In situthermal noise measurements under nanoindentation of suspended graphene.

We demonstrated thermal noise measurement under the nanoindentation of monolayer and bilayer graphene nanodrums. The resonant oscillation of the cantilever excited only by a thermal energy is detectable even in the case of contact with a suspended graphene. The contact resonance fRequency can be obtained in 1 millisecond intervals during the force curve measurement by optimizing the parameters of a real-time spectrum analyzer. The pretension value of the graphene nanodrum is evaluated by the minimum frequency just when the applied force of the cantilever becomes zero. The simultaneous measurement of the force and the resonant frequency with respect to the deformation of the graphene nanodrum enables us to determine the value of InvOLS (inverse optical lever sensitivity) more accurately in each measurement. From the analysis scheme, force curve measurements of the graphene nanodrums with the same diameters show good reproducibility. We also revealed that the effective spring constant of the graphene nanodrums consists of a weak sample-dependent pretension factor and a deformation-dependent factor proportional to the number of graphene layers.

The Effects of a Lateral Wedge Insole on Knee and Ankle Joints During Slope Walking.

The purpose of this study was to determine whether a lateral wedge insole reduces the external knee adduction moment during slope walking. Twenty young, healthy subjects participated in this study. Subjects walked up and down a slope using 2 different insoles: a control flat insole and a 7° lateral wedge insole. A three-dimensional motion analysis system and force plate were used to examine the knee adduction moment, the ankle valgus moment, and the moment arm of the ground reaction force to the knee joint center in the frontal plane. The lateral wedge insole significantly decreased the moment arm of the ground reaction force, resulting in a reduction of the knee adduction moment during slope walking, similar to level walking. The reduction ratio of knee adduction moment by the lateral wedge insole during the early stance of up-slope walking was larger than that of level walking. Conversely, the lateral wedge insole increased the ankle valgus moment during slope walking, especially during the early stance phase of up-slope walking. Clinicians should examine the utilization of a lateral wedge insole for knee osteoarthritis patients who perform inclined walking during daily activity, in consideration of the load on the ankle joint.

Inertial measurement unit-based real-time feedback gait immediately changes gait parameters in older inpatients: a pilot study.

The effect of gait feedback training for older people remains unclear, and such training methods have not been adapted in clinical settings. This study aimed to examine whether inertial measurement unit (IMU)-based real-time feedback gait for older inpatients immediately changes gait parameters. Seven older inpatients (mean age: 76.0 years) performed three types of 60-s gait trials with real-time feedback in each of the following categories: walking spontaneously (no feedback trial); focused on increasing the ankle plantarflexion angle during late stance (ankle trial); and focused on increasing the leg extension angle, which is defined by the location of the ankle joint relative to the hip joint in the sagittal plane, during late stance (leg trial). Tilt angles and accelerations of the pelvis and lower limb segments were measured using seven IMUs in pre- and post-feedback trials. To examine the immediate effects of IMU-based real-time feedback gait, multiple comparisons of the change in gait parameters were conducted. Real-time feedback increased gait speed, but it did not significantly differ in the control (p = 0.176), ankle (p = 0.237), and leg trials (p = 0.398). Step length was significantly increased after the ankle trial (p = 0.043, r = 0.77: large effect size). Regarding changes in gait kinematics, the leg trial increased leg extension angle compared to the no feedback trial (p = 0.048, r = 0.77: large effect size). IMU-based real-time feedback gait changed gait kinematics immediately, and this suggests the feasibility of a clinical application for overground gait training in older people.

Application of High-speed Countercurrent Chromatography for the Purification of High-purity Illudin S from Omphalotus japonicus.

Illudin S from mushroom, such as Omphalotus japonicus and illudens, is a natural sesquiterpene analog with strong anti-tumor and antiviral activities. These illudins compounds are highly effective against various drug-resistant cancers that show extreme cytotoxicity an in vitro assay. However, it is difficult to obtain a sufficient amount of highly pure illudin S from a natural product by simple, efficient and low-cost purification techniques. Here, we offer to apply the high-speed countercurrent chromatography for the preparative purification of illudin S from mushroom extract. For a two-solvent system, the optimal condition of hexane/ethyl acetate/methanol/water (1/5/1/5, v/v/v/v) was optimized to obtain pure illudin S from a crude extract. This purified component was evaluated by liquid chromatography (high-purity >99%) and tandem mass spectrometry. The yield amounts of illudin S (1.3 mg/about 10 g Omphalotus japonicus) at one running are determined by liquid chromatographic calibration. It is concluded that by requiring a natural material and cost-effectiveness, our method represents a significant improvement over complicated techniques for the purification of illudin S from natural materials.

Rapid in situ synthesis of polymer-metal nanocomposite films in several seconds using a CO2 laser.

We demonstrate the rapid in situ synthesis of polymer-metal nanocomposite films using a CO2 laser at 10.6 µm. The mechanism of our method is that the precursor of the metal nanoparticles, i.e., the metallic ions, is very rapidly reduced in the laser-heated polymer matrix without any reducing agent. Unlike other known laser-induced reduction methods using UV lasers, which produce radicals to promote reduction, the CO2 laser energy is mainly absorbed by the glass substrate, and the laser-heated substrate heats the polymer matrix through heat diffusion to promote reduction. The superiority of the use of CO2 lasers over nanosecond visible~UV lasers is also demonstrated in terms of the damage to the film. The developed method can be a new alternative to quickly synthesize a variety of polymer-metal nanocomposite films.