RESUMO
Carbon nanodots (C-dots) with an average size of 1.5 and 3.0â nm were produced by laser ablation in different imidazolium ionic liquids (ILs), namely, 1-n-butyl-3-methylimidazolium tetrafluoroborate (BMI.BF4 ), 1-n-butyl-3-methylimidazolium bis(trifluoromethanesulfonyl)imide (BMI.NTf2 ) and 1-n-octyl-3-methylimidazolium bis(trifluoromethanesulfonyl)imide (OMI.NTf2 ). The mean size of the nanoparticles is influenced by the imidazolium alkyl side chain but not by the nature of the anion. However, by varying the anion (BF4 vs. NTf2 ) it was possible to detect a significant modification of the fluorescence properties. The C-dots are much probably stabilised by an electrostatic layer of the IL and this interaction has played an important role with regard to the formation, stabilisation and photoluminescence properties of the nanodots. A tuneable broadband fluorescence emission from the colloidal suspension was observed under ultraviolet/visible excitation with fluorescence lifetimes fitted by a multi-exponential decay with average values around 7â ns.
RESUMO
Highly ordered TiO2 NT arrays were easily decorated with CdSe via RF magnetron sputtering. After deposition thermal annealing at different temperatures was performed to obtain an improved TiO2/CdSe interface. The heterostructures were characterized by RBS, SEM, XRD, HRTEM, UV-Vis, EIS, IPCE and current versus voltage curves. The sensitized semiconducting electrodes display an enhanced photocurrent density of ca. 2 mA cm(-2) at 0.6 V (vs. Ag/AgCl) under visible light (λ > 400 nm). The sensitized photoelectrodes displayed 3 and 535-fold enhanced photocurrent when compared to bare TiO2 NTs under 1 sun and under visible light illumination, respectively. IES results confirmed the improved charge transfer across the TiO2/CdSe/electrolyte interface after annealing at 400 °C. Incident photon-to-electron conversion efficiency measurements confirmed the efficient sensitization by allowing photoresponse in the visible range.
RESUMO
Surface-clean Au nanoparticles (NPs) confined in films of ionic liquids (ILs) can be easily fabricated by sputtering deposition. A silicon wafer coated with films of both hydrophobic (bis((trifluoromethyl)sulfonyl)amide, NTf2-) and hydrophilic (tetrafluoroborate, BF4-) imidazolium-based ILs forms an 'ionic carpet-like' structure that can be easily decorated with Au NPs of 5.1 and 6.5 nm mean diameter, respectively. The depth profile distribution of the Au NPs depends on the arrangement of the IL, which is controlled mainly by the anion volume. Higher concentrations of Au NPs are found closer to the IL surface for the system containing a larger anion (NTf2) whereas Au NPs are located deeper in the IL for the system containing a smaller anion (BF4). The Au NPs are well distributed over the IL/Si support and are strictly confined in a single layer of the IL. This method is among the most simple and versatile for the generation of liquid layers containing surface-clean, stable and confined Au NPs.
RESUMO
In this work, we show the effect of the thermal treatment temperature on the photoelectrochemical (PEC) activity of CdSe/TiO2 nanocomposites. TiO2 nanotubes (NTs) were synthesized by anodization and the nanocomposites were obtained by depositing CdSe clusters via magnetron sputtering. A two-step thermal treatment was performed: heating the TiO2 NTs at different temperatures prior to CdSe deposition and further heating the CdSe/TiO2 nanocomposites. The nanocomposites were characterized by Rutherford backscattering spectroscopy (RBS), scanning electron microscopy (SEM), scanning transmission electron microscopy (STEM), high-resolution transmission electron microscopy (HRTEM), energy dispersive X-ray spectroscopy (EDX), X-ray diffraction (XRD), UV-Vis spectrophotometry, and electrochemical impedance spectroscopy (EIS). To compare the PEC performance of the CdSe/TiO2 nanocomposites and pristine TiO2 NTs, linear sweep voltammetry (LSV) curves were obtained under visible light and under 1 sun illumination. It was observed that CdSe incorporation into the TiO2 template enhances the visible light absorbance thereby improving the PEC performance of the nanocomposites. We have found that the optical, structural and PEC properties of the CdSe/TiO2 nanocomposites are dependent on the thermal treatment temperature of the TiO2 nanotubular substrate, prior to CdSe deposition. Moreover, a three-fold improvement in photocurrent was observed upon further thermal treatment of the obtained nanocomposite.