RESUMO
We report on an analysis of the nonlinear absorption in lithium triborate (LBO) used for second and third harmonic generation of ultrashort laser pulses at average powers in the order of kW and with sub-picosecond pulse duration. Thermographic imaging of the LBO crystals together with a simple analytical model revealed the presence of nonlinear absorption in both harmonic generation processes. Subsequent processing with a numerical model considering the nonlinear mixing, the absorption, and the heat conduction was used to estimate the absorption coefficients. Average powers exceeding 100 W in the ultraviolet and 400 W in the visible spectral range were obtained while maintaining a good beam quality by avoiding excessive nonlinear absorption.
RESUMO
We report on high-quality high-throughput laser milling of silicon with a sub-ps laser delivering more than 1 kW of average laser power on the workpiece. In order to avoid heat accumulation effects, the processing strategy for high-quality laser milling was adapted to the available average power by using five-pulse bursts, a large beam diameter of 372 µm to limit the peak fluence per pulse to approximately 0.7J/cm2, and a high feed rate of 24 m/s. As a result, smooth surfaces with a low roughness of Sa≤0.6µm were achieved up to the investigated milling depth of 313 µm while maintaining a high material removal rate of 230mm3/min.
RESUMO
Generation of sub-150-fs-level pulses has been obtained from an Yb-doped crystal-based regenerative amplifier by applying an innovative amplification scheme. This scheme is based on optimization of the linear and non-linear phase during the amplification process inside the regenerative amplifier cavity. This technique with Yb:KYW allows to achieve pulse durations from diode-pumped Yb-doped regenerative amplifiers that were up to now only accessible with more complex Ti:sapphire amplifiers. With this Yb-doped tungstate crystal used in regenerative amplifiers, 145 fs pulses centered at 1026 nm with a spectral bandwidth of 14 nm at 50 kHz for an average power of 1.6 W have been generated.
RESUMO
We report on the first diode-pumped Yb:CaGdAlO4 regenerative amplifier in the sub-100-fs regime. It generates pulses at a central wavelength of 1047 nm with up to 24 µJ energy (after compression) at a repetition rate of 50 kHz. The measured pulse duration is 97 fs, with a spectral bandwidth of 19 nm. We describe in detail how nonlinear effects are optimally used to compensate gain narrowing in order to overcome the 100 fs barrier.
RESUMO
The femtosecond GHz-burst mode laser processing has attracted much attention in the last few years. Very recently, the first percussion drilling results obtained in glasses using this new regime were reported. In this study, we present our latest results on top-down drilling in glasses, focusing specifically on the influence of burst duration and shape on the hole drilling rate and the quality of the drilled holes, wherein holes of very high quality with a smooth and glossy inner surface can be obtained. We show that a decreasing energy repartition of the pulses within the burst can increase the drilling rate, but the holes saturate at lower depths and present lower quality than holes drilled with an increasing or flat energy distribution. Moreover, we give an insight into the phenomena that may occur during drilling as a function of the burst shape.
RESUMO
We present a diode-pumped regenerative amplifier based on an Yb:CaF(2) crystal optimized to produce short pulses for various repetition rates ranging from 100 Hz to 10 kHz. The shortest pulse duration generated is 178 fs, and the corresponding energy is 1.4 mJ before compression (620 microJ after), at a repetition rate of 500 Hz for 16 W of pump power. The bandwidth is 10 nm centered at 1040 nm. Higher repetition rate regimes have also been explored, allowing an optical-to-optical efficiency up to 10% at a high repetition rate.