Aspirin and omega-3 polyunsaturated fatty acid use and their interaction in cardiovascular diseases and colorectal adenomas.

Aspirin (acetylsalicylic acid, ASA) is inexpensive and is established in preventing cardiovascular disease (CVD) and colorectal adenomas. Omega-3 (n3) polyunsaturated fatty acids (PUFA), eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA) have also shown benefit in preventing CVD. The combination could be an effective preventative measure in patients with such diseases. ASA and n3 PUFA reduced the risk of CVD in ASA-resistant or diabetic patients. EPA- and DHA-deficient patients also benefited the most from n3 PUFA supplementation. Synergistic effects between ASA and EPA and DHA are 'V-shaped' such that optimal ASA efficacy is dependent on EPA and DHA concentrations in blood. In colorectal adenomas, ASA (300 mg/d) and EPA reduced adenoma burden in a location- and subtype-specific manner. Low doses of ASA (75-100 mg/d) were used in CVD prevention; however, ultra-low doses (30 mg/d) can also reduce thrombosis. EPA-to-DHA ratio is also important with regard to efficacy. DHA is more effective in reducing blood pressure and modulating systemic inflammation; however, high-dose EPA can lower CVD events in high-risk individuals. Although current literature has yet to examine ASA and DHA in preventing CVD, such combination warrants further investigation. To increase adherence to ASA and n3 PUFA supplementation, combination dosage form may be required to improve outcomes.

Improved purification of cyclotron [68Ga]GaCl3 for the production of 68Ga radiopharmaceuticals.

INTRODUCTION: Increased demand for NetSpot and Illuccix as requirement to receive the respective Lutathera and Pluvicto radiotherapies, and monitor subsequent response to treatment, have reinforced the need to develop alternative ways of producing gallium-68 (68Ga). Building on our efforts to produce 68Ga in a liquid target on a GE PETtrace, the goal of this work is to modify the current GE Gallium Chloride cassette using the FASTLab 2 synthesis module to produce [68Ga]GaCl3 equivalent to a 1.85 GBq generator and demonstrate compatibility with FDA-approved kits for production of 68Ga-labeled radiopharmaceuticals. METHODS: 68Ga was produced in a liquid target via the 68Zn(p,n)68Ga reaction. 68Ga was loaded onto various sizes of ZR resins (ZR Load, 0.3 mL, 1 mL, or 2 mL). The loading efficiency was determined using a dose calibrator. After washing with HNO3, 1.75 M HCl was used to elute the ZR Load resin through various sizes of a second ZR resin (ZR CG, 0 mL, 2 mL, 4 mL). Using 0.5 mL fractions, the elution profile was determined. Compatibility of the [68Ga]GaCl3 with NetSpot and Illuccix kits was investigated. Radiochemical purity (RCP) and 4 h stability were determined using radioTLC and radioHPLC. Using a modified [68Ga]GaCl3 cassette and new FASTLab program, 6 validation preparations were conducted using NetSpot and Illuccix kits for which RCP, stability, sterility and suitability were determined. Dual irradiation of 2 liquid targets was also performed, which was used to simultaneously prepare 1 NetSpot and 2 Illuccix kits by diluting the required activity with 0.1 M HCl. RESULTS: The commercially available GE Cassette gave low RCP using commercial FDA kits. To optimize this, the loading efficiency onto ZR Load and the ratio of ZR resin used to load the initial activity and subsequent elution were explored. When using a 2:4 ratio of ZR Load to ZR CG, 97.89 % RCP was observed when a 3.8 mL [68Ga]GaCl3 solution was used. For Dotatate validation, 0.55 mL of buffer was added to 4.2 mL of [68Ga]GaCl3 which gave 1.35 GBq of formulated product. For Illuccix validation, [68Ga]GaCl3 was added to 2.5 mL of buffer which gave 1.52 GBq of [68Ga]Ga-PSMA-11. Formulated products passed package insert quality control (QC) requirements. When dual target irradiations were performed, 2.84 GBq was delivered to an external vial and used to label 1 NetSpot and 2 Illuccix kits simultaneously, and each kit also met or exceeded established QC criteria. CONCLUSION: Methods are reported for using cyclotron-produced 68Ga from a liquid target in conjunction with FDA-approved NetSpot and Illucix kits. By employing a 2 mL ZR Load resin with a 4 mL ZR CG resin, adequate resolution between residual 68Zn and desired 68Ga was achieved. By modifying the FASTLab procedure to retain the final 2.5 mL of eluate from the ZR CG resin, [68Ga]GaCl3 equivalent to a new 1.85 GBq generator was obtained. This was suitable for labeling NetSpot and Illucix kits, resulting in high incorporation of 68Ga (RCP >95 %), which has not previously been demonstrated. Delivering [68Ga]GaCl3 into an external vial and diluting with 0.1 M HCl makes it possible to prepare multiple kits simultaneously. These new procedures should facilitate use of cyclotron-produced [68Ga]GaCl3 for clinical production going.

Diagnostic Approaches for COVID-19 and Its Associated Complications.

With almost 4 million deaths worldwide from the COVID-19 pandemic, the efficient and accurate diagnosis and identification of COVID-19-related complications are more important than ever. Scales such as the pneumonia severity index, or CURB-65, help doctors determine who should be admitted to the hospital or the intensive care unit. To properly treat and manage admitted patients, standardized sampling protocols and methods are required for COVID-19 patients. Using PubMed, relevant articles since March 2020 on COVID-19 diagnosis and its complications were analyzed. Patients with COVID-19 had elevated D-dimer, thrombomodulin, and initial factor V elevation followed by decreased factor V and factor VII and elevated IL-6, lactate dehydrogenase, and c-reactive protein, which indicated coagulopathy and possible cytokine storm. Patients with hypertension, newly diagnosed diabetes, obesity, or advanced age were at increased risk for mortality. Elevated BUN, AST, and ALT in severe COVID-19 patients was associated with acute kidney injury or other organ damage. The gold standard for screening COVID-19 is reverse transcriptase polymerase chain reaction (RT-PCR) using sputum, oropharyngeal, or nasopharyngeal routes. However, due to the low turnover rate and limited testing capacity of RT-PCR, alternative diagnostic tools such as CT-scan and serological testing (IgM and IgG) can be considered in conjunction with symptom monitoring. Advancements in CRISPR technology have also allowed the use of alternative COVID-19 testing, but unfortunately, these technologies are still under FDA review and cannot be used in patients. Nonetheless, increased turnover rates and testing capacity allow for a bright future in COVID-19 diagnosis.