Kinetics of the formation and destruction of PCDD/Fs in a laboratory tubular furnace.

A kinetic model has been developed for the formation of selected congeners of PCDD/Fs during the thermal decomposition of different wastes in a horizontal reactor. Previously published data on the decomposition of wastes have been correlated using a kinetic model that only considers process parameters, such as the presence of different amounts of oxygen in the atmosphere of reaction, chlorine and metals in the waste. The effect of both chlorine and metals is modelled through an equation assuming a "saturation effect", i.e., that a certain amount of each substance produces the maximum rate, and that higher amounts do not increase the rate. The presence of oxygen is modelled by a destruction reaction over part of the PCDD/Fs produced. The model, which uses data from more than 64 experiments, correlated the emissions of three selected congeners: 1,2,3,6,7,8-HxCDD, OCDF and 2,3,7,8-TCDF, which are enough to estimate the total amount and toxicity of an emission.

Volatile and semivolatile emissions from the pyrolysis of almond shell loaded with heavy metals.

Heavy metal-loaded almond shell was subjected to pyrolysis to understand the effect of the presence of different heavy metals on its thermal degradation. Pyrolysis behavior of native and metal-loaded samples was studied by thermogravimetric analysis. Similar shapes of thermogravimetric curves indicate that the presence of cadmium (Cd), chromium (Cr), copper (Cu), nickel (Ni) and lead (Pb) did not change the main degradation pathways of almond shell. However, the temperature at which the decomposition in each stage takes place at a higher rate and char yield was considerably modified by the presence of Cr and Ni. Then, pyrolysis tests of the almond shell samples were performed in a moving tubular reactor at 700°C. Gases and volatile organic compounds were collected using Tedlar bags and semivolatile organic compounds were collected using a resin as adsorbent. Significant changes were obtained in the composition of the gaseous fraction as a result of the metal impregnation. The main changes in the composition of the gas were observed for Ni-loaded sample, which presented the highest H2 and CO yields. Also, the yields of most of the light hydrocarbons decrease in the presence of metal, while the rest remain quite similar. The total PAH yields reached 103µg/g for nickel-loaded sample (NiAS), 164µg/g for copper-loaded sample (CuAS), 172µg/g for lead-loaded sample (PbAS), 245µg/g for native sample (AS), 248µg/g for cadmium-loaded sample (CdAS) and 283µg/g for chromium-loaded sample (CrAS). Nickel is the most effective in the higher aromatic tar reduction, followed by Cu and Pb, whereas the presence of Cd does not affect the total emissions of PAHs. Finally, the carcinogenic potency of the samples was calculated. Native sample and the sample loaded with Cr presented slightly higher values associated to the presence of small amounts of benzo(a)pyrene.

Ebola, fragile health systems and tuberculosis care: a call for pre-emptive action and operational research.

The Ebola outbreak that started in late 2013 is by far the largest and most sustained in history. It occurred in a part of the world where pre-existing health systems were already fragile, and these deteriorated further during the epidemic due to a large number of health worker deaths; temporary or permanent closure of health facilities; non-payment of health workers; intrinsic fear of contracting or being stigmatised by Ebola among the population, which negatively influenced health-seeking behaviour; enforced quarantine of Ebola-affected communities, restricting the access of vulnerable individuals to health facilities; and late response by the international community. There are also reports of drug and consumable stockouts due to deficiencies in the procurement and supply chain as a result of overriding Ebola-related priorities. Providing tuberculosis (TB) care and achieving favourable treatment outcomes require a fully functioning health system, accurate patient tracking and high patient adherence to treatment. Furthermore, as Ebola is easily transmitted through body fluids, the use of needles-essential for TB diagnosis and treatment-needs to be avoided during an outbreak. We highlight ways in which a sustained Ebola outbreak could jeopardise TB activities and suggest pre-emptive preventive measures while awaiting operational research evidence.

Use of nanoclay platelets in food packaging materials: technical and cytotoxicity approach.

Two organo-modified clays for food contact applications were developed to produce hydrophobically modified montmorillonite and hence to obtain better compatibility between the biopolymer and the filler (nanoclay). These nanofillers were characterised by Fourier transform infrared (FTIR) spectroscopy, X-ray diffraction and thermogravimetric analysis (TGA) in order to study their composition, structure and thermal stability. The fillers were used to reinforce polylactic acid (PLA) bottles, which were characterised using different techniques such as mechanical and barrier properties, morphology and thermal stability. The results were compared with conventional PLA bottles. The use of the modified clay in PLA bottles was found to lead to an improvement in mechanical and barrier properties. Finally, cytotoxicity tests were carried out with the organo-modified clays using Caco-2 and HepG2 cell lines, with uptake of neutral red as a basal cytotoxicity biomarker.