RESUMO
The intelligent reflecting surface (IRS) and angle diversity receiver (ADR) jointly assisted indoor visible light communication (VLC) system is proposed to improve average signal-to-noise ratio (ASNR) performance. Specifically, to maximize the ASNR at the receiving plane, the roll angle and yaw angle of IRS and the inclination angle of the side detector in the ADR structure are optimized simultaneously as one non-convex problem. With the bat algorithm, the optimal solution is numerically obtained. Results show that when the transmit power of the light emitting diode lamp array is 1 W, the ASNRs of this VLC system optimized by IRS and ADR are approximately 7.89 dB, 3.58 dB, and 2.09 dB higher than those of the original, IRS-assisted, and ADR-assisted VLC systems, respectively. Furthermore, the transmission rate and bit error rate performances of the original, IRS-assisted, ADR-assisted, and IRS and ADR jointly assisted indoor VLC systems are also simulated and compared; it is found that the performance improvement of the indoor VLC system jointly optimized by IRS and ADR is more evident than that of the other three VLC systems. This study will benefit the research and development of indoor VLC systems.
RESUMO
In this work, a dynamic resource allocation (DRA) algorithm is proposed to optimize the transmission rate subject to the access point assignment, bandwidth and transmit power allocation in RF/VLC heterogeneous networks, which combines the visible light communication (VLC) access point (AP) and radio frequency (RF) AP. To optimize the allocation among resource block (RB), subchannel and power, the time-average transmission rate is maximized under time-average transmit power budget. Specifically, the time-average optimization problem is converted into series of single timeslot online problem by Lyapunov optimization technique. Because of its complexity and non-convexity, the problem is decomposed into three independent subproblems for which a non-iterative solution is presented on the basis of Lagrange relaxation and convex optimization theory. Numerical simulations are conducted to demonstrate the effectiveness of the proposed DRA algorithm. And the comparisons with two classical algorithms are also given in terms of transmission rate and system stability. This work will benefit the design and development of hybrid RF/VLC system.
RESUMO
In this work, an angle diversity receiver (ADR) structure is proposed to optimize the uniformity of the received optical power distribution in an indoor visible light communication (VLC) system. Taking the rectangular and hybrid layouts with 16 light-emitting diodes as examples, different inclination angles and the number of side detectors are investigated with three diversity combining techniques in a typical room, where the primary reflection of the wall is considered. Simulation results showed that the inclination angles and the number of side detectors would affect the variance and average of the received optical power, and the variance would decrease with the increase of the number of side detectors. In addition, maximal ratio combining is more suitable for the ADR when the variance and average of the received optical power are considered simultaneously. By applying the ADR with five side detectors, the variances of the received optical power will decrease by 81.34% and 86.09% under the rectangle layout and the hybrid layout, respectively. This work will benefit the design and development of the VLC system.
RESUMO
Aiming at the problem of uneven distribution of receiving illuminance and optical power on the receiving plane of the visible light communication (VLC) system, this paper proposes a light source optimization method based on an improved bat algorithm (IBA). Taking the rectangular and hybrid layouts with 16 light-emitting diodes (LEDs), as examples, we set the variance of received light power on the receiving plane as the fitness function. By redesigning the speed update method and local search method of the traditional bat algorithm (BA), the IBA is used to optimize the LED half-power angle and LED position that affect the system performance. The simulation results show that, considering the primary reflection of the wall, the method can reduce the received illumination and optical power fluctuation of the receiving plane within a limited number of iterations under different light source layout schemes.