Design and Validation of a Scalable, Reconfigurable and Low-Cost Structural Health Monitoring System.

This paper presents the design, development and testing of a low-cost Structural Health Monitoring (SHM) system based on MEMS (Micro Electro-Mechanical Systems) triaxial accelerometers. A new control system composed by a myRIO platform, managed by specific LabVIEW software, has been developed. The LabVIEW software also computes the frequency response functions for the subsequent modal analysis. The proposed SHM system was validated by comparing the data measured by this set-up with a conventional SHM system based on piezoelectric accelerometers. After carrying out some validation tests, a high correlation can be appreciated in the behavior of both systems, being possible to conclude that the proposed system is sufficiently accurate and sensitive for operative purposes, apart from being significantly more affordable than the traditional one.

Internal GFRP Reinforcement of Low-Grade Maritime Pine Duo Timber Beams.

This paper presented an experimental structural-scale test campaign used to analyze the flexural behavior of low-grade maritime pine (Pinus pinaster Ait.) duo timber beams reinforced with an internal glass fiber-reinforced polymer (GFRP) sheet. For this purpose, thirty (30) unreinforced duo beams and thirty (30) duo beams internally reinforced with a unidirectional GFRP sheet with an areal mass of 1200 g/m2 were produced and tested. The addition of a low GFRP reinforcement ratio (1.07%) in the tension zone of the duo beams provided an average improvement of 8.37% in bending stiffness (EI) and an increase of up to 18.45% in ultimate moment capacity. In addition to this improved bending behavior, the internal GFRP reinforcements seemed to decrease the influence of wood singularities and wood heterogeneity on mechanical properties, which allowed for better characteristic values to be reached and for the achievement of results with less variability.