RESUMEN
Silicon photonics (SiPh) are considered a promising technology for increasing interconnect speed and capacity while decreasing power consumption. Mode division multiplexing (MDM) enables signals to be transmitted in different orthogonal modes in a single waveguide core. Wideband MDM components simultaneously supporting wavelength division multiplexing (WDM) and orthogonal frequency-division multiplexing (OFDM) can significantly increase the transmission capacity for optical interconnects. In this work, we propose, fabricate and demonstrate a wideband and channel switchable MDM optical power divider on an SOI platform, supporting single, dual and triple modes. The switchable MDM power divider consists of two parts. The first part is a cascaded Mach-Zehnder interferometer (MZI) for switching the data from their original TE0, TE1 and TE2 modes to different modes among themselves. After the target modes are identified, mode up-conversion and Y-branch are utilized in the second part for the MDM power division. Here, 48 WDM wavelength channels carrying OFDM data are successfully switched and power divided. An aggregated capacity of 7.682 Tbit/s is achieved, satisfying the pre-forward error correction (pre-FEC) threshold (bit-error-rate, BER = 3.8 × 10-3). Although up to three MDM modes are presented in the proof-of-concept demonstration here, the proposed scheme can be scaled to higher order modes operation.
Asunto(s)
Registros , Silicio , Prueba de Estudio Conceptual , TecnologíaRESUMEN
Due to the popularity of different high bandwidth applications, it is becoming increasingly difficult to satisfy the huge data capacity requirements, since the traditional electrical interconnects suffer significantly from limited bandwidth and huge power consumption. Silicon photonics (SiPh) is one of the important technologies for increasing interconnect capacity and decreasing power consumption. Mode-division multiplexing (MDM) allows signals to be transmitted simultaneously, at different modes, in a single waveguide. Wavelength-division multiplexing (WDM), non-orthogonal multiple access (NOMA) and orthogonal-frequency-division multiplexing (OFDM) can also be utilized to further increase the optical interconnect capacity. In SiPh integrated circuits, waveguide bends are usually inevitable. However, for an MDM system with a multimode bus waveguide, the modal fields will become asymmetric when the waveguide bend is sharp. This will introduce inter-mode coupling and inter-mode crosstalk. One simple approach to achieve sharp bends in multimode bus waveguide is to use a Euler curve. Although it has been reported in the literature that sharp bends based on a Euler curve allow high performance and low inter-mode crosstalk multimode transmissions, we discover, by simulation and experiment, that the transmission performance between two Euler bends is length dependent, particularly when the bends are sharp. We investigate the length dependency of the straight multimode bus waveguide between two Euler bends. High transmission performance can be achieved by a proper design of the waveguide length, width, and bend radius. By using the optimized MDM bus waveguide length with sharp Euler bends, proof-of-concept NOMA-OFDM experimental transmissions, supporting two MDM modes and two NOMA users, are performed.
RESUMEN
We demonstrate an optical-camera-communication (OCC) system utilizing a laser-diode (LD) coupled optical-diffusing-fiber (ODF) transmitter (Tx) and rolling-shutter based image sensor receiver (Rx). The ODF is a glass optical fiber produced for decorative lighting or embedded into small areas where bulky optical sources cannot fit. Besides, decoding the high data rate rolling-shutter pattern from the thin ODF Tx is very challenging. Here, we propose and experimentally demonstrate the pixel-row-per-bit based neural-network (PPB-NN) to decode the rolling-shutter-pattern emitted by the thin ODF Tx. The proposed PPB-NN algorithm is discussed. The proposed PPB-NN method can satisfy the pre-forward error correction (FEC) BER at data rate of 3,300 bit/s at a transmission distance of 35 cm. Theoretical analysis of the maximum ODF Tx angle is also discussed; and our experimental values agree with our theoretical results.