RESUMEN
Dual-comb systems based on two optical frequency combs of slightly different line spacing emerge as powerful tools in spectroscopy and interferometry. Semiconductor lasers have a high impact in continuous-wave tunable laser spectroscopy. Here we demonstrate the first dual-comb interferometer based on a single femtosecond semiconductor laser: a dual-comb modelocked optically pumped external-cavity surface-emitting laser (MIXSEL) ideally suited for a 1 to 10 GHz comb spacing. At a center wavelength of 1.03 µm (9709 cm-1) we measured acetylene gas transmittance with a resolution of 2.7 GHz in 100 ms with residual errors of less than 3% using thousand comb lines without aliasing effects.
RESUMEN
We demonstrate for the first time the calibration of the wavelength scale of high-performance spectrometers using a fully stabilized optical frequency comb from an ultrafast optically pumped semiconductor disk laser (SDL) as a traceable reference. The SDL is a modelocked integrated external-cavity surface-emitting laser (MIXSEL) with the gain and saturable absorber layers fully integrated into one wafer chip, which forms one end mirror of the simple straight cavity with a pulse repetition rate of 11 GHz. This MIXSEL comb is actively stabilized and opens new possibilities for easier and more accurate frequency calibrations of standard laboratory instruments.
RESUMEN
Optically pumped passively modelocked vertical external-cavity surface-emitting lasers (VECSELs) can generate pulses as short as 100 fs with an intracavity semiconductor saturable absorber mirror (SESAM). Very stable soliton modelocking can be obtained, however, the high-Q-cavity, the short gain lifetime, and the kinetic-hole burning can also support rather complex multipulse instabilities which we analyze in more details here. This onset of multipulse operation limits the maximum average output power with fundamental modelocking and occurs at the roll-over of the cavity round trip reflectivity. Unfortunately, such multipulse operation sometimes can mimic stable modelocking when only limited diagnostics are available.
RESUMEN
Optically-pumped SESAM-modelocked semiconductor disk lasers have become interesting ultrafast lasers with gigahertz pulse repetition rates, high average power and adjustable lasing wavelength. It is well established that colliding pulse modelocking (CPM) can generate both shorter pulses and improved stability. These improvements however typically come at the expense of a more complex ring cavity and two output beams. So far similar modelocking results have been obtained with CPM vertical external-cavity surface-emitting lasers (VECSELs) and with SESAM-modelocked VECSELs or modelocked integrated external-cavity surface-emitting lasers (MIXSELs) in a linear cavity. However coherent beam combining of the two output beams of a CPM VECSEL could result in a significantly higher peak power. This is interesting for example for applications in biomedical microscopy and frequency metrology. Here we demonstrate with a more detailed noise analysis that for both output beams of a CPM VECSEL the pulse repetition rates and the carrier envelope offset frequencies are locked to each other. In contrast to standard SESAM-modelocked VECSELs in a linear cavity, we only have been able to actively stabilize the pulse repetition rate of the CPM VECSEL by cavity length control and not by pump-power control. Furthermore, a first coherent beam combining experiment of the two output beams is demonstrated.
RESUMEN
We present the amplification of a mode-locked vertical external-cavity surface-emitting laser (VECSEL) using an Yb:YAG crystalline waveguide as gain medium. The VECSEL seed laser operates at a center wavelength of 1030 nm and generates 300-fs pulses at a repetition rate of 1.77 GHz. An average seed power of 60 mW was launched onto a 8.3 mm long fs-laser written Yb:YAG waveguide pumped by 7.7 W from a 969-nm continuous-wave VECSEL. The amplifier achieves an average output power of up to 2.9 W, corresponding to an amplification factor of 17 dB. Due to gain narrowing, the pulse duration increases to 629 fs. Our results show that crystalline waveguides are a promising technique for the realization of compact multi-watt ultrafast amplifier systems.
RESUMEN
We present the first characterization of the noise properties and modulation response of the carrier-envelope offset (CEO) frequency in a semiconductor modelocked laser. The CEO beat of an optically-pumped vertical external-cavity surface-emitting laser (VECSEL) at 1030 nm was characterized without standard f-to-2f interferometry. Instead, we used an appropriate combination of signals obtained from the modelocked oscillator and an auxiliary continuous-wave laser to extract information about the CEO signal. The estimated linewidth of the free-running CEO beat is approximately 1.5 MHz at 1-s observation time, and the feedback bandwidth to enable a tight CEO phase lock to be achieved in a future stabilization loop is in the order of 300 kHz. We also characterized the amplitude and phase of the pump current to CEO-frequency transfer function, which showed a 3-dB bandwidth of â¼300 kHz for the CEO frequency modulation. This fulfills the estimated required bandwidth and indicates that the first self-referenced phase-stabilization of a modelocked semiconductor laser should be feasible in the near future.
RESUMEN
We use an ultrafast diode-pumped semiconductor disk laser (SDL) to demonstrate several applications in multiphoton microscopy. The ultrafast SDL is based on an optically pumped Vertical External Cavity Surface Emitting Laser (VECSEL) passively mode-locked with a semiconductor saturable absorber mirror (SESAM) and generates 170-fs pulses at a center wavelength of 1027 nm with a repetition rate of 1.63 GHz. We demonstrate the suitability of this laser for structural and functional multiphoton in vivo imaging in both Drosophila larvae and mice for a variety of fluorophores (including mKate2, tdTomato, Texas Red, OGB-1, and R-CaMP1.07) and for endogenous second-harmonic generation in muscle cell sarcomeres. We can demonstrate equivalent signal levels compared to a standard 80-MHz Ti:Sapphire laser when we increase the average power by a factor of 4.5 as predicted by theory. In addition, we compare the bleaching properties of both laser systems in fixed Drosophila larvae and find similar bleaching kinetics despite the large difference in pulse repetition rates. Our results highlight the great potential of ultrafast diode-pumped SDLs for creating a cost-efficient and compact alternative light source compared to standard Ti:Sapphire lasers for multiphoton imaging.