RESUMO
Sandwich-type structure based on Salisbury screen effect is a simple and effective strategy to acquire high-performance terahertz (THz) absorption. The number of sandwich layer is the key factor that affects the absorption bandwidth and intensity of THz wave. Traditional metal/insulant/metal (M/I/M) absorber is difficult to construct multilayer structure because of low light transmittance of the surface metal film. Graphene exhibits huge advantages including broadband light absorption, low sheet resistance and high optical transparency, which are useful for high-quality THz absorber. In this work, we proposed a series of multilayer metal/PI/graphene (M/PI/G) absorber based on graphene Salisbury shielding. Numerical simulation and experimental demonstration were provided to explain the mechanism of graphene as resistive film for strong electric field. And it is important to improve the overall absorption performance of the absorber. In addition, the number of resonance peaks is found to increase by increasing the thickness of the dielectric layer in this experiment. The absorption broadband of our device is around 160%, greater than those previously reported THz absorber. Finally, this experiment successfully prepared the absorber on a polyethylene terephthalate (PET) substrate. The absorber has high practical feasibility and can be easily integrated with the semiconductor technology to make high efficient THz-oriented devices.
RESUMO
Lithium niobate (LiNbO3) single crystals are a kind of ferroelectric material with a high piezoelectric coefficient and Curie temperature, which is suitable for the preparation of piezoelectric pressure sensors. However, there is little research reporting on the use of LiNbO3 single crystals to prepare piezoelectric pressure sensors. Therefore, in this paper, LiNbO3 was used to prepare piezoelectric pressure sensors to study the feasibility of using LiNbO3 single crystals as a sensitive material for piezoelectric pressure sensors. In addition, chemical mechanical polishing (CMP) technology was used to prepare LiNbO3 crystals with different thicknesses to study the influence of these LiNbO3 crystals on the electric charge output of the sensors. The results showed that the sensitivity of a 300 µm sample (0.218 mV kPa-1) was about 1.23 times that of a 500 µm sample (0.160 mV kPa-1). Low-temperature polymer heterogeneous integration and oxygen plasma activation technologies were used to realize the heterogeneous integration of LiNbO3 and silicon to prepare piezoelectric pressure sensors, which could significantly improve the sensitivity of the sensor by approximately 16.06 times (2.569 mV kPa-1) that of the original sample (0.160 mV kPa-1) due to an appropriate residual stress that did not shatter LiNbO3 or silicon, thus providing a possible method for integrating piezoelectric pressure sensors and integrated circuits.
RESUMO
In 2013, the Chinese government implemented a two-child policy to increase the country's fertility rate. However, the persistently low rates necessitated other measures to boost fertility. This study empirically investigated the association between intergenerational support and second-child fertility intention in the Chinese sandwich generation and demonstrated the mediating role of parental burnout and burnout in caring for grandparents. Survey data collected at Time 1, Time 2, and Time 3 included 2939 participants from different regions of China. Before analyzing the data, coarsened exact matching and propensity score matching was conducted to reduce sampling bias. Regression analysis results indicated that intergenerational support has a significant total positive effect on second-child fertility intention. Furthermore, mediation path analysis revealed that parental burnout and burnout in caring for grandparents play significant but opposite directional mediating roles in the association between intergenerational support and second-child fertility intention. Sensitivity analysis using different calipers yielded similar results. These results indicated that second-child fertility intention can be increased among the Chinese sandwich generation with intergenerational support, by mitigating parental burnout. However, intergenerational support did not alleviate burnout in caring for grandparents in the sandwich generation; therefore, formal older adult care policies are required to help the sandwich generation experience lower burnout, while receiving intergenerational support.
RESUMO
Obtaining highly purified intact living cells from complex environments has been a challenge, such as the isolation of circulating tumor cells (CTCs) from blood. In this work, we demonstrated an acoustic-based ultra-compact device for cell sorting, with a chip size of less than 2 × 1.5 cm2. This single actuator device allows non-invasive and label-free isolation of living cells, offering greater flexibility and applicability. The device performance was optimized with different-sized polystyrene (PS) particles and blood cells spiked with cancer cells. Using the narrow-path travelling surface acoustic wave (np-TSAW), precise isolation of 10 µm particles from a complex mixture of particles (5, 10, 20 µm) and separation of 8 µm and 10 µm particles was achieved. The purified collection of 10 µm particles with high separation efficiency (98.75%) and high purity (98.1%) was achieved by optimizing the input voltage. Further, we investigated the isolation and purification of CTCs (MCF-7, human breast cancer cells) from blood cells with isolation efficiency exceeding 98% and purity reaching 93%. Viabilities of the CTCs harvested from target-outlet were all higher than 97% after culturing for 24, 48, and 72 h, showing good proliferation ability. This novel ultra-miniaturized microfluidic chip demonstrates the ability to sorting cells with high-purity and label-free, providing an attractive miniaturized system alternative to traditional sorting methods.
Assuntos
Técnicas Analíticas Microfluídicas , Células Neoplásicas Circulantes , Humanos , Células Neoplásicas Circulantes/patologia , Separação Celular/métodos , Linhagem Celular Tumoral , Microfluídica/métodos , SomRESUMO
As a basis for biometric and chemical analysis, issues of how to dilute or concentrate substances such as particles or cells to specific concentrations have long been of interest to researchers. In this study, travelling surface acoustic wave (TSAW)-based devices with three frequencies (99.1, 48.8, 20.4 MHz) have been used to capture the suspended Polystyrene (PS) microspheres of various sizes (5, 20, 40 µm) in sessile droplets, which are controlled by acoustic field-induced fluid vortex (acoustic vortex) and aggregate into clusters or rings with particles. These phenomena can be explained by the interaction of three forces, which are drag force caused by ASF, ARF caused by Leaky-SAW and varying centrifugal force. Eventually, a novel approach of free transition between the particle ring and cluster was approached via modulating the acoustic amplitude of TSAW. By this method, multilayer particles agglomerate with 20 µm wrapped around 40 µm and 20 µm wrapped around 5 µm can be obtained, which provides the possibility to dilute or concentrate the particles to a specific concentration.
Assuntos
Microfluídica , Som , Acústica , Microesferas , Tamanho da Partícula , Poliestirenos/químicaRESUMO
Graphene nanostructures are widely perceived as a promising material for fundamental components; their high-performance electronic properties offer the potential for the construction of graphene nanoelectronics. Numerous researchers have paid attention to the fabrication of graphene nanostructures, based on both top-down and bottom-up approaches. However, there are still some unavoidable challenges, such as smooth edges, uniform films without folds, and accurate dimension and location control. In this work, a direct writing method was reported for the in-situ preparation of a high-resolution graphene nanostructure of controllable size (the minimum feature size is about 15 nm), which combines the advantages of e-beam lithography and copper-catalyzed growth. By using the Fourier infrared absorption test, we found that the hydrogen and oxygen elements were disappearing due to knock-on displacement and the radiolysis effect. The graphene crystal is also formed via diffusion and the local heating effect between the e-beam and copper substrate, based on the Raman spectra test. This simple process for the in-situ synthesis of graphene nanostructures has many promising potential applications, including offering a way to make nanoelectrodes, NEMS cantilever resonant structures, nanophotonic devices and so on.