Active Opto-Magnetic Biosensing with Silicon Microring Resonators.

Integrated optical biosensors are gaining increasing attention for their exploitation in lab-on-chip platforms. The standard detection method is based on the measurement of the shift of some optical quantity induced by the immobilization of target molecules at the surface of an integrated optical element upon biomolecular recognition. However, this requires the acquisition of said quantity over the whole hybridization process, which can take hours, during which any external perturbation (e.g., temperature and mechanical instability) can seriously affect the measurement and contribute to a sizeable percentage of invalid tests. Here, we present a different assay concept, named Opto-Magnetic biosensing, allowing us to optically measure off-line (i.e., post hybridization) tiny variations of the effective refractive index seen by microring resonators upon immobilization of magnetic nanoparticles labelling target molecules. Bound magnetic nanoparticles are driven in oscillation by an external AC magnetic field and the corresponding modulation of the microring transfer function, due to the effective refractive index dependence on the position of the particles above the ring, is recorded using a lock-in technique. For a model system of DNA biomolecular recognition we reached a lowest detected concentration on the order of 10 pm, and data analysis shows an expected effective refractive index variation limit of detection of 7.5×10-9 RIU, in a measurement time of just a few seconds.

Peptide-Based Sensor and Microfluidic Platform for IgG Antibody Detection by Differential Impedance Sensing.

Serological assays enable infection screening as relatively easy-to-operate approaches compared with standard methods. In addition, to be relevant for early diagnosis, specific antibody detection is important for epidemiological surveillance and quantitative detection has potential significance for evaluating the severity and prognosis of different diseases.Here, we describe the detection process based on differential impedance sensing of IgG antibodies labeled with polystyrene nanoparticles. The electrode differential configuration, the amplification with nanoparticle functionalization, the electronic reading, and the microfluidic protocol allow to reach a limit of detection below 100 pg/mL for commercial IgG antibody spiked in buffer.

Differential Impedance Sensing platform for high selectivity antibody detection down to few counts: A case study on Dengue Virus.

We developed a biosensing system for serological detection of viruses based on the impedance variation between gold microelectrodes upon the capture of the target antibodies hybridized with nanobeads for signal amplification. The microfluidic platform core features a Differential Impedance Sensing (DIS) architecture between a reference and an active sensor able to reach nanoparticle resolution of few tens. The biosensor, functionalized with a copoly layer housing a synthetic peptide probe, has shown a limit of detection (LOD) below 100 pg/mL using a model IgG antibody spiked in a buffer. The biosensor was also tested with human serum samples for quantitative counts of anti-Dengue Virus antibodies, reaching a sensitivity that outperforms commercial ELISA kit. The system is perfectly suited to be easily reconfigured for novel probes by simply modifying the preparation of the biosensor chip surface, thus addressing a wide range of pathogens and diseases with clinically relevant concentrations for rapid immunoassays in a point of care setting.

Ferroelectricity in Si-Doped Hafnia: Probing Challenges in Absence of Screening Charges.

The ability to develop ferroelectric materials using binary oxides is critical to enable novel low-power, high-density non-volatile memory and fast switching logic. The discovery of ferroelectricity in hafnia-based thin films, has focused the hopes of the community on this class of materials to overcome the existing problems of perovskite-based integrated ferroelectrics. However, both the control of ferroelectricity in doped-HfO2 and the direct characterization at the nanoscale of ferroelectric phenomena, are increasingly difficult to achieve. The main limitations are imposed by the inherent intertwining of ferroelectric and dielectric properties, the role of strain, interfaces and electric field-mediated phase, and polarization changes. In this work, using Si-doped HfO2 as a material system, we performed a correlative study with four scanning probe techniques for the local sensing of intrinsic ferroelectricity on the oxide surface. Putting each technique in perspective, we demonstrated that different origins of spatially resolved contrast can be obtained, thus highlighting possible crosstalk not originated by a genuine ferroelectric response. By leveraging the strength of each method, we showed how intrinsic processes in ultrathin dielectrics, i.e., electronic leakage, existence and generation of energy states, charge trapping (de-trapping) phenomena, and electrochemical effects, can influence the sensed response. We then proceeded to initiate hysteresis loops by means of tip-induced spectroscopic cycling (i.e., "wake-up"), thus observing the onset of oxide degradation processes associated with this step. Finally, direct piezoelectric effects were studied using the high pressure resulting from the probe's confinement, noticing the absence of a net time-invariant piezo-generated charge. Our results are critical in providing a general framework of interpretation for multiple nanoscale processes impacting ferroelectricity in doped-hafnia and strategies for sensing it.