Acute toxicity when concentration varies with time: A case study with carbon monoxide inhalation by rats.

Exposure to time-varying concentrations of toxic compounds is the norm in both occupational settings and daily human life, but little has been done to investigate the impact of variations in concentration on toxic outcomes; this case study with carbon monoxide helps fill that gap. Median acute lethality of 10-, 20-, 40-, and 60-min continuous exposures of rats to carbon monoxide was well described by the toxic load model (k = C(n) × t; k is constant, C = test concentration, n = toxic load exponent, and t = exposure duration) with n = 1.74. Dose response-relationships for 1-h exposures including a recovery period between 10- or 20-min pulses showed greater similarity (in both median lethality and steepness of dose-response curve) to continuous exposures with equivalent pulse duration and concentration, rather than a 60-min exposure with equivalent time-weighted average concentrations or toxic load. When pulses were of unequal concentration (3:1 ratio), only the high concentration pulse contributed to lethality. These findings show that fluctuations or interruptions in exposure over a short time scale (60 min or less) can have a substantial impact on outcomes (when n > 1), and thus high-resolution monitoring data are needed to aid interpretation of resulting outcomes.

Evaluating the validity and applicable domain of the toxic load model: impact of concentration vs. time profile on inhalation lethality of hydrogen cyanide.

The ten Berge model (or "toxic load" model) is often used to estimate the acute toxicity for varying combinations of inhaled concentration and duration. Expressed as C(n) × t = toxic load (TL), TLs are assumed constant for various combinations of concentration (C) and time (t). Experimental data in a recent acute inhalation study of rats exposed to time-varying concentrations of hydrogen cyanide (HCN) supported the validity of the toxic load model except under very brief, discontinuous, high concentration exposures. In the present investigation, experiments were conducted to extend the evaluation of the applicable domain of the model for acute lethality of HCN in the rat (cumulative exposure range of 2900-11,000 ppm min). The lethality of HCN over very short (< 5 min) durations of high concentrations did not conform to the toxic load model. A value of n=1.57 was determined for uninterrupted exposures ⩾ 5 min. For 30-min exposures, the presence or absence of a gap between two exposure pulses of different concentrations, the relative duration, relative height, and the ordering of the pulses (low then high, vs. high then low) did not appear to have a meaningful impact on the toxic load required for median lethality.

Modeling low-dose mortality and disease incubation period of inhalational anthrax in the rabbit.

There is a need to advance our ability to conduct credible human risk assessments for inhalational anthrax associated with exposure to a low number of bacteria. Combining animal data with computational models of disease will be central in the low-dose and cross-species extrapolations required in achieving this goal. The objective of the current work was to apply and advance the competing risks (CR) computational model of inhalational anthrax where data was collected from NZW rabbits exposed to aerosols of Ames strain Bacillus anthracis. An initial aim was to parameterize the CR model using high-dose rabbit data and then conduct a low-dose extrapolation. The CR low-dose attack rate was then compared against known low-dose rabbit data as well as the low-dose curve obtained when the entire rabbit dose-response data set was fitted to an exponential dose-response (EDR) model. The CR model predictions demonstrated excellent agreement with actual low-dose rabbit data. We next used a modified CR model (MCR) to examine disease incubation period (the time to reach a fever >40 °C). The MCR model predicted a germination period of 14.5h following exposure to a low spore dose, which was confirmed by monitoring spore germination in the rabbit lung using PCR, and predicted a low-dose disease incubation period in the rabbit between 14.7 and 16.8 days. Overall, the CR and MCR model appeared to describe rabbit inhalational anthrax well. These results are discussed in the context of conducting laboratory studies in other relevant animal models, combining the CR/MCR model with other computation models of inhalational anthrax, and using the resulting information towards extrapolating a low-dose response prediction for man.

Impact of non-constant concentration exposure on lethality of inhaled hydrogen cyanide.

The ten Berge model, also known as the toxic load model, is an empirical approach in hazard assessment modeling for estimating the relationship between the inhalation toxicity of a chemical and the exposure duration. The toxic load (TL) is normally expressed as a function of vapor concentration (C) and duration (t), with TL equaling C(n) × t being a typical form. Hypothetically, any combination of concentration and time that yields the same "toxic load" will give a constant biological response. These formulas have been developed and tested using controlled, constant concentration animal studies, but the validity of applying these assumptions to time-varying concentration profiles has not been tested. Experiments were designed to test the validity of the model under conditions of non-constant acute exposure. Male Sprague-Dawley rats inhaled constant or pulsed concentrations of hydrogen cyanide (HCN) generated in a nose-only exposure system for 5, 15, or 30 min. The observed lethality of HCN for the 11 different C versus t profiles was used to evaluate the ability of the model to adequately describe the lethality of HCN under the conditions of non-constant inhalation exposure. The model was found to be applicable under the tested conditions, with the exception of the median lethality of very brief, high concentration, discontinuous exposures.

Inhalational anthrax (Ames aerosol) in naïve and vaccinated New Zealand rabbits: characterizing the spread of bacteria from lung deposition to bacteremia.

There is a need to better understand inhalational anthrax in relevant animal models. This understanding could aid risk assessment, help define therapeutic windows, and provide a better understanding of disease. The aim here was to characterize and quantify bacterial deposition and dissemination in rabbits following exposure to single high aerosol dose (> 100 LD(50)) of Bacillus anthracis (Ames) spores immediately following exposure through 36 h. The primary goal of collecting the data was to support investigators in developing computational models of inhalational anthrax disease. Rabbits were vaccinated prior to exposure with the human vaccine (Anthrax Vaccine Adsorbed, AVA) or were sham-vaccinated, and were then exposed in pairs (one sham and one AVA) so disease kinetics could be characterized in equally-dosed hosts where one group is fully protected and is able to clear the infection (AVA-vaccinated), while the other is susceptible to disease, in which case the bacteria are able to escape containment and replicate uncontrolled (sham-vaccinated rabbits). Between 4-5% of the presented aerosol dose was retained in the lung of sham- and AVA-vaccinated rabbits as measured by dilution plate analysis of homogenized lung tissue or bronchoalveolar lavage (BAL) fluid. After 6 and 36 h, >80% and >96%, respectively, of the deposited spores were no longer detected in BAL, with no detectable difference between sham- or AVA-vaccinated rabbits. Thereafter, differences between the two groups became noticeable. In sham-vaccinated rabbits the bacteria were detected in the tracheobronchial lymph nodes (TBLN) 12 h post-exposure and in the circulation at 24 h, a time point which was also associated with dramatic increases in vegetative CFU in the lung tissue of some animals. In all sham-vaccinated rabbits, bacteria increased in both TBLN and blood through 36 h at which point in time some rabbits succumbed to disease. In contrast, AVA-vaccinated rabbits showed small numbers of CFU in TBLN between 24 and 36 h post-exposure with small numbers of bacteria in the circulation only at 24 h post-exposure. These results characterize and quantify disease progression in naïve rabbits following aerosol administration of Ames spores which may be useful in a number of different research applications, including developing quantitative models of infection for use in human inhalational anthrax risk assessment.