Period measurement of a periodic structure by using a heterodyne grating interferometer.

This paper proposes an alternative method for grating period measurement based on heterodyne grating interferometry. The optical configurations for measuring the period of reflection/transmission gratings were demonstrated, and four commercially available gratings were used to evaluate the effectiveness of the proposed method. Based on the phase-lock technique, the grating period could be obtained immediately through the phase wrapped/unwrapped process. Under precise measurement conditions, the grating period measurement error of the proposed method was better than 1 nm, and the grating period difference between product specifications was less than 1%. In addition, the measurement results of the proposed method also exhibited high similarity with optical microscopy measurements.

Fabrication and Characterization of Photovoltaic Microgenerators Using the Complementary Metal Oxide Semiconductor Process.

This study develops a photovoltaic microgenerator based on the complementary metal oxide semiconductor (CMOS) process. The photovoltaic microgenerator converts the absorbed light energy into electrical energy using the photovoltaic effect. The material for the photovoltaic microgenerator is silicon, and its structure consists of patterned p-n junctions. The design of the photovoltaic microgenerator utilizes a grid-like shape, forming a large-area p-n junction with a patterned p-doping and N-well structure to enhance the photocurrent and improve the device's performance. The photovoltaic microgenerator is fabricated employing the CMOS process with post-processing step. Post-processing is applied to enhance the microgenerator's light absorption and energy-conversion efficiency. This involves using wet etching with buffered-oxide etch (BOE) to remove the silicon dioxide layer above the p-n junctions, allowing direct illumination of the p-n junctions. The area of the photovoltaic microgenerator is 0.79 mm2. The experimental results show that under an illumination intensity of 1000 W/m2, the photovoltaic microgenerator exhibits an open-circuit voltage of 0.53 V, a short-circuit current of 233 µA, a maximum output power of 99 µW, a fill factor of 0.8, and an energy-conversion efficiency of 12.5%.

Modeling and simulation of cell migration on the basis of force equilibrium.

To study cell behavior, we developed a cell model to simulate cell movements and the interacting forces among cells and between cells and obstacles. The developed model simulates several cells simultaneously and examines correlations among characteristic parameters between cells and substrates during migration. We modified Odde's model to develop fundamental model, applied Gillespie's stochastic algorithm to design time during in the migration simulation, and employed Keren's membrane theory to analyze the equilibrium at the leading edges. Thus, the proposed model can analyze stresses due to substrate, the intracellular body, and the external interaction between cells and obstacles. Simulation results indicate that cell-cell interaction depends on the equilibrium between the forces at the leading edge of the membrane, namely the cell-substrate interaction force, cell-cell interaction forces, and the cell membrane force. These results also indicate that the migration direction is dependent on the resultant forces. The membrane force and substrate force directions are "low correlation," and the polymerization rate exhibits "little correlative" with the migration direction. We propose a modified cell migration model for simulating allocation and interaction among multiple cells. This model helps indicate the weightings of characteristic parameters that affect the cell migration direction and velocity.

Eye orbit effects on eyeball resonant frequencies and acoustic tonometer measurements.

The eye orbit has mechanical and acoustic characteristics that determine resonant frequencies and amplify acoustic signals in certain frequency ranges. These characteristics also interfere with the acoustic amplitudes and frequencies of eyeball when measured with an acoustic tonometer. A model in which a porcine eyeball was embedded in ultrasonic conductive gel in the orbit of a model skull was used to simulate an in vivo environment, and the acoustic responses of eyeballs were detected. The triggering source was a low-power acoustic speaker contacting the occipital bone, and the detector was a high-resolution microphone with a dish detecting the acoustic signals without contacting the cornea. Dozens of ex vivo porcine eyeballs were tested at various intraocular pressure levels to detect their resonant frequencies and acoustic amplitudes in their power spectra. We confirmed that the eyeballs' resonant frequencies were proportional to intraocular pressure, but interference from orbit effects decreased the amplitudes in these resonant frequency ranges. However, we observed that the frequency amplitudes of eyeballs were correlated with intraocular pressure in other frequency ranges. We investigated eye orbit effects and demonstrated how they interfere with the eyeball's resonant frequencies and frequency amplitudes. These results are useful for developing advanced acoustic tonometer.

Functional assistance for stress distribution in cell culture membrane under periodically stretching.

Dynamic cell cultures simulate the in vivo cell environment for a regular loading system with curtain strains. However, it is difficult to obtain strains that are suitable for cells without conducting multiple trials. This study develops a device that increases the strain gradient by changing the tensile section, in order to determine the effect of various cyclic strains on cultured human keratinocytes (HK) cells. This device is used to determine the effect of 3% and 5% cyclic strain and shear strain on cell proliferation and arrangement at 1 Hz. The results show that compared with static and 3% strain, a 5% cyclic strain better inhibits the proliferation of HK cells. Compared to the initial cell attachment when there is no specific directionality, the cells are aligned in the vertical stretching direction after cyclic stretching. This equipment increases the efficiency of the experiment and more intuitively maps the cell behavior and shape to the strain field and the response to the shear strain.