Determination of diquat by flow injection-chemiluminescence.

A simple, economic, sensitive and rapid method for the determination of the pesticide diquat was described. This new method was based on the coupling of flow injection analysis methodology and direct chemiluminescent detection; to the authors' knowledge, this approach had not been used up to now with this pesticide. It was based on its oxidation with ferricyanide in alkaline medium; significant improvements in the analytical signal were achieved by using high temperatures and quinine as sensitiser. Its high throughput (144 h(-1)), together with its low limit of detection (2 ng mL(-1)), achieved without need of preconcentration steps, permitted the reliable quantification of diquat over the linear range of (0.01-0.6) microg mL(-1) in samples from different origins (river, tap, mineral and ground waters), even in the presence of a 40-fold concentration of paraquat, a pesticide commonly present in the commercial formulations of diquat.

Copper carbonate as a solid-bed reactor for spectrophotometric determination of doxycycline and oxytetracycline in an unsegmented continuous flow assembly.

The FIA-spectrophotometric determination of doxycycline was carried out by reaction of the drug with cupric ions entrapped in a polymeric material in a packed-bed reactor: the complex formed was then injected into a manifold with an alkaline solution as carrier. The developed colour was monitored at 395.0 nm. The method was applied to the determination of doxycycline in different pharmaceutical formulations. The calibration graph for doxycycline hyclate was linear over the range 10.0-80.0 mg ml-1 (n = 8) with a relative standard deviation of 1.4% (at 25 mg ml-1) and a sample throughput of 128 h-1. The proposed procedure was also applied to the determination of oxytetracycline in pharmaceutical formulations.

Native vs photoinduced chemiluminescence in dimethoate determination.

The determination of dimethoate using either its native chemiluminescent (CL) properties or its photoinduced chemiluminescence obtained by irradiation with a 15 W low-pressure mercury lamp was studied. Thereby, two flow injection systems (FIA) with and without irradiation were exhaustively optimized and their analytical characteristics studied. Better sensitivity and selectivity was found in absence of irradiation, due to the enhancing effect of hexadecylpyridinium chloride (HPC), which acted as a sensitizer. In the developed FIA-CL system, the alkaline hydrolysis of dimethoate with NaOH was performed on-line in presence of HPC. The oxidation of the product of hydrolysis with Ce(IV) in hydrochloric medium induced chemiluminescence. The method provided a limit of detection of only 0.05 ng mL(-1) without any pre-treatment. However, the combination with solid phase extraction allowed the removal of some potential interferents as well as the preconcentration of the pesticide. Finally, the developed method was successfully applied to natural waters with recoveries between 95 and 108%.

Flow injection-photoinduced-chemiluminescence determination of ziram and zineb.

A simple, sensitive and rapid method for the determination of the pesticides ziram and zineb was described. This new method was based on the coupling of FIA methodology and direct chemiluminescent detection; this approach had not been used up to now with these pesticides. The additional use of an 'on line' photochemical reaction, which was performed by using a photoreactor consisting of a long piece of PTFE helically coiled around a 15W low-pressure lamp, increased by a factor >20 the chemiluminometric response of the pesticides. An additional 3-fold improvement in the analytical signal was also achieved by using quinine as sensitizer. The obtained throughputs were very high (121 and 101 h(-1) for ziram and zineb, respectively); this feature together with its low limit of detection (1 ng mL(-1)) makes this method particularly well suited to routine analyses of environmental samples. On the other hand, its applicability to two members of the dithiocarbamate family of pesticides, makes it promising for the determination of the rest of the members of this family. The method was demonstrated by application to spiked water samples from different origins (ground, river and irrigation).

Ultratrace measurements of nucleic acids by baseline-corrected adsorptive stripping square-wave voltammetry.

The direct and reliable electrochemical detection of DNA is of paramount importance to the development of modern DNA hybridization chips, for the detection of nucleic acids following their electrophoretic separations, or for the sensing of DNA damage and interactions. Such solid electrode voltammetric measurements of nucleic acids have been traditionally hampered by the large solvent decomposition background current that obscures the oxidation signals of the purine nucleobases. This paper reports on the use of adsorptive stripping square-wave voltammetry, in connection with the "moving average baseline correction" approach, for monitoring ultratrace levels of DNA and RNA. Compared to other baseline-fitted or background-subtraction protocols, the moving average baseline scheme is particularly effective in isolating the small purine nucleobase peaks, which appear as small shoulders on the steep background discharge contribution. The remarkably flat baseline thus obtained (up to extreme potentials) leads to a dramatic lowering of the detection limits to the femtomole level and to a performance that compares favorably with that of computerized chronopotentiometric measurements of nucleic acids. Combined with the speed of square-wave voltammetric measurements, such developments should expand the role of voltammetry in DNA diagnostics and nucleic acid research.