Carbon Dioxide Conversion to Methanol over Size-Selected Cu4 Clusters at Low Pressures.

The activation of CO2 and its hydrogenation to methanol are of much interest as a way to utilize captured CO2. Here, we investigate the use of size-selected Cu4 clusters supported on Al2O3 thin films for CO2 reduction in the presence of hydrogen. The catalytic activity was measured under near-atmospheric reaction conditions with a low CO2 partial pressure, and the oxidation state of the clusters was investigated by in situ grazing incidence X-ray absorption spectroscopy. The results indicate that size-selected Cu4 clusters are the most active low-pressure catalyst for catalytic CO2 conversion to CH3OH. Density functional theory calculations reveal that Cu4 clusters have a low activation barrier for conversion of CO2 to CH3OH. This study suggests that small Cu clusters may be excellent and efficient catalysts for the recycling of released CO2.

Size- and support-dependent evolution of the oxidation state and structure by oxidation of subnanometer cobalt clusters.

Size-selected subnanometer cobalt clusters with 4, 7, and 27 cobalt atoms supported on amorphous alumina and ultrananocrystalline diamond (UNCD) surfaces were oxidized after exposure to ambient air. Grazing incidence X-ray absorption near-edge spectroscopy (GIXANES) and near-edge X-ray absorption fine structure (NEXAFS) were used to characterize the clusters revealed a strong dependency of the oxidation state and structure of the clusters on the surface. A dominant Co(2+) phase was identified in all samples. However, XANES analysis of cobalt clusters on UNCD showed that ∼10% fraction of a Co(0) phase was identified for all three cluster sizes and about 30 and 12% fraction of a Co(3+) phase in 4, 7, and 27 atom clusters, respectively. In the alumina-supported clusters, the dominating Co(2+) component was attributed to a cobalt aluminate, indicative of a very strong binding to the support. NEXAFS showed that in addition to strong binding of the clusters to alumina, their structure to a great extent follows the tetrahedral morphology of the support. All supported clusters were found to be resistant to agglomeration when exposed to reactive gases at elevated temperatures and atmospheric pressure.

Shape Recovery with Concomitant Mechanical Strengthening of Amphiphilic Shape Memory Polymers in Warm Water.

Maintaining adequate or enhancing mechanical properties of shape memory polymers (SMPs) after shape recovery in an aqueous environment are greatly desired for biomedical applications of SMPs as self-fitting tissue scaffolds or minimally invasive surgical implants. Here we report stable temporary shape fixing and facile shape recovery of biodegradable triblock amphiphilic SMPs containing a poly(ethylene glycol) (PEG) center block and flanking poly(lactic acid) or poly(lactic-co-glycolic acid) blocks in warm water, accompanied by concomitant enhanced mechanical strengths. Differential scanning calorimetry (DSC), wide-angle X-ray diffraction (WXRD), and small-angle X-ray scattering (SAXS) analyses revealed that the unique stiffening of the amphiphilic SMPs upon hydration was due to hydration-driven microphase separation and PEG crystallization. We further demonstrated that the chemical composition of degradable blocks in these SMPs could be tailored to affect the persistence of hydration-induced stiffening upon subsequent dehydration. These properties combined open new horizons for these amphiphilic SMPs for smart weight-bearing in vivo applications (e.g., as self-fitting intervertebral discs). This study also provides a new material design strategy to strengthen polymers in aqueous environment in general.

Size-dependent subnanometer Pd cluster (Pd4, Pd6, and Pd17) water oxidation electrocatalysis.

Water oxidation is a key catalytic step for electrical fuel generation. Recently, significant progress has been made in synthesizing electrocatalytic materials with reduced overpotentials and increased turnover rates, both key parameters enabling commercial use in electrolysis or solar to fuels applications. The complexity of both the catalytic materials and the water oxidation reaction makes understanding the catalytic site critical to improving the process. Here we study water oxidation in alkaline conditions using size-selected clusters of Pd to probe the relationship between cluster size and the water oxidation reaction. We find that Pd4 shows no reaction, while Pd6 and Pd17 deposited clusters are among the most active (in terms of turnover rate per Pd atom) catalysts known. Theoretical calculations suggest that this striking difference may be a demonstration that bridging Pd-Pd sites (which are only present in three-dimensional clusters) are active for the oxygen evolution reaction in Pd6O6. The ability to experimentally synthesize size-specific clusters allows direct comparison to this theory. The support electrode for these investigations is ultrananocrystalline diamond (UNCD). This material is thin enough to be electrically conducting and is chemically/electrochemically very stable. Even under the harsh experimental conditions (basic, high potential) typically employed for water oxidation catalysts, UNCD demonstrates a very wide potential electrochemical working window and shows only minor evidence of reaction. The system (soft-landed Pd4, Pd6, or Pd17 clusters on a UNCD Si-coated electrode) shows stable electrochemical potentials over several cycles, and synchrotron studies of the electrodes show no evidence for evolution or dissolution of either the electrode material or the clusters.