Electrothermal Desolvation-Enhanced Dielectric Barrier Discharge Plasma-Induced Vapor Generation for Sensitive Determination of Antimony by Atomic Fluorescence Spectrometry.

A novel simple electrothermal desolvation-enhanced dielectric barrier discharge plasma-induced vapor generation (ETD-DBD-PIVG) method has been developed for sensitive Sb determination by atomic fluorescence spectrometry (AFS). In our proposed ETD-DBD-PIVG, 20 µL sample solution was dried first; then, the resulting solution residue was directly converted into molecular volatile species efficiently through the interactions with hydrogen-doped DBD plasma; and finally, it was transported to AFS for detection. It was found that the desolvation process could greatly enhance Sb vapor generation, and the Sb fluorescence signal intensity is almost independent of its speciation, where comparable sensitivity is achieved for Sb(III) and Sb(V), enabling efficient total Sb detection without pre-reduction. Influencing parameters were evaluated in detail, including heating time, discharge gap, solution pH, and flow rates of argon and hydrogen, as well as coexisting ion interference. Under optimized conditions, the limit of detection was calculated as 0.86 µg L-1 (17.2 pg) for Sb. The accuracy of the proposed method was validated by the analysis of certified reference materials of simulated natural water samples and several river water samples. Compared with conventional hydride generation, the new ETD-DBD-PIVG offers an alternative green vapor generation technique with several advantages: (1) it eliminates the use of a sample flow system (e.g., no use of any syringe or peristaltic pump); instead, 20 µL of a sample is directly pipetted onto the glass plate for analysis; (2) it greatly simplifies the sample pretreatment steps as no pre-reduction process is needed; (3) it is sensitive and suitable for volume-limited sample analysis: efficient Sb vapor generation without chemical reducing reagents in ETD-DBD-PIVG enables Sb detection with an absolute limit at the picogram level. All the results demonstrate that the proposed method provides a simple, green, and sensitive method for Sb determination and it can also be extended to other elements such as Cd and As.

Direct and Sensitive Determination of Antimony in Water by Hydrogen-Doped Solution Anode Glow Discharge-Optical Emission Spectrometry Without Hydride Generation.

In the present work, a novel, simple, and sensitive method for the direct determination of trace Sb in water samples was developed based on hydrogen-doped solution anode glow discharge-optical emission spectrometry (SAGD-OES). It was found that the vapor generation and excitation of Sb occurred simultaneously in the SAGD, contributing to the significant improvement in the sensitivity of Sb as compared with normal pure He-operated SAGD or solution cathode glow discharge. Besides, the proposed hydrogen-doped SAGD-OES could be operated even at pH = 14, which could reduce the interference of coexisting ions as many metal ions could be precipitated and removed. Our results demonstrated that the proposed method offered good tolerance to the interferences of Li, Na, Ca, Mg, Fe, Ni, Mn, and Zn ions even at a concentration of 50 mg L-1. Under optimized conditions, the limit of detection of Sb was 0.85 µg L-1, which was comparable to that of microplasma sources coupled with conventional hydride generation. The linearity of the Sb calibration curve reached R2 > 0.999 in the 5-5000 µg L-1 range. Finally, the accuracy of the proposed method was validated by the determination of certified reference materials [GSB 07-1376-2001 (1) and (2))] and real water samples. The proposed low-power (6 W), green, sensitive, rapid, and robust method provides a promising approach for on-site trace Sb analysis and may also be extended to other elements.

Development of an Automatic Column Chromatography Separation Device for Metal Isotope Analysis Based on Droplet Counting.

A novel, simple, cost-effective, reliable, and practical automatic column chromatography separation device capable of simultaneously purifying samples for radiogenic and non-traditional stable isotope analysis has been developed. The device avoids the use of any pump and features eluent driving by the siphon effect (gravity) and quantitative control by infrared droplet counting. Several factors affecting the control of droplets were investigated, including types and concentrations of eluents and the height of the liquid level. Results showed that accurate dripping of the eluent could be readily achieved by controlling the number of droplets under selected conditions. The separation performance of the device was first demonstrated by the elution of Sr and Cd in synthetic matrix solutions. The recoveries of Sr and Cd samples were better than 87.6 and 95.0%, respectively, and the whole procedure blank was about 0.3 ng for Sr and 0.1 ng for Cd. Finally, the reliability of the device was further validated by the purification of Sr and Cd from different geological reference materials (NIST 2711a, Nod-A-1, BCR-2, and BHVO-2). The determined Cd and Sr isotope values agree well with their reference values within the uncertainty range. All these results clearly demonstrate the reliability and practicability of the proposed device, which provides a promising method for the automated purification of isotope samples.

Development of a Portable Method for Serum Lithium Measurement Based on Low-Cost Miniaturized Ultrasonic Nebulization Coupled with Atmospheric-Pressure Air-Sustained Discharge.

An accurate, rapid but cheap, and portable method for monitoring of serum lithium (Li) is highly desirable for mental patients who take Li medicine for treatment. Conventional techniques are usually bulky, costly, and cannot provide on-site real-time measurements. Herein, a miniaturized, reliable, cost-effective, and portable optical emission method for rapid and sensitive determination of serum Li was developed based on a combination of miniaturized ultrasonic nebulization (MUN) and a low-power (≈22 W) atmospheric-pressure air-sustained discharge (APAD) excitation source. The proposed method eliminates the use of any compressed gas or pump and can achieve serum Li detection within 40 s with low sample consumption (less than 20 µL serum). Except for dilution with water, no extra treatment is needed for serum Li analysis by MUN-APAD-OES. In addition, it offers a significant advantage of good tolerance to the coexisting high concentration of Na, K, Ca, and Mg, which is in contrast with the obvious matrix effect encountered in conventional inductively coupled plasma optical emission spectrometry (ICP-OES). Different operating parameters affecting the performance of MUN-APAD-OES were evaluated. Under optimized conditions, the detection limit of Li (670.8 nm) was calculated to be 0.6 µg L-1 (6 µg L-1 in serum). Finally, the accuracy of the proposed method was validated by the analysis of two certified reference materials (Seronorm serum L-1 and L-2 RUO), six real human serum samples, and eight real animal serum samples. All of the results indicate that the low-cost and low-power MUN-APAD-OES provides a promising reliable method for on-site serum Li measurement and may also be extended to other elements.

One-step separation of Cu, Fe, Zn and Cd and isotope ratio analysis by MC-ICP-MS for geological samples.

Multi-isotope systems have shown great application potential in tracing geological and environmental processes. In order to obtain the isotopic composition of multiple elements of interest, the common protocol is to separate each element from the matrix by independent procedures, which has some limitations, including poor efficiency, being time-consuming, requiring large samples and being unsuitable for rare samples (e.g., meteorite, lunar soil and atmospheric aerosol samples). In this study, we present an integrated and optimized one-step method to separate Cu, Fe, Zn and Cd from complex matrix elements using the AG MP-1M anion exchange resin. By experimentally optimizing the resin volume, eluent concentration and eluent amount, these target elements can be effectively separated from the matrix elements, such as Cu separation from Ti and Co, Zn separation from Fe and Cd, and Cd separation from Sn. The recoveries of Cu, Fe, Zn and Cd were 100.1 ± 0.8% (2SD, n = 3), 99.8 ± 0.7% (2SD, n = 3), 100 ± 0.8% (2SD, n = 3) and 99 ± 1% (2SD, n = 3), respectively. Moreover, the resolution (R) between the elements of interest and interfering elements was in the range of 1.8-28.1. The process blanks of Cu, Fe, Zn and Cd were 1-1.6 ng, 62-70 ng, 2.1-3 ng and 66-74 pg, respectively. The obtained isotope ratios for the standard reference materials agreed well with the published values. Meanwhile, we have reported the Cu, Fe and Zn isotope ratios of six soil and sediment standard reference materials, namely NIST 2711a, GSS-1, GSD-5a, GSD-7a, GSD-12 and GSD-23, for the first time. These new data can be used for the intercalibration and quality control of soils and sediments in other laboratories. The one-step separation of Cu, Fe, Zn and Cd shows obvious economic and efficiency advantages, making it suitable for the simultaneous separation of multiple elements of interest in geological samples.

Stable isotope fractionation of cadmium in the soil-rice-human continuum.

Consumption of rice (Oryza sativa) grain is a major pathway by which humans are exposed to Cd, especially in non-smoking Asian populations. Although the stable isotope signatures of Cd offer a potential tool for tracing its sources, little is known about the isotopic fractionation of Cd across the entire soil-rice-human continuum. Cadmium isotope ratios were determined in field soils, rice grain, and human urine collected from two Cd-contaminated regions in southern China. Additionally, Cd isotopic fractionation in rice plants was investigated using two transgenic plants differing in Cd uptake and accumulation. Analysis of isotope ratios revealed a preferential enrichment of the heavy Cd isotopes from soil to rice grain (δ114/110Cdgrain-soil = +0.40‰) and from grain to urine (δ114/110Cdurine-grain = +0.40‰) in both regions. The first increase was mainly caused by partitioning between the soil solid phase and the soil solution, with heavier Cd preferentially enriching in the soil solution. Within the rice plant, we identified multiple processes that alter the isotope ratio, but the net effect throughout the plant was comparatively small. Cd fractionation in humans is presumably due to the preferential enrichment of heavier Cd isotopes by metal transporters DMT1 and ZIP8 (responsible for the absorption of Cd into body from the foods). These findings provide important insights into the Cd isotopic fractionation through the soil-rice-human continuum and are helpful for tracing the sources of Cd.

Efficacy and Safety of Laser Surgery and Transurethral Resection of the Prostate for Treating Benign Prostate Hyperplasia: a Network Meta-analysis.

BACKGROUND: Traditional meta-analyses or systematic reviews of randomized controlled trials (RCTs) have been used to compare laser surgeries and transurethral resection of the prostate (TURP) for benign prostate hyperplasia (BHP), but they cannot provide a hierarchy regarding efficacy and safety of treatment. OBJECTIVE: We therefore performed a network meta-analysis (NMA) to compare and create hierarchies for efficacy and safety of TUPR and laser surgeries for BPH. MATERIALS AND METHODS: We searched for reports of RCTs published up to April 25, 2015. After methodological quality assessment and data extraction, we performed an NMA to compare TURP and laser surgeries for BPH. RESULTS: We ranked the treatments of TURP and laser surgeries for BPH. For IPSS at 6 months, holmium laser resection of the prostate (HoLRP) ranked the first-best and at 12 months, holmium laser enucleation of the prostate (HoLEP). For Qmax at 6 and 12 months, HoLEP ranked the first-best; for operative time it was TURP; for cathedral removal time, diode laser enucleation of the prostate (DiLEP) ranked the first-best. CONCLUSIONS: Although TURP is considered the gold standard for treating BPH, it is not better in terms of efficacy and safety compared with the laser surgery. Our NMA created hierarchies for the 9 types of surgery in terms of efficacy and safety, which should help clinicians choose the best approach for the individual patient.

Vitamin B2 intake and the risk of colorectal cancer: a meta-analysis of observational studies.

BACKGROUND: A systematic review and meta-analysis of observational studies evaluated the association of intake of vitamin B2 with the incidence of colorectal cancer. MATERIALS AND METHODS: Relevant studies were identified in MEDLINE via PubMed (published up to April 2014). We extracted data from articles on vitamin B2 and used multivariable-adjusted odds ratio (OR) and a random-effects model for analysis. RESULTS: We found 8 articles meeting the inclusion criteria (4 of cohort studies and 4 of case-control studies) and a total of 7,750 colorectal cancer cases were included in this meta-analysis. The multivariable-adjusted OR for pooled studies for the association of the highest versus lowest vitamin B2 intake and the risk of colorectal cancer was 0.83 (95% confidence interval [95%CI]:0.75,0.91). We performed a sensitivity analysis for vitamin B2. If we omitted the study by Vecchia et al., the pooled OR was 0.86 (95%CI, 0.77,0.96). CONCLUSIONS: This is the first meta-analysis to study links between vitamin B2 and colorectal cancer. We found vitamin B2 intake was inversely associated with risk of colorectal cancer. However, further research and large sample studies need to be conducted to better validate the result.

Efficacy and safety of Trastuzumab added to standard treatments for HER2-positive metastatic breast cancer patients.

INTRODUCTION: Trastuzumab, an HER2-targeting agents, has shown efficacy in metastatic HER2-positive breast cancer patients. Single-agent clinical trials have evaluated therapeutic regimens using trastuzumab for metastatic breast cancer patients. The aim of our study is to evaluate the efficacy and safety of trastuzumab in combination with chemotherapy or hormone therapy in HER2-positive metastatic breast cancer patients. METHODS: A literature research was conducted in PubMed and to identify appropriate studies from relevant reviews. Randomized controlled trials comparing chemotherapy or hormone therapy regimens in combination with trastuzumab were eligible. Dadta on clinical outcomes, including safety, efficacy, and patient characteristics were collected. RESULTS: Seven articles describing five trials were included in our systematic review and meta- analysis. Partners of trastuzumab included in trials were anthracycline, paclitaxel, docetaxel, anastrozole and letrozole. The addition of trastuzumab to chemotherapy improved the overall survival (HR=0.79, 95%CI 0.65- 0.96), while to hormone therapy did not (HR=0.85 95%CI 0.56-1.30). All trastuzumab-containing regimens increased cardiac toxicity (RR=3.37, 95%CI 1.26-9.02) and grade III-IV adverse events. CONCLUSIONS: Our study supports the addition of trastuzumab to chemotherapy which is effective and tolerated for metastatic breast cancer with HER2+ patients. Of note, more adverse events will occur followed the use of trastuzumab, especially cardiac toxicity, with two treatment regimens.