The Impact of Simulated Gastric Acid and Toothbrushing on Surface Characteristics of Resin-Modified Glass-Ionomer Cements.

Background and Objectives: The aim of this in vitro study was to evaluate the effect of simulated gastric acid associated with toothbrushing on the surface condition of three resin-modified glass-ionomer cements (RMGIC). Materials and Methods: One hundred and sixty samples of each material were obtained and included in three study groups according to the tested material: Group I (Ionolux, VOCO GmbH, Cuxhaven, Germany); Group II (Vitremer, 3 M-ESPE, St. Paul, MN, USA); and Group III (Fuji II LC, GC Corporation, Tokyo, Japan). The samples were submersed in hydrochloric acid 0.01 M (pH 3.8) for 3 h and exposed to a toothbrushing procedure at a frequency of 10,000 cycles with medium and hard bristles immediately or 30 min after the acid attack. Profilometric measurements were performed by using a non-contact profilometer (Dektak XT, Bruker, Billerica, MA, USA) in order to assess the surface roughness. ANOVA and Bonferroni post hoc tests were used for the statistical analysis at a significance level of p < 0.05. Results: Exposure of RMGICs to the erosive effect of hydrochloric acid in association with toothbrushing 30 min after the chemical attack increased the surface roughness of all three RMGICs. Exposure of the three tested materials exclusively to the action of hydrochloric acid did not affect the surface roughness. Conclusions: One year of hydrochloric acid challenge associated with one year of toothbrushing with medium-hardness bristles performed 30 min after the acid attack increase the surface roughness of two of the three types of RMGIC tested (Ionolux and Fuji II LC).

In Vitro Evaluation of Gastric Acid and Toothbrushing Effect on the Surface State of Different Types of Composite Resins.

Background and Objectives: The aim of this in vitro study was to evaluate the effect of gastric acid associated with the effect of toothbrushing on the surface roughness of different types of composite resin used for direct restorations. Materials and Methods: The materials used in this study were two microhybrid (Filtek Z250, Herculite XRV) and two nanohybrid (Filtek Z550, Herculite XRV Ultra) composite resins. Two hundred and forty cylindrical samples with a height of 2 mm and a diameter of 6 mm were divided into four groups (groups A, B, C and D) corresponding to each tested material (n = 60). Each group was divided in two subgroups: subgroup I-the samples were submersed in hydrochloric acid and immediately submitted to toothbrushing; subgroup II-the samples were submitted only to toothbrushing. The simulation of the acid attack was performed by immersing the samples in a 0.01 M hydrochloric acid solution for 90 min. This procedure was followed immediately by toothbrushing simulation with 10,000 cycles. The acid attack and toothbrushing simulation were performed for two times. The surface roughness evaluation was performed with a Proscan 2100 profilometer. Repeated Measures ANOVA and Bonferroni post-hoc tests were used to perform the statistical analysis. Results: Simulation of one year of toothbrushing associated or not to hydrochloric acid exposure increases the surface roughness of microhybrid and nanohybrid composite resins. Six months of toothbrushing associated to six months of hydrochloric acid exposure increase the surface roughness of nanohybrid composite resins. Conclusions: Microhybrid composite resins surface becomes rougher after toothbrush and acid submersion when comparing to nanohybrid composite resins.

External-beam radiation therapy combined with limb-sparing surgery in elderly patients (>70 years) with primary soft tissue sarcomas of the extremities : A retrospective analysis.

PURPOSE: To report our experience with EBRT combined with limb-sparing surgery in elderly patients (>70 years) with primary extremity soft tissue sarcomas (STS). METHODS: Retrospectively analyzed were 35 patients (m:f 18:17, median 78 years) who all presented in primary situation without nodal/distant metastases (Charlson score 0/1 in 18 patients; ≥2 in 17 patients). Median tumor size was 10 cm, mainly located in lower limb (83%). Stage at presentation (UICC7th) was Ib:3%, 2a:20%, 2b:20%, and 3:57%. Most lesions were high grade (97%), predominantly leiomyosarcoma (26%) and undifferentiated pleomorphic/malignant fibrous histiocytoma (23%). Limb-sparing surgery was preceded (median 50 Gy) or followed (median 66 Gy) by EBRT. RESULTS: Median follow-up was 37 months (range 1-128 months). Margins were free in 26 patients (74%) and microscopically positive in 9 (26%). Actuarial 3­ and 5­year local control rates were 88 and 81% (4 local recurrences). Corresponding rates for distant control, disease-specific survival, and overall survival were 57/52%, 76/60%, and 72/41%. The 30-day mortality was 0%. Severe postoperative complications were scored in 8 patients (23%). Severe acute radiation-related toxicity was observed in 2 patients (6%). Patients with Charlson score ≥2 had a significantly increased risk for severe postoperative complications and acute radiation-related side effects. Severe late toxicities were found in 7 patients (20%), including fractures in 3 (8.6%). Final limb preservation rate was 97%. CONCLUSION: Combination of EBRT and limb-sparing surgery is feasible in elderly patients with acceptable toxicities and encouraging but slightly inferior outcome compared to younger patients. Comorbidity correlated with postoperative complications and acute toxicities. Late fracture risk seems slightly increased.

Influence of the Loading with Newly Green Silver Nanoparticles Synthesized Using Equisetum sylvaticum on the Antibacterial Activity and Surface Hardness of a Composite Resin.

The aim of the study was to evaluate the antibacterial activity and surface hardness of a light-activated microhybrid composite resin modified with green silver nanoparticles (AgNPs). AgNPs were synthesized using an Equisetum sylvaticum extract and characterized through different methods such as UV-Vis, EDX, and FTIR. The obtained AgNPs were mixed with a microhybrid composite resin (Herculite XRV, Kerr Corp., Orange, CA, USA) in different concentrations: 0% (group A-control); 0.5% (group B); 1% (group C); and 1.5% (group D). A total of 120 composite resin disk-shaped samples were obtained and divided into 4 groups (n = 30) according to AgNP concentration. Each group was then divided into 2 subgroups: subgroup 1-samples were not soaked in 0.01 M NaOH solution; and subgroup 2-samples were soaked in 0.01 M NaOH solution. The antibacterial activity against Streptococcus mutans was determined using a direct contact test. A digital electronic hardness tester was used to determine the composite resin's Vickers surface hardness (VH). Statistical analysis was performed using the Mann-Whitney U and Kruskal-Wallis nonparametric tests with a confidence level of 95%. Groups C and D showed higher antibacterial activity against S. mutans when compared to the control group (p < 0.05). No significant differences were recorded between VH values (p > 0.05). The use of AgNPs synthesized from Equisetum sylvaticum as a composite resin filler in 1% wt. and 1.5% wt. reduced the activity of Streptococcus mutans. Soaking of the experimental composite resin decreased the antibacterial efficacy. The loading of a microhybrid composite resin with AgNPs in concentrations of 0.5% wt., 1% wt., and 1.5% wt. did not influence the surface hardness.

Evaluation of the Surface Roughness of Bulk-Fill Composite Resins after Submission to Acidic and Abrasive Aggressions.

This in vitro study aimed to assess the erosive effect of hydrochloric acid in association with toothbrushing procedure on the surface condition of three bulk-fill composite resins used for direct restoration. A total of 480 samples (160 from each composite resin): X-tra Fil (VOCO, Germany)­group A, Filtek Bulk-fill Posterior (3M-ESPE, St. Paul, MN, USA)­group B, G-aenial Posterior (GC Japan)­group C were prepared, submitted to chemical attack for 60 min with hydrochloric acid 30% and, subsequently, submitted to the abrasive effect of toothbrushing using 10,000 cycles with medium and hard bristles, at three different times (immediately and after 30 min after acid attack or without any chemical attack). The surface roughness of the samples was measured using a noncontact profilometer (Dektak XT, Bruker, Billerica, MA, USA). The values were analyzed using ANOVA and post hoc Bonferroni tests, with a p < 0.05. Chemical attack for 60 min associated with one year of toothbrushing with toothbrushes having medium or hard bristles increase the surface roughness of tested bulk-fill composite resins. No differences were recorded between toothbrushing with medium or firm bristles immediately or 30 min after acidic challenge for each of the three bulk-fill composite resins. Exposure to hydrochloric acid determines no effect on surface roughness of bulk-fill composite resins.

The Influence of Abrasive and Acidic Aggressions on the Surface Condition of Flowable Composite Resin.

The aim of this in vitro study was to evaluate the effect of hydrochloric acid associated with the abrasive effect of toothbrushing on the surface condition of three flowable composite resins used for direct restoration. Seventy samples of each composite resin: Grandio Flow (VOCO, Germany)-group A, Filtek Ultimate Flow (3M-ESPE, MN, USA)-group B, G-aenial Flo X (GC Europe)-group C were prepared, submersed in hydrochloric acid 30% for 60 min and then submitted to simulated toothbrushing procedure using 5000 cycles with toothbrushes with medium and hard bristles, immediately after the chemical attack, after 30 min or without any chemical attack. The sample's surface roughness was analyzed using a noncontact profilometer (Dektak XT, Bruker, USA). ANOVA and post hoc Bonferroni tests, with a p < 0.05, were used to analyze the values. Hydrochloric acid action for 60 min and six months of toothbrushing using toothbrushes having medium hardness or firm bristles affects the surface roughness of tested flowable composite resins. Toothbrushing with firm bristles immediately after acidic challenge determines increased surface roughness for two of the three flowable composite resins (Grandio Flow and Filtek Ultimate Flow). Toothbrushing with medium or firm bristles thirty minutes after the acidic aggression determine no effect on surface condition of flowable composite resins.

Concomitant trimodality therapy of re-irradiation, chemotherapy and regional hyperthermia for a pretreated inoperable sarcoma recurrence.

We hereby present a case of pre-treated unresectable sarcoma recurrence of the trunk which showed an excellent response to concomitant tri-modal therapy, consisting of re-irradiation, chemotherapy and regional hyperthermia even with a strong compromised re-irradiation dose. No significant toxicity of the combined therapy and fast achievement of the pain and neurological symptoms relief are reported. The case shows that concurrent tri-modality treatment can be considered as a therapeutic option for the management of pre-treated unresectable recurrence even in there-irradiation setting.

Excellent local control and survival after postoperative or definitive radiation therapy for sarcomas of the head and neck.

BACKGROUND: To report our results with postoperative or definitive radiation therapy in head and neck sarcomas. METHODS: We performed a retrospective analysis of 26 patients suffering from head and neck sarcomas, who received postoperative or definitive radiation therapy between 2003 and 2012. Median age was 64 years (19-88) and 69 % were male. Tumor locations were skull (including skin) in 31 %, paranasal sinus/orbita in 27 % and neck (including pharynx/larynx) in 42 %. Median tumor size was 4.6 cm (1-12 cm). 22 patients (85 %) presented in primary situation. Stage at presentation (UICC 7(th) for soft tissue sarcomas) was as follows: Ia:4 %, IIa:50 %, IIb:15 %, III:31 %. All except one patient suffered from high grade lesions (G2/3 FNCLCC), predominantly angiosarcoma (35 %), MFH (19 %) and synovial sarcoma (15 %). Surgery was performed in 21 pts (81 %), resulting in free margins in 10 (38 %), microscopically positive margins in 6 (23 %) and gross residual disease in 5 (19 %). Median dose to the primary tumor region was 66Gy (45-72Gy) in conventional fractionation, using 3D-CRT in 65 %, IMRT in 27 % and electrons in 8 %. 50 % of the patients also received sequential chemotherapy. RESULTS: Median follow up was 39 months (8-136). We observed three local recurrences, transferring into estimated 3- and 5-year local control rates of 86 %. One additional patient failed distantly, resulting in 3- and 5-year freedom from treatment failure rates of 82 %. Four patients have deceased, transferring into 3- and 5-year overall survival rates of 88 % and 82 %, respectively. Only two of the four deaths were sarcoma related. Maximum acute toxicity (CTCAE 3.0) was grade 1 in 27 % of the patients, grade 2 in 50 % and grade 3 in 23 %. Severe acute toxicity was mainly represented by mucositis and dysphagia. Maximum late toxicity was grade 1 in 31 %, grade 2 in 15 % and grade 3 in 19 % of the patients. Severe late toxicity included skin ulceration (n = 1), dysphagia with persistent tube dependency (n = 1), persistent sinusitis (n = 1) and hearing loss (n = 2). CONCLUSION: Excellent local control and overall survival rates can be achieved with postoperative or definitive radiation therapy with acceptable acute and late toxicities in patients suffering from sarcomas of the head and neck region.