Biomass aggregation influences NaN3 short-term effects on anammox bacteria activity.

The main bottleneck to maintain the long-term stability of the partial nitritation-anammox processes, especially those operated at low temperatures and nitrogen concentrations, is the undesirable development of nitrite oxidizing bacteria (NOB). When this occurs, the punctual addition of compounds with the capacity to specifically inhibit NOB without affecting the process efficiency might be of interest. Sodium azide (NaN3) is an already known NOB inhibitor which at low concentrations does not significantly affect the ammonia oxidizing bacteria (AOB) activity. However, studies about its influence on anammox bacteria are unavailable. For this reason, the objective of the present study was to evaluate the effect of NaN3 on the anammox activity. Three different types of anammox biomass were used: granular biomass comprising AOB and anammox bacteria (G1), anammox enriched granules (G2) and previous anammox granules disaggregated (F1). No inhibitory effect of NaN3 was measured on G1 sludge. However, the anammox activity decreased in the case of G2 and F1. Granular biomass activity was less affected (IC50 90 mg/L, G2) than flocculent one (IC50 5 mg/L, F1). Summing up, not only does the granular structure protect the anammox bacteria from the NaN3 inhibitory effect, but also the AOB act as a barrier decreasing the inhibition.

Novel system configuration with activated sludge like-geometry to develop aerobic granular biomass under continuous flow.

A novel continuous flow system with "flat geometry" composed by two completely mixed aerobic tanks in series and a settler was used to promote the formation of aerobic granular sludge. Making similarities of this system with a typical sequencing batch reactor (SBR), for aerobic granules cultivation, the value of the tank 1/tank 2 vol ratio and the biomass recirculation rate would correspond with the feast/famine length ratio and the length of the operational cycle, respectively, while the settler upflow liquid velocity imposed would be related to the settling time. From the three experiments performed the best results were obtained when the tank 1/tank 2 vol ratio was of 0.28, the sludge recycling ratio of 0.25 and the settler upflow velocity of 2.5 m/h. At these conditions the aggregates had settling velocities between 29 and 113 m/h, sludge volume index at 10 min (SVI10) of 70 mL/g TSS and diameters between 1.0 and 5.0 mm.