RESUMEN
Fractal dendrites are extensively observed in industry, especially in the electrochemical deposition process. The fractal dendrite electrodeposition behavior of quasi-two-dimensional Cu (Q2D-Cu) metal based on the wire is examined via direct electrodeposition using a thin layer reactor. Here, to explain the fractal growth mechanism, the directional migration and random walking of ions are introduced in the traditional diffusion-limited aggregation model, and fractal patterns consistent with the experimental results are successfully simulated. In addition, the Cu fractal dendrite structure is finely adjusted by varying electrodeposition conditions, demonstrating its great potential for further optimization. The CuO/Q2D-Cu fractal dendrite photothermal device fabricated through in situ assembly of CuO nanowires on Cu fractal dendrite has good photothermal conversion ability. Therefore, metal fractal dendrites, which are considered harmful in the electroplating industry, have application prospects in the photothermal field.
RESUMEN
Solar-driven water evaporation is essential to provide sustainable and ecofriendly sources of fresh water. However, there are still great challenges in preparing materials with broadband light absorption for high photothermal efficiency as well as in designing devices with large evaporation areas and small heat dissipation areas to boost the water evaporation rate. We designed a hanging-mode solar evaporator based on the polyaniline/carbon nanotube (PANI/CNT) fabric, in which the photothermal fabric acts as the solar evaporator and the micropores on the cotton fabric act as the water transfer channels. The hanging mode provides efficient evaporation at both interfaces by greatly reducing the heat dissipation area. The hanging mode PANI/CNT fabric solar evaporator can achieve an evaporation rate of 2.81 kg·m-2·h-1 and a photothermal efficiency of 91.74% under a solar illumination of 1 kW·m-2. This high-performance evaporator is designed by regulating the photothermal material and evaporation device, which provides a novel strategy for sustainable desalination.
RESUMEN
Steroid hormones released from manure agricultural application are a matter of global concern. The residual levels of steroid hormones were studied in a typical intensive vegetable cultivation area in northeast China, with a long history of heavy manure application. Seven steroids (estrone, 17α-estradiol, 17ß-estradiol, estriol, testosterone, androstendione and progesterone) were analyzed from soil sampled from vegetable greenhouses, from sediments and water from the adjacent drainage ditch and from the groundwater. The results showed that target steroids were detected in the soil samples, with detection frequencies varying from 3.13 to 100%. The steroid concentrations varied substantially in soils, ranging from below the detection limit to 109.7µg·kg(-1). Three steroids-progesterone, androstendione and estrone-were found to have relatively high residue concentrations in soil, with maximum concentrations of 109.7, 9.83 and 13.30µg·kg(-1), respectively. In adjacent groundwater, all the steroids, with the exception of estrone, were detected in one or more of the 13 groundwater samples. The concentrations of steroids in groundwater ranged from below the method detection limit to 2.38ng·L(-1). Six of the seven (excluding androstendione) were detected in drainage ditch water samples, with concentrations ranging from below the detection limit to 14ng·L(-1). Progesterone, androstendione and estrone accumulated relatively easily in soils; their concentrations in groundwater were lower than those of other steroids. The concentrations of testosterone and estriol were relatively low in soil, while in groundwater were higher than those of other steroids. The residual levels of steroids in soil and groundwater showed a clear spatial variation in the study area. The residual levels of steroid hormones in soil varied substantially between differently planted greenhouses.