RESUMO
Electrostatic effects in charge transport across the molecular framework, including those imposed by halogen atoms, have recently attracted noticeable attention of the molecular-electronics community. In this context, in the present work, we studied the effect of tail group (R) substitution on the charge transport properties of oligophenylenethiolate self-assembled monolayers (SAMs) on Au(111), with R = H, F, CH3, and CF3. The length of the molecular backbone was varied from one to three rings and the quality, basic parameters, and electrostatic properties of the SAMs were monitored. For a given length of the molecular backbone, the current density showed a strong dependence on R, being the highest for R = CH3, and then successively lower for R = H, R = CF3, and R = F. This tendency correlated neither with the molecular length of the precursors nor with the work function of the SAMs and was, therefore, exclusively ascribed to the identity of the tail group. In contrast to the current density, the tunneling decay coefficient, describing its dependence on the molecular length, was found to be independent of the identity of the tail group. The reasons behind the observed behavior are discussed and rationalized within the available experimental data and reasonable assumptions.
RESUMO
Two homoleptic copper(II) complexes [Cu(L1)2 ] and [Cu(L2)2 ] with anionic redox-active ligands were synthesised, one with urea azine (L1) and the other with thio-urea azine (L2) ligands. One-electron oxidation of the complexes initiates an unprecedented redox-induced electron transfer process, leading to monocationic copper(I) complexes [Cu(L1)2 ]+ and [Cu(L2)2 ]+ with two oxidised ligands. While [Cu(L1)2 ]+ is best described as a CuI complex with two neutral radical ligands that couple antiferromagnetically, [Cu(L2)2 ]+ is a CuI complex with two clearly different ligand units in the solid state and with a magnetic susceptibility close to a diamagnetic compound. Further one-electron oxidation of the complex with L1 ligands results in a dication [Cu(L1)2 ]2+ , best described as a CuI complex with a twofold oxidised, monocationic ligand and a neutral radical ligand. The stability in at least three redox states, the accumulation of spin density at the ligands and the facile ligand-metal electron transfer make these complexes highly attractive for a variety of applications; here the catalytic aerobic oxidation of alcohols to aldehydes is tested.
RESUMO
A series of single-component and binary SAMs composed of non-substituted (H-BPT) and fluorine-substituted (F-BPT) mercaptobiphenyls on Au(111) was studied in the context of their structure, composition, electrostatic properties, and charge tunneling rates in molecular junctions. All SAMs were found to be well-defined and densely packed, with all molecules bound to the substrate by the thiolate anchor and orientated upright with respect to the substrate. The relative composition of the binary SAMs turned out to be close to the relative contents of both molecules in the solutions from which these SAMs were formed. The work function of the binary SAMs can be varied in a gradual and controlled fashion between the ultimate values for the single-component films, viz.â¼4.3 eV and â¼5.2 eV. The extent of the electrostatic effects in photoemission is small, affecting predominantly the apparent binding energy of the terminal fluorine atoms, which is explained by the strong spatial confinement of the step in the electrostatic potential at the SAM-ambient interface. The charge tunneling rate across the molecular framework is noticeably (by about an order of magnitude) higher for the H-BPT SAM than for the F-BPT monolayer, in good agreement with the literature data. The tunneling rates for the mixed SAM are intermediate to those of the single-component films, varying in a gradual fashion with the SAM composition between the respective ultimate values.
RESUMO
Binary self-assembled monolayers (SAMs) combining a Y-shaped aromatic carboxylic acid (1,3,5-benzenetribenzoic acid, H3BTB) and a cage-type alicyclic carboxylic acid (adamantane carboxylic acid, AdCA) were investigated by scanning tunneling microscopy (STM), X-ray photoelectron spectroscopy (XPS), and near edge X-ray absorption fine structure (NEXAFS) spectroscopy. The SAMs, prepared by molecular adsorption from solution on Au substrates modified by underpotential deposition of Ag, exhibit a pronounced dependence of their structure on the assembly protocol. Exposing an H3BTB SAM to AdCA, the highly regular row structure of the native H3BTB layer persists and STM imaging does not show signs of AdCA adsorption. This is in striking contrast to the disordered arrangements of H3BTB and the presence of AdCA employing the inverted adsorption sequence or coadsorption of the two molecules. However, spectroscopic analysis of the H3BTB SAM exposed to AdCA reveals the presence also of the latter, suggesting that the AdCA molecules are hidden in the nanotunnels of the H3BTB monolayer. Direct evidence for the intercalation of AdCA is obtained by STM manipulation experiments which lay bare areas of AdCA molecules upon local removal of H3BTB. Surprisingly, these are densely packed and arranged into a highly ordered monolayer. Formation of such a compact AdCA layer is explained by expulsion of AdCA from the H3BTB nanotunnels of the surrounding intact mixed SAM, driven by release of stress in the nanotunnels built up when AdCA is intercalated.
RESUMO
This study describes the modulation of tunneling probabilities in molecular junctions by switching one of two parallel intramolecular pathways. A linearly conjugated molecular wire provides a rigid framework that allows a second, cross-conjugated pathway to be effectively switched on and off by protonation, affecting the total conductance of the junction. This approach works because a traversing electron interacts with the entire quantum-mechanical circuit simultaneously; Kirchhoff's rules do not apply. We confirm this concept by comparing the conductances of a series of compounds with single or parallel pathways in large-area junctions using EGaIn contacts and single-molecule break junctions using gold contacts. We affect switching selectively in one of two parallel pathways by converting a cross-conjugated carbonyl carbon into a trivalent carbocation, which replaces destructive quantum interference with a symmetrical resonance, causing an increase in transmission in the bias window.
RESUMO
Photoisomerization of a series of custom-designed, azobenzene-substituted alkanethiolate (AT) self-assembled monolayers (SAMs) on Au(111) substrates was studied in the context of work function variation, using Kelvin probe measurements as a transduction technique. These SAMs featured variable packing density (by â¼14%; due to the odd-even effects) and, as an option, were additionally decorated with the electron donating/withdrawing -CH3 and -CF3 tail group, respectively, which induce additional dipole moments. The efficiency of photoisomerization and the respective extent of work function variation (ΔΦ) were found to be quite low and independent of the packing density in the SAMs, within the given odd-even packing density variation. They could only be increased, up to ca. 40 meV for ΔΦ, by mixing the azobenzene-substituted ATs with shorter "matrix" molecules, which were introduced for a partial release of the sterical constraints. The ΔΦ values for the SAMs decorated with the -CH3 and -CF3 tail groups were found to be lower than those for the monolayers without such a decoration, which correlated well with the theoretical estimates for the change of the dipole moment of the relevant molecules upon the photoisomerization.
RESUMO
The controlled functionalization of single-walled carbon nanotubes with luminescent sp3-defects has created the potential to employ them as quantum-light sources in the near-infrared. For that, it is crucial to control their spectral diversity. The emission wavelength is determined by the binding configuration of the defects rather than the molecular structure of the attached groups. However, current functionalization methods produce a variety of binding configurations and thus emission wavelengths. We introduce a simple reaction protocol for the creation of only one type of luminescent defect in polymer-sorted (6,5) nanotubes, which is more red-shifted and exhibits longer photoluminescence lifetimes than the commonly obtained binding configurations. We demonstrate single-photon emission at room temperature and expand this functionalization to other polymer-wrapped nanotubes with emission further in the near-infrared. As the selectivity of the reaction with various aniline derivatives depends on the presence of an organic base we propose nucleophilic addition as the reaction mechanism.
RESUMO
To understand the influence of the molecular dipole moment on the electron transfer (ET) dynamics across the molecular framework, two series of differently fluorinated, benzonitrile-based self-assembled monolayers (SAMs) bound to Au(111) by either thiolate or selenolate anchoring groups were investigated. Within each series, the molecular structures were the same with the exception of the positions of two fluorine atoms affecting the dipole moment of the SAM-forming molecules. The SAMs exhibited a homogeneous anchoring to the substrate, nearly upright molecular orientations, and the outer interface comprised of the terminal nitrile groups. The ET dynamics was studied by resonant Auger electron spectroscopy in the framework of the core-hole clock method. Resonance excitation of the nitrile group unequivocally ensured an ET pathway from the tail group to the substrate. As only one of the π* orbitals of this group is hybridized with the π* system of the adjacent phenyl ring, two different ET times could be determined depending on the primary excited orbital being either localized at the nitrile group or delocalized over the entire benzonitrile moiety. The latter pathway turned out to be much more efficient, with the characteristic ET times being a factor 2.5-3 shorter than those for the localized orbital. The dynamic ET properties of the analogous thiolate- and selenolate-based adsorbates were found to be nearly identical. Finally and most importantly, these properties were found to be unaffected by the different patterns of the fluorine substitution used in the present study, thus showing no influence of the molecular dipole moment.
RESUMO
This paper describes the conductance of single-molecules and self-assembled monolayers comprising an oligophenyleneethynylene core, functionalized with acenes of increasing length that extend conjugation perpendicular to the path of tunneling electrons. In the Mechanically Controlled Break Junction (MCBJ) experiment, multiple conductance plateaus were identified. The high conductance plateau, which we attribute to the single molecule conformation, shows an increase of conductance as a function of acene length, in good agreement with theoretical predictions. The lower plateau is attributed to multiple molecules bridging the junctions with intermolecular interactions playing a role. In junctions comprising a self-assembled monolayer with eutectic Ga-In top-contacts (EGaIn), the pentacene derivative exhibits unusually low conductance, which we ascribe to the inability of these molecules to pack in a monolayer without introducing significant intermolecular contacts. This hypothesis is supported by the MCBJ data and theoretical calculations showing suppressed conductance through the PC films. These results highlight the role of intermolecular effects and junction geometries in the observed fluctuations of conductance values between single-molecule and ensemble junctions, and the importance of studying molecules in both platforms.