Systematic review and QSPR analysis of chemical penetration through the nail to inform onychomycosis candidate selection.

Recalcitrant nail plate infections can be life-long problems because localizing antifungal agents into infected tissues is problematic. In this systematic review, guided by the SPIDER method, we extracted chemical nail permeation data for 38 compounds from 16 articles, and analyzed the data using quantitative structure-property relationships (QSPRs). Our analysis demonstrated that low-molecular weight was essential for effective nail penetration, with <120 g/mol being preferred. Interestingly, chemical polarity had little effect on nail penetration; therefore, small polar molecules, which effectively penetrate the nail, but not the skin, should be set as the most desirable target chemical property in new post-screen onychomycosis candidate selections.

Solid-state epimerisation and disproportionation of pilocarpine HCl: Why we need a 5-stage approach to validate melting point measurements for heat-sensitive drugs.

Melting points for new drugs are reported in regulatory documents, e.g. investigational brochures, and frequently in published research; however, the authors do not typically consider that heat-induced degradation can affect the melting point measurement. Applying a single heating rate is not adequate, and thus many melting points in the literature and regulatory documentation are not valid. Our aim was to validate a five-stage approach for the melting point measurement of heat-sensitive drugs. These stages are; (1) observe melting; (2) record mass loss; (3) measure melting points at different heating rates; (4) characterise degradation and (5) test for potential isomerisation. Applying this approach to pilocarpine HCl illustrated the sensitivity of a melting point to thermal degradation. Due to salt disproportionation & loss of HCl gas, pilocarpine's melting point decreased by 14 °C when the heating rate was lowered from 20 to 1 °C/min. Epimerization occurred before melting was reached. Increasing the heating rate diminished disproportionation; however, this did not remove epimerization. Thus, the melting point of pilocarpine HCl of 205.5 ± 0.4 °C measured at 20 °C/min represents the melt of a racemic mixture containing inactive isopilocarpine. Heating above the melting point accelerated degradation, a rate of 5 °C/min recovered just 38 ± 1% of pilocarpine. Such data predicted a shelf-life of 6.6 years. Pilocarpine successfully validated the multistage approach by providing new knowledge concerning its thermal stability. Our 5-stage approach must be applied to all new drugs especially if their formulation requires heat. For example, thermal stability is an infrequently considered pre-requisite in the emerging field of 3D printing.

Buccal drug delivery technologies for patient-centred treatment of radiation-induced xerostomia (dry mouth).

Radiotherapy is a life-saving treatment for head and neck cancers, but almost 100% of patients develop dry mouth (xerostomia) because of radiation-induced damage to their salivary glands. Patients with xerostomia suffer symptoms that severely affect their health as well as physical, social and emotional aspects of their life. The current management of xerostomia is the application of saliva substitutes or systemic delivery of saliva-stimulating cholinergic agents, including pilocarpine, cevimeline or bethanechol tablets. It is almost impossible for substitutes to replicate all the functional and sensory facets of natural saliva. Salivary stimulants are a better treatment option than saliva substitutes as the former induce the secretion of natural saliva from undamaged glands; typically, these are the minor salivary glands. However, patients taking cholinergic agents systemically experience pharmacology-related side effects including sweating, excessive lacrimation and gastrointestinal tract distresses. Local delivery direct to the buccal mucosa has the potential to provide rapid onset of drug action, i.e. activation of minor salivary glands within the buccal mucosa, while sparing systemic drug exposure and off-target effects. This critical review of the technologies for the local delivery of saliva-stimulating agents includes oral disintegrating tablets (ODTs), oral disintegrating films, medicated chewing gums and implantable drug delivery devices. Our analysis makes a strong case for the development of ODTs for the buccal delivery of cholinergic agents: these must be patient-friendly delivery platforms with variable loading capacities that release the drug rapidly in fluid volumes typical of residual saliva in xerostomia (0.05-0.1 mL).