Immobilization of nanobeads on a surface to control the size, shape and distribution of pores in electrochemically generated sol-gel films.

Electrochemically assisted deposition of an ormosil film at a potential where hydrogen ion is generated as the catalyst yields insulating films on electrodes. When the base electrode is modified with 20-nm poly(styrene sulfonate), PSS, beads bound to the surface with 3-aminopropyltriethoxysilane (APTES) and using (CH3)3SiOCH3 as the precursor, the resulting film of organically modified silica (ormosil) has cylindrical channels that reflect both the diameter of the PSS and the distribution of the APTES-PSS on the electrode. At an electrode modified by a 20-min immersion in 0.5 mmol dm-3 APTES followed by a 30-s immersion in PSS, a 20-min electrolysis at 1.5 V in acidified (CH3)3SiOCH3 resulted in an ormosil film with 20-nm pores separated by 100 nm. Cyclic voltammetry of Ru(CN)64- at scan rates above 5 mVs-1 yielded currents controlled primarily by linear diffusion. Below 5 mVs-1, convection rather than the expected factor, radial diffusion, apparently limited the current.

Distribution of Elements in Durum Wheat Seed and Milling Products: Discrimination between Cultivation Methods through Multivariate Data Analysis.

Many staple foods originate from durum wheat and its milling products; because of this, it is very important to know their characteristics. This study investigates elemental contents in these products and if differences exist because of organic farming. The concentrations of 28 elements in the whole seed and in milling products, that is, bran, semolina and flour, of durum wheat, were determined through ICP-OES. The wheats were grown under conventional or organic agronomic practices to verify the possibility of discriminating, using the elemental content, between products coming from one or the other practice. The elements were more abundant in the outer layer of the seed, the bran, but most of them were also present in the others. Traces of Sb were present only in 3% of the samples, while traces of Tl were detected in approximately half of the seed and bran samples but not in other samples. The absence of an element was more characteristic of specific products, e.g., most semolina and flour lacked Co, while other elements showed small differences between products from organic and conventional cultivation or between different milling products, which was the case, for example, for traces of Ag, B, and V. The concentrations of these elements were coupled with multivariate discriminant analysis, specifically PLS-DA, to identify the cultivation provenance of the milled products. A few elements, although different for each product, are sufficient to attain precision and accuracy of classification close to 1; small differences exist for different products. The worst is flour, where the predicted precision and accuracy are 0.92, although using only three elements: B, K, and Se. Semolina attains perfect prediction when also adding to the three previous elements, Ag, Cd, and Cu. Further elements are necessary for bran, while Fe and Mg replace K and Ag to classify seeds. In conclusion, five elements, B, Cd, Cu, K, and Se, are the most important in distinguishing between organic and conventional agriculture; these elements also permit some differentiation among products. The method could help in fraud prevention.

ON-SITE monitoring OF BVOCS emission in Tremiti island, Italy.

A measurement campaign was conducted on San Domino Island, part of the Tremiti Islands archipelago, located in Foggia, Italy. The area is almost entirely covered by vegetation, dominated by the following main species: Juniperus turbinata, Helichrysum italicum, Myrtus communis, Rosmarinus officinalis, Pistacia lentiscus and Pinus halepensis.This study focused on the BVOCs emitted by plants and the ground, employing a simple, economical, and efficient sampling and analysis method. The main known BVOC species emitted by Mediterranean plant species as α-pinene, ß-pinene, camphene and limonene were detected. The measurements highlighted a daily complementarity between plant and soil emissions. The daily variations in BVOCs emitted by both plants and the soil are differ, ensuring an almost constant concentration throughout the day. At the same time, the composition of sea spray aerosol (SSA) was also measured. The measurement sites were selected based on botanical characterization to account for the predominant species on San Domino Island, and the sampling was conducted at human height to accurately identify the species for potential use. The combination of beneficial effects of the substances emitted by plant species and soil, along with the simultaneous presence of SSA, are factors that could enhance the effectiveness of forest therapy in a previously unexplored location.

Multivariate curve resolution analysis for interpretation of dynamic Cu K-edge X-ray absorption spectroscopy spectra for a Cu doped V(2)O(5) lithium battery.

Vanadium pentoxide materials prepared through sol-gel processes act as excellent intercalation hosts for lithium as well as polyvalent cations. A chemometric approach has been applied to study the X-ray absorption near-edge structure (XANES) evolution during in situ scanning of the Cu(0.1)V(2)O(5) xerogel/Li ions battery. Among the more common techniques, the fixed size windows evolving factor analysis (FSWEFA) permits the number of species involved in the experiment to be determined and the range of existence of each of them. This result, combined with the constraints of the invariance of the total concentration and non-negativity of both concentrations and spectra, enabled us to obtain the spectra of the pure components using a multivariate curve resolution refined by an alternate least squares fitting procedure. This allowed the normalized concentration profile to be understood. This data treatment evidenced the occurrence, for the first time, of three species during the battery charging. This fact finds confirmation by comparison of the pure spectra with the experimental ones. Extended X-ray absorption fine structure (EXAFS) analysis confirms the occurrence of three different chemical environments of Cu during battery charging.

Deconvolution of UV-VIS spectroelectrochemical thin-layer data for an EE electrochemical process.

A deconvolution method, based on Fixed Size Window Evolving Factor Analysis (FSWEFA) has been developed to analyse the spectroelectrochemical sequence of spectra obtained in OTTLE electrodes for EE electrochemical processes. The analysis of the data permits to reconstruct the concentration profiles, the spectra of the intermediates and an optical analogue of the i vs E curve.

Oxidation and flow-injection amperometric determination of 5-hydroxytryptophan at an electrode modified by electrochemically assisted deposition of a sol-gel film with templated nanoscale pores.

The oxidation of 5-hydroxytryptophan (5-HTPP) yielded a passivating polymeric film at an indium tin oxide (ITO) electrode. Coating ITO with a nanoscale sol-gel film with a mesoporous structure was shown to change the pathway of the chemical reaction coupled to the electron transfer. The sol-gel film was deposited by an electrochemically assisted process, and the mesoporosity was imparted by including generation-4 poly(amidoamine) dendrimer in the precursor solution. The dendrimer was removed subsequently with an atmospheric oxygen plasma. This electrode remained active during cyclic voltammetry and controlled potential electrolysis of 5-HTPP, which was attributed to dimer, rather than polymer, formation from the oxidation product. Mass spectrometry confirmed this hypothesis. The anodic current was limited by the electron-transfer kinetics. Modification of the sol-gel film by inclusion of cobalt hexacyanoferrate, which catalyzes the oxidation, resulted in a diffusion-limited current. Determination of 5-HTPP by flow-injection amperometry had a detection limit of 17nM.