Investigating sagittal spinopelvic alignment and equivalent stress on the femoral head in patients with rapidly destructive coxarthrosis.

PURPOSE: Rapidly destructive coxarthrosis (RDC) is a rare syndrome of unknown etiology. This study evaluated sagittal spinopelvic alignment (SSPA) in patients with RDC and compared it with that in patients with hip osteoarthritis (HOA). In addition, finite element analysis (FEA) was performed to investigate the distribution of stress on the femoral head in RDC versus HOA. METHODS: This retrospective study included patients who had undergone primary total hip arthroplasty for RDC (n = 33) and HOA (n = 99; age- and sex-matched to patients with RDC) at three hospitals from June 2014 to September 2020. Preoperative SSPA parameters and inflammatory blood markers were compared between the two groups. FEA on the computed tomography data was performed for four patients from each group with similar pelvic tilt (PT) and lateral center-edge angle (LCEA). The distribution of Drucker-Prager equivalent stress was assessed at the loaded area of the femoral head. RESULTS: Patients with RDC had significantly higher PT, lower sacral slope, decreased lumbar lordosis (LL), higher sagittal vertical axis, and higher pelvic incidence minus LL than patients with HOA, indicating sagittal spinal imbalance. Blood test revealed patients with RDC had higher levels of inflammation markers than patients with HOA. FEA revealed no statistically significant difference in the degree of stress concentration or the maximum equivalent stress between the two groups when PT and LCEA were comparable. CONCLUSION: Patients with RDC tend to have sagittally imbalanced spine. Decreased acetabular coverage of the femoral head may heighten mechanical load of the hip joint in patients with RDC.

Long-term outcome of primary total hip arthroplasty with cementless bioactive glass ceramic bottom-coated implants and highly cross-linked polyethylene: A minimum 10-year analysis.

BACKGROUND: Cementless glass ceramics containing apatite and wollastonite (AW-GC) bottom-coated titanium hip implants were developed; early excellent clinical and radiographic results have been reported previously. This study aimed to investigate the long-term clinical and radiographic outcomes in detail, and the wear rate of HXLPE. METHODS: We retrospectively evaluated 99 patients (117 hips) between November 2001 and December 2007. The survival rate was estimated using the Kaplan-Meier method. Hip joint function was evaluated using the Japanese Orthopaedic Association (JOA) score. The extent of radiographic signs was determined from the radiographs performed at the last follow-up. Polyethylene wear was measured using Martell's Hip Analysis Suite. We assessed the possible factors affecting the steady-state linear wear rate. RESULTS: The mean follow-up period was 14.8 ± 2.1 (10-18.6) years. The mean JOA score improved to 88.7 ± 9.4 (59-100) at the final follow-up from 47.8 ± 12.5 (17-76) before surgery. The overall survival rate with the end point of all-cause revision and wear-related revision was 99% and 100% respectively. There was no osteolysis or loosening of either the acetabular or femoral component. All hips were classified as having bone ingrowth fixation. The mean steady-state wear rate was 0.008 ± 0.025 mm/year. We found no significant correlation between the wear rate and age, body weight, body mass index, cup inclination and femoral head size. CONCLUSION: The combination of AW-GC bottom-coated implants and HXLPE showed excellent implant survival and wear resistance for 15 years.

Bone ingrowth into a porous structure is achieved by preceding fibrogenesis and vascularization.

Porous structures are frequently used in surgical implants to strengthen the interlocking power produced by bone ingrowth. Therefore, we aimed to elucidate the mechanism underlying bone ingrowth into a porous structure accompanied by vascularization. A nonbioactive polyetheretherketone implant with a 3D-printed porous structure was prepared and implanted in a bone hole created in the tibias of rabbits. We observed bone ingrowth in the same individual specimens immediately and at 2, 4, 8, and 12 weeks post-implantation using in-vivo computed tomography (CT). Furthermore, a detailed evaluation with blood vessels of each specimen at 2, 4, and 12 weeks was performed with ex-vivo CT and histological specimen. Additional histological evaluation was performed using thin sections of an implant made with thermoplastic polyurethane having the same structure. As a result, the bone invasion began after four weeks, when the construction of fibrous tissue and the spread of new blood vessels within the voids matured. As the bone matured in the load-bearing area, new blood vessels outside the bone matrix regressed. This longitudinal evaluation study suggests that preceding fibrogenesis and vascularization may be key in developing bone ingrowth. STATEMENT OF SIGNIFICANCE: A porous structure is an essential structure for dental and orthopedic implants because it provides strong fixation through bone invasion. Although it was known that vascularization was involved in this, the details were not known. This in vivo study revealed that in order for bone ingrowth to begin, a preparatory period of approximately 4 weeks was required to establish blood flow inside and outside the implant. Furthermore, it was confirmed that by spreading the fibrous structure in advance, it has an advantageous effect on the migration of cells involved in the formation of bones and blood vessels. We pointed out that it is necessary to consider fibrogenesis and vascularization when creating future implants.

Wear resistance of first-generation highly cross-linked annealed polyethylene in cementless total hip arthroplasty is maintained 20 years after surgery.

AIMS: The aim of this study was to evaluate the performance of first-generation annealed highly cross-linked polyethylene (HXLPE) in cementless total hip arthroplasty (THA). METHODS: We retrospectively evaluated 29 patients (35 hips) who underwent THA between December 2000 and February 2002. The survival rate was estimated using the Kaplan-Meier method. Hip joint function was evaluated using the Japanese Orthopaedic Association (JOA) score. Two-dimensional polyethylene wear was estimated using Martell's Hip Analysis Suite. We calculated the wear rates between years 1 and 5, 5 and 10, 10 and 15, and 15 and final follow-up. RESULTS: The mean follow-up period was 19.1 years (SD 0.6; 17.3 to 20.1). The 19-year overall survival rate with the end point of all-cause revision was 97.0% (95% confidence interval (CI) 91 to 100). The mean JOA score improved from 43.2 (SD 10.6; 30 to 76) before surgery to 90.2 (SD 6.4; 76 to 98) at the final follow-up (p < 0.001). There was no osteolysis or loosening of the acetabular or femoral components. The overall steady-state wear rate was 0.013 mm/year (SD 0.012). There was no hip with a steady-state wear rate of > 0.1 mm/year. There was no significant difference in wear rates for each period. We found no significant correlation between the wear rate and age, body weight, BMI, or cup inclination. CONCLUSION: First-generation annealed HXLPE shows excellent wear resistance and no acceleration of wear for approximately 20 years, with low all-cause revision rates. Cite this article: Bone Joint J 2022;104-B(2):200-205.

Radiolucent lines do not affect the longevity of highly cross-linked polyethylene cemented components in total hip arthroplasty.

AIMS: We aimed to evaluate the long-term outcome of highly cross-linked polyethylene (HXLPE) cemented acetabular components and assess whether any radiolucent lines (RLLs) which arose were progressive. METHODS: We retrospectively reviewed 170 patients who underwent 187 total hip arthroplasties at two hospitals with a minimum follow-up of ten years. All interventions were performed using the same combination of HXLPE cemented acetabular components with femoral stems made of titanium alloy. Kaplan-Meier survival analysis was performed for the primary endpoint of acetabular component revision surgery for any reason and secondary endpoint of the appearance of RLLs. RLLs that had appeared once were observed over time. We statistically assessed potential relationships between RLLs and a number of factors, including the technique of femoral head autografting and the Japanese Orthopaedic Association score. RESULTS: The mean follow-up period was 13.0 years (10.0 to 16.3). Femoral head autografting was performed on 135 hips (72.2%). One acetabular component was retrieved because of deep infection. No revision was performed for the aseptic acetabular loosening. The Kaplan-Meier survival curve for the primary and secondary endpoints were 98.2% (95% confidence interval (CI) 88.6% to 99.8%) and 79.3% (95% CI 72.8% to 84.6%), respectively. RLLs were detected in 38 hips (21.2%), at a mean of 1.7 years (1 month to 6 years) postoperatively. None of the RLLs were progressive, and the presence of RLLs did not show a significant association with the survival and clinical score. RLLs were more frequently observed in hips without femoral head autografts than in those with autografts. CONCLUSION: The use of HXLPE cemented acetabular components in total hip arthroplasty demonstrated excellent clinical outcomes after ten years, and no RLLs were progressive, and their presence did not affect the outcome. Femoral head autografting did not negatively impact the acetabular component survival or the appearance of RLLs. Cite this article: Bone Joint J 2021;103-B(10):1604-1610.

Solitary Muscle Metastasis of Hepatocellular Carcinoma to the Biceps Femoris Muscle with Only Elevated Serum PIVKA-II: A Case Report.

BACKGROUND Hepatocellular carcinoma (HCC) is a common primary hepatic cancer. Regardless of its metastatic potential, metastasis to skeletal muscle is rare, especially to one solitary muscle. The diagnostic efficiency of Protein induced by Vitamin K absence/antagonist-II (PIVKA-II) has been illustrated sufficiently and it has been proven that PIVKA-II is a potent biomarker and independent of alpha-fetoprotein (AFP). The present report describes a case of solitary muscle metastasis with PIVKA-II elevation. CASE REPORT An 81-year-old man noticed a growing mass in the proximal posterior thigh, and it was found to be a solitary tumor in the biceps femoris muscle. He had undergone a medial segmentectomy for primary HCC and transcatheter arterial chemoembolization for an intrahepatic recurrence 7 and 4 years before, respectively. The level of PIVKA-II was elevated to 11 400 mAU/mL, but the alpha-fetoprotein (AFP) level was normal. Elevation of PIVKA-II to over 50 mAU/mL had been observed 7 months before the muscular lesion was first observed. When the solitary metastasis was diagnosed, a wide resection was performed in the same way as for primary sarcoma, and the PIVKA-II value decreased to 71 mAU/mL. No recurrence at the muscle was observed, but multiple lung metastases were seen and the PIVKA-II was elevated to 1410 mAU/mL 4 months after the resection. CONCLUSIONS Resection of the solitary muscle metastasis helped control the local metastatic lesion and helped with ability to perform daily activities, as well as possibly prolonging survival. PIVKA-II is an important biomarker for HCC surveillance in conjunction with alpha-fetoprotein (AFP). PIVKA-II can be independent of AFP. Examination of the whole body is still necessary in cases with elevated PIVKA-II in order to detect extrahepatic metastasis.

Phagocytic response to fully controlled plural stimulation of antigens on macrophage using on-chip microcultivation system.

To understand the control mechanism of innate immune response in macrophages, a series of phagocytic responses to plural stimulation of antigens on identical cells was observed. Two zymosan particles, which were used as antigens, were put on different surfaces of a macrophage using optical tweezers in an on-chip single-cell cultivation system, which maintains isolated conditions of each macrophage during their cultivation. When the two zymosan particles were attached to the macrophage simultaneously, the macrophage responded and phagocytosed both of the antigens simultaneously. In contrast, when the second antigen was attached to the surface after the first phagocytosis had started, the macrophage did not respond to the second stimulation during the first phagocytosis; the second phagocytosis started only after the first process had finished. These results indicate that (i) phagocytosis in a macrophage is not an independent process when there are plural stimulations; (ii) the response of the macrophage to the second stimulation is related to the time" delay from the first stimulation. Stimulations that occur at short time intervals resulted in simultaneous phagocytosis, while a second stimulation that is delayed long enough might be neglected until the completion of the first phagocytic process.