in CO2 reduction to CO, with a catalytic rates of up to 39 510 and 47 330â µmol h-1 g-1 in the first 2â h of reaction, respectively; a high CO selectivity of 73.1 % for the former was achieved in parallel competing reactions in the photoreduction of CO2 and H2 O. A combination of experimental and computational studies clearly shows that strong interactions between CoP and carbon-supported materials and partially adsorbed H2 O molecules on the catalyst surface significantly improve CO-generating rates.
RESUMEN
Ammonia-borane (AB) is a promising chemical hydrogen-storage material. However, the development of real-time, efficient, controllable, and safe methods for hydrogen release under mild conditions is a challenge in the large-scale use of hydrogen as a long-term solution for future energy security. A new class of low-cost catalytic system is presented that uses nanostructured Ni2 P as catalyst, which exhibits excellent catalytic activity and high sustainability toward hydrolysis of ammonia-borane with the initial turnover frequency of 40.4â mol(H2) mol(Ni2P) (-1) min(-1) under air atmosphere and at ambient temperature. This value is higher than those reported for noble-metal-free catalysts, and the obtained Arrhenius activation energy (Ea =44.6â kJ mol(-1) ) for the hydrolysis reaction is comparable to Ru-based bimetallic catalysts. A clearly mechanistic analysis of the hydrolytic reaction of AB based on experimental results and a density functional theory calculation is presented.
RESUMEN
Catalytic conversion of carbon dioxide (CO2) to value-added chemicals under mild conditions is highly desired, albeit with significant challenges. Here, in terms of exposure of abundant active sites and excellent photo-to-thermal conversion properties, flower-like Co2C has been firstly used for effectively catalysing the cycloaddition of CO2 with epoxides to produce cyclic carbonates with yields of up to 95% under solar light. Density functional theory (DFT) calculations reveal that Lewis acid sites of the surface Co atoms can activate both CO2 and epoxide, thus opening up the possibility of a CO2-epoxide cycloaddition reaction.
RESUMEN
The CoP nanoparticle catalyst had excellent catalytic activity and a short catalytic induction period in the presence of anions, and high sustainability in ammonia borane hydrolysis, with an initial turnover frequency of 72.2 mol(H2) mol(CoP)-1 min-1 at ambient temperature. This value is unprecedented for noble-metal-free catalytic systems.