RESUMEN
The dynamics of photoinduced electron transfer were measured at dye-sensitized photoanodes in aqueous (acetate buffer), nonaqueous (acetonitrile), and mixed solvent electrolytes by nanosecond transient absorption spectroscopy (TAS) and ultrafast optical-pump terahertz-probe spectroscopy (OPTP). Higher injection efficiencies were found in mixed solvent electrolytes for dye-sensitized SnO2/TiO2 core/shell electrodes, whereas the injection efficiency of dye-sensitized TiO2 electrodes decreased with the increasing acetonitrile concentration. The trend in injection efficiency for the TiO2 electrodes was consistent with the solvent-dependent trend in the semiconductor flat band potential. Photoinduced electron injection in core/shell electrodes has been understood as a two-step process involving ultrafast electron trapping in the TiO2 shell followed by slower electron transfer to the SnO2 core. The driving force for shell-to-core electron transfer increases as the flat band potential of TiO2 shifts negatively with increasing concentrations of acetonitrile. In acetonitrile-rich electrolytes, electron injection is suppressed due to the very negative flat band potential of the TiO2 shell. Interestingly, a net negative photoconductivity in the SnO2 core is observed in mixed solvent electrolytes by OPTP. We hypothesize that an electric field is formed across the TiO2 shell from the oxidized dye molecules after injection. Conduction band electrons in SnO2 are trapped at the core/shell interface by the electric field, resulting in a negative photoconductivity transient. The overall electron injection efficiency of the dye-sensitized SnO2/TiO2 core/shell photoanodes is optimized in mixed solvents. The ultrafast transient conductivity data illustrate the crucial role of the electrolyte in regulating the driving forces for electron injection and charge separation at dye-sensitized semiconductor interfaces.
RESUMEN
The efficient conversion of electricity to chemicals is needed to mitigate the intermittency of renewable energy sources. Driving these electrochemical conversions at useful rates requires not only fast electrode kinetics, but also rapid mass and ion transport. However, little is known about the effect of local environments on ionic flows in solid polymer electrolytes. Here, we show that it is possible to measure and manipulate the local pH in membrane electrolysers with a resolution of tens of nanometres. In bipolar-membrane-based gas-fed CO2 electrolysers, the acidic environment of the cation exchange layer results in low CO2 reduction efficiency. By using ratiometric indicators and layer-by-layer polyelectrolyte assembly, the local pH was measured and controlled within an ~50-nm-thick weak-acid layer. The weak-acid layer suppressed the competing hydrogen evolution reaction without affecting CO2 reduction. This method of probing and controlling the local membrane environment may be useful in devices such as electrolysers, fuel cells and flow batteries, as well as in operando studies of ion distributions within polymer electrolytes.