Defect reconfiguration in a Ti-Al alloy via electroplasticity.

It has been known for decades that the application of pulsed direct current can significantly enhance the formability of metals. However, the detailed mechanisms of this effect have been difficult to separate from simple Joule heating. Here, we study the electroplastic deformation of Ti-Al (7 at.% Al), an alloy that is uniquely suited for uncoupling this behaviour because, contrary to most metals, it has inherently lower ductility at higher temperature. We find that during mechanical deformation, electropulsing enhances cross-slip, producing a wavy dislocation morphology, and enhances twinning, which is similar to what occurs during cryogenic deformation. As a consequence, dislocations are prevented from localizing into planar slip bands that would lead to the early failure of the alloy under tension. Our results demonstrate that this macroscopic electroplastic behaviour originates from defect-level microstructural reconfiguration that cannot be rationalized by simple Joule heating.

Electronic Origins of Anomalous Twin Boundary Energies in Hexagonal Close Packed Transition Metals.

Density-functional-theory calculations of twin-boundary energies in hexagonal close packed metals reveal anomalously low values for elemental Tc and Re, which can be lowered further by alloying with solutes that reduce the electron per atom ratio. The anomalous behavior is linked to atomic geometries in the interface similar to those observed in bulk tetrahedrally close packed phases. The results establish a link between twin-boundary energetics and the theory of bulk structural stability in transition metals that may prove useful in controlling mechanical behavior in alloy design.

The key characteristics of cardiotoxicity for the pervasive pollutant phenanthrene.

The key characteristic (KCs) framework has been used previously to assess the carcinogenicity and cardiotoxicity of various chemical and pharmacological agents. Here, the 12 KCs of cardiotoxicity are used to evaluate the previously reported cardiotoxicity of phenanthrene (Phe), a tricyclic polycyclic aromatic hydrocarbon (PAH), and major component of fossil fuel-derived air pollution. Phe is a semi-volatile pollutant existing in both the gas phase and particle phase through adsorption onto or into particulate matter (PM). Phe can translocate across the airways and gastrointestinal tract into the systemic circulation, enabling body-wide effects. Our evaluation based on a comprehensive literature review, indicates Phe exhibits 11 of the 12 KCs for cardiotoxicity. These include adverse effects on cardiac electromechanical performance, the vasculature and endothelium, immunomodulation and oxidative stress, and neuronal and endocrine control. Environmental agents that have similarly damaging effects on the cardiovascular system are heavily regulated and monitored, yet globally there is no air quality regulation specific for PAHs like Phe. Environmental monitoring of Phe is not the international standard with benzo[a]pyrene being frequently used as a proxy despite the two PAH species exhibiting significant differences in sources, concentration variations and toxic effects. The evidence summarised in this evaluation highlights the need to move away from proxied PAH measurements and develop a monitoring network capable of measuring Phe concentration. It also stresses the need to raise awareness amongst the medical community of the potential cardiovascular impact of PAH exposure. This will allow the production of mitigation strategies and possibly the development of new policies for the protection of the societal groups most vulnerable to cardiovascular disease.

Grain refinement in titanium prevents low temperature oxygen embrittlement.

Interstitial oxygen embrittles titanium, particularly at cryogenic temperatures, which necessitates a stringent control of oxygen content in fabricating titanium and its alloys. Here, we propose a structural strategy, via grain refinement, to alleviate this problem. Compared to a coarse-grained counterpart that is extremely brittle at 77 K, the uniform elongation of an ultrafine-grained (UFG) microstructure (grain size ~ 2.0 µm) in Ti-0.3wt.%O is successfully increased by an order of magnitude, maintaining an ultrahigh yield strength inherent to the UFG microstructure. This unique strength-ductility synergy in UFG Ti-0.3wt.%O is achieved via the combined effects of diluted grain boundary segregation of oxygen that helps to improve the grain boundary cohesive energy and enhanced dislocation activities that contribute to the excellent strain hardening ability. The present strategy will not only boost the potential applications of high strength Ti-O alloys at low temperatures, but can also be applied to other alloy systems, where interstitial solution hardening results into an undesirable loss of ductility.

Elimination of oxygen sensitivity in α-titanium by substitutional alloying with Al.

Individually, increasing the concentration of either oxygen or aluminum has a deleterious effect on the ductility of titanium alloys. For example, extremely small amounts of interstitial oxygen can severely deteriorate the tensile ductility of titanium, particularly at cryogenic temperatures. Likewise, substitutional aluminum will decrease the ductility of titanium at low-oxygen concentrations. Here, we demonstrate that, counter-intuitively, significant additions of both Al and O substantially improves both strength and ductility, with a 6-fold increase in ductility for a Ti-6Al-0.3 O alloy as compared to a Ti-0.3 O alloy. The Al and O solutes act together to increase and sustain a high strain-hardening rate by modifying the planar slip that predominates into a delocalized, three-dimensional dislocation pattern. The mechanism can be attributed to decreasing stacking fault energy by Al, modification of the "shuffle" mechanism of oxygen-dislocation interaction by the repulsive Al-O interaction in Ti, and micro-segregation of Al and O by the same cause.

Mechanistic basis of oxygen sensitivity in titanium.

One of the most potent examples of interstitial solute strengthening in metal alloys is the extreme sensitivity of titanium to small amounts of oxygen. Unfortunately, these small amounts of oxygen also lead to a markedly decreased ductility, which in turn drives the increased cost to purify titanium to avoid this oxygen poisoning effect. Here, we report a systematic study on the oxygen sensitivity of titanium that provides a clear mechanistic view of how oxygen impurities affect the mechanical properties of titanium. The increased slip planarity of Ti-O alloys is caused by an interstitial shuffling mechanism, which is sensitive to temperature, strain rate, and oxygen content and leads to the subsequent alteration of deformation twinning behavior. The insights from our experimental and computational work provide a rationale for the design of titanium alloys with increased tolerance to variations in interstitial content, with notable implications for more widespread use of titanium alloys.

Direct imaging of short-range order and its impact on deformation in Ti-6Al.

Chemical short-range order (SRO) within a nominally single-phase solid solution is known to affect the mechanical properties of alloys. While SRO has been indirectly related to deformation, direct observation of the SRO domain structure, and its effects on deformation mechanisms at the nanoscale, has remained elusive. Here, we report the direct observation of SRO in relation to deformation using energy-filtered imaging in a transmission electron microscope (TEM). The diffraction contrast is enhanced by reducing the inelastically scattered electrons, revealing subnanometer SRO-enhanced domains. The destruction of these domains by dislocation planar slip is observed after ex situ and in situ TEM mechanical testing. These results confirm the impact of SRO in Ti-Al alloys on the scale of angstroms. The direct confirmation of SRO in relationship to dislocation plasticity in metals can provide insight into how the mechanical behavior of concentrated solid solutions by the material's thermal history.

The proto-oncogene c-fos is over-expressed in the majority of human osteosarcomas.

The expression of fos protein was examined in 30 cases of human osteosarcoma as formalin-fixed and paraffin-embedded tissue sections using two monoclonal antibodies and, for five cases, as frozen sections using 3 polyclonal antibodies. Nuclear antibody labeling intensities were determined either by visual scoring (3 pathologists) or by microdensitometry and included over 700 tumor, 350 normal and 150 benign tissue observations. Visual scores were shown to be linear with optical density with a correlation coefficient of 0.97. Analysis of the osteosarcoma cases at one antibody concentration revealed two groups: a minority (39%) with a low average visual score of 2 +/- 0.2 which was very similar to benign and normal tissues, and a majority (61%) with an average score of 3.1 +/- 0.3. The difference is highly significant (t-test), P less than or equal to 0.01. The results were supported by an analysis of partial immunotitration curves using a curve-fitting procedure which yielded estimates of FOSo (maximum relative fos protein concentration) which were ca. 150% increased for the majority tumor group compared to the minority group or benign or normal tissues. In previous studies of v-sis transformed cells, which exhibit ca. 300% over-expression of c-fos protein as observed here, antisense techniques were used to show that over-expression leads to increased growth and loss of contact inhibition. Thus the combined results suggest that steady state c-fos protein is significantly elevated in, and may contribute to, the aggressive growth properties of a majority of human osteosarcomas.

Metallurgy. Origin of dramatic oxygen solute strengthening effect in titanium.

Structural alloys are often strengthened through the addition of solute atoms. However, given that solute atoms interact weakly with the elastic fields of screw dislocations, it has long been accepted that solution hardening is only marginally effective in materials with mobile screw dislocations. By using transmission electron microscopy and nanomechanical characterization, we report that the intense hardening effect of dilute oxygen solutes in pure α-Ti is due to the interaction between oxygen and the core of screw dislocations that mainly glide on prismatic planes. First-principles calculations reveal that distortion of the interstitial sites at the screw dislocation core creates a very strong but short-range repulsion for oxygen that is consistent with experimental observations. These results establish a highly effective mechanism for strengthening by interstitial solutes.

Triacetylated insulin: biologic activity and resistance to degradation.

Tritiated N-hydroxysuccinimide acetate was prepared with specific activities up to 5 Ci/mmole and utilized to prepare tritiated triacetyl insulin. Binding of triacetyl insulin to liver plasma membranes was measured by its capacity to displace 125I-monoiodoinsulin. At low concentrations, less than 10 ng/ml triacetyl insulin appears to be as effective as native insulin in reducing the binding of 125I-monoiodoinsulin to plasma membranes. At concentrations of 20 ng/ml and higher, triacetyl insulin is significantly less effective than native insulin in displacing binding of 125I-monoiodoinsulin to plasma membranes. The properties of triacetyl insulin in this system are not ascribable to deacetylation and conversion of the substituted product to native insulin. Biologic activity of triacetylated insulin was studied in two other in vitro systmes. A comparison was made of the capacity of native beef insulin and its triacetyl derivative to stimulate glucose oxidation by epididymal fat pads. At all three concentrations tested (2, 6, and 18 ng/ml), triacetyl insulin exerted considerable activity, although its potency was significantly less than that of native insulin. Similar effects were observed when biologic activity was measured by induction of tyrosine-alpha-ketoglutarate transaminase in a cultured liver cell system where significant activity of triacetyl insulin was found at concentrations of 10(-9)-10(-7) M. In all systems tested, the activity of triacetylated insulin could not be accounted for by deacetylation and conversion to native insulin. In all systems studied, triacetyl insulin was more resistant to degradation than was monoiodoinsulin.

Multichannel scaling with an eight bit microcomputer.

In this note a microcomputer-based system for multichannel scaling is described. This system relies on a combination of simple hardware with software support to achieve maximum cost effectiveness.

Development of a Nanoindenter for In Situ Transmission Electron Microscopy.

In situ transmission electron microscopy is an established experimental technique that permits direct observation of the dynamics and mechanisms of dislocation motion and deformation behavior. In this article, we detail the development of a novel specimen goniometer that allows real-time observations of the mechanical response of materials to indentation loads. The technology of the scanning tunneling microscope is adopted to allow nanometer-scale positioning of a sharp, conductive diamond tip onto the edge of an electron-transparent sample. This allows application of loads to nanometer-scale material volumes coupled with simultaneous imaging of the material's response. The emphasis in this report is qualitative and technique oriented, with particular attention given to sample geometry and other technical requirements. Examples of the deformation of aluminum and titanium carbide as well as the fracture of silicon will be presented.

Biostatistical evaluation of evidence from continuous allele frequency distribution deoxyribonucleic acid (DNA) probes in reference to disputed paternity and identity.

We present a development and discussion of the biostatistical evaluation of deoxyribonucleic acid (DNA) probe evidence in forensic science cases of disputed paternity and identity. We restrict ourselves to single-locus codominant systems (highly analogous to more conventional systems) which have the apparently novel complication of an experimentally continuous allele frequency distribution. This complication necessitates reformulations of standard biostatistical summaries of the evidence (the paternity index (PI) and the phenotype frequency, respectively). These reformulations, rather than representing a unique case, have applicability to the evaluation of evidence obtained in standard genetic systems now in widespread use.

Findings from long-term monitoring studies at MSW landfill facilities with leachate recirculation.

This paper presents findings from long-term monitoring studies performed at full-scale municipal solid waste landfill facilities with leachate recirculation. Data from two facilities at a landfill site in Delaware, USA were evaluated as part of this study: (1) Area A/B landfill cells; and (2) two test cells (one with leachate recirculation and one control cell). Data from Area A/B were compared with proposed waste stability criteria for leachate quality, landfill gas production, and landfill settlement. Data from the test cells were directly compared with each other. Overall, the trends at Area A/B pointed to the positive effects (i.e., more rapid waste degradation) that may be realized through increasing moisture availability in a landfill relative to the reported behavior of more traditionally operated (i.e., drier) landfills. Some significant behavioral differences between the two test cells were evident, including dissimilarities in total landfill gas production quantity and the extent of waste degradation observed in recovered time capsules. Differences in leachate quality were not as dramatic as anticipated, probably because the efficiency of the leachate recirculation system at distributing leachate throughout the waste body in the recirculation cell was low.

KVP meter errors induced by plastic wrap.

The purpose of this study was to determine whether erroneous kVp meter readings, induced by plastic wrap, affected the actual kVp (output) of a dental X-ray machine. To evaluate the effect of plastic wrap on dental X-ray machine kVp meters, a radiation output device was used to measure output in mR/ma.s. An intraoral dental X-ray unit (S.S. White Model #90W) was used to make the exposures. First, the kVp meter was not covered with plastic wrap and output readings were recorded at various kVp settings with the milliamperage and time held constant. Secondly, the same kVp settings were selected before the plastic wrap was placed. Milliamperage and time were again held to the same constant. The X-ray console was then covered with plastic wrap prior to measuring the output for each kVp. The wrap possessed a static charge. This charge induced erroneous kVp meter readings. Out-put readings at the various induced kVp settings were then recorded. A kVp of 50 with no wrap present resulted in the same output as a kVp of 50 induced to read 40 or 60 kVp by the presence of wrap. Similar results were obtained at other kVp settings. This indicates that the plastic wrap influences only the kVp meter needle and not the actual kilovoltage of the X-ray machine. Dental X-ray machine operators should select kVp meter readings prior to placing plastic wrap and should not adjust initial settings if the meter is deflected later by the presence of wrap. The use of such a procedure will result in proper exposures, fewer retakes, and less patient radiation. If plastic wrap leads to consistent exposure errors, clinicians may wish to use a 0.5% sodium hypochlorite disinfectant as an alternative to the barrier technique.