The application of heating film to hands reduces the decline in manual dexterity performance associated with cold exposure.

PURPOSE: Exposure to cold temperatures decreases finger temperature (Tfing) and dexterity. Decreased manual function and dexterity can be serious safety risks, especially in tasks that require fine motor movements that must be performed outdoors. The aim of this study was to determine whether hand heating with a minimal power requirement (14.8 W) results in a smaller reduction in Tfing and manual dexterity performance during mild cold exposure compared to a non-heated control condition. METHODS: In a randomized crossover design, twenty-two healthy participants were exposed to a moderately cold environment (5  ºC) for 90 min. One condition had no intervention (CON), while the other had the palmar and dorsal hands heated (HEAT) by using electric heating films. Tfing and cutaneous vascular conductance (CVC) were continuously monitored using laser Doppler flowmetry. Manual dexterity performance and cognitive function were assessed by the Grooved Pegboard Test (GPT) and Stroop Color-Word (SCW) test, respectively, during the baseline period and every 30 min during the cold exposure. RESULTS: After the cold exposure, Tfing was higher in HEAT relative to CON (CON 9.8 vs. HEAT 13.7 ºC, p < 0.0001). GPT placing time, as an index of dexterity performance, was also shorter in HEAT by 14.5% (CON 69.10 ± 13.08 vs. HEAT 59.06 ± 7.99 s, p < 0.0001). There was no difference in CVC between the two conditions during the cold exposure (p > 0.05 for all). Cognitive function was similar between two conditions (p > 0.05 for all). CONCLUSION: The proposed hand heating method offers a practical means of heating fingers to maintain dexterity throughout prolonged cold exposure.

Whole-genome resequencing of 240 Gossypium barbadense accessions reveals genetic variation and genes associated with fiber strength and lint percentage.

KEY MESSAGE: Genetic variation in a G. barbadense population was revealed using resquencing. GWAS on G.barbadense population identified several candidate genes associated with fiber strength and lint percentage. Gossypium barbadense is the second-largest cultivated cotton species planted in the world, which is characterized by high fiber quality. Here, we described the global pattern of genetic polymorphisms for 240 G. barbadense accessions based on the whole-genome resequencing. A total of 3,632,231 qualified single-nucleotide polymorphisms (SNPs) and 221,354 insertion-deletions (indels) were obtained. We conducted a genome-wide association study (GWAS) on 12 traits under four environments. Two traits with more stable associated variants, fiber strength and lint percentage, were chosen for further analysis. Three putative candidate genes, HD16 orthology (GB_D11G3437), WDL2 orthology (GB_D11G3460) and TUBA1 orthology (GB_D11G3471), on chromosome D11 were found to be associated with fiber strength, and one gene orthologous to Arabidopsis Receptor-like protein kinase HERK 1 (GB_A07G1034) was predicated to be the candidate gene for the lint percentage improvement. The identified genes may serve as promising targets for genetic engineering to accelerate the breeding process for G. barbadense and the high-density genome variation map constructed in this work may facilitate our understanding of the genetic architecture of cotton traits.

Improvement of Verticillium Wilt Resistance by Applying Arbuscular Mycorrhizal Fungi to a Cotton Variety with High Symbiotic Efficiency under Field Conditions.

Arbuscular mycorrhizal fungi (AMF) play an important role in nutrient cycling processes and plant stress resistance. To evaluate the effect of Rhizophagus irregularis CD1 on plant growth promotion (PGP) and Verticillium wilt disease, the symbiotic efficiency of AMF (SEA) was first investigated over a range of 3% to 94% in 17 cotton varieties. The high-SEA subgroup had significant PGP effects in a greenhouse. From these results, the highest-SEA variety of Lumian 1 was selected for a two-year field assay. Consistent with the performance from the greenhouse, the AMF-mediated PGP of Lumian 1 also produced significant results, including an increased plant height, stem diameter, number of petioles, and phosphorus content. Compared with the mock treatment, AMF colonization obviously inhibited the symptom development of Verticillium dahliae and more strongly elevated the expression of pathogenesis-related genes and lignin synthesis-related genes. These results suggest that AMF colonization could lead to the mycorrhiza-induced resistance (MIR) of Lumian 1 to V. dahliae. Interestingly, our results indicated that the AMF endosymbiont could directly inhibit the growth of phytopathogenic fungi including V. dahliae by releasing undefined volatiles. In summary, our results suggest that stronger effects of AMF application result from the high-SEA.

The effect of ischemic preconditioning on repeated sprint cycling performance: a randomized crossover study.

BACKGROUND: Ischemic preconditioning (IPC) has been suggested to improve exercise performance by 1-8%. Prior research concerning its impact on short-duration exercises, such as sprints, has been limited and yielded conflicting results. The aim of this study, which included a non-occlusion-based placebo control, was to determine whether IPC improves repeated sprint performance in a manner that accounted for psychophysiological effects. METHODS: Twenty-two healthy males participated in this study, which employed a randomized crossover design. Following the 10-min baseline period, participants received intervention under four different conditions: 1) no-intervention control (CON); 2) non-occlusion-based placebo control (SHAM); 3) remote IPC (RIPC); and 4) local IPC (LIPC). Participants then performed a standardized repeated sprint cycling (5×10s maximal cycling sprint, separated by a 40-s rest in each set). RESULTS: Repeated sprint performance, as indexed by average power output, peak power output, and total work, the improvement was observed in the RIPC and LIPC during the initial phase (set 1-3) when compared with CON (P<0.05). SHAM condition also showed an increase in peak power output in the set 1 (CON 9.97±1.05 vs. SHAM 10.30±1.13 w/kg, P<0.05), which may represent a psychophysiological component in the IPC-induced improvement. Higher lactate concertation was found in the SHAM and LIPC groups, than in the CON group, 5 minutes after the exercise (CON 15.72±0.68 vs. SHAM 16.82±0.41 vs. LIPC 17.19±0.39 mmol/L, P<0.0001 for both, respectively). CONCLUSIONS: In conclusion, LIPC enhanced repeated sprint cycling performance during the initial phase, beyond what could be accounted for entirely by a psychophysiological effect. The improvement associated with RIPC, however, did not surpass the effect of a placebo intervention.

Integrated Dose-Effect Relationship of Near-Infrared Light-Emitting Diode Light on Bone Regeneration in Disuse Osteoporosis Rats.

Objective: To examine the integrated dose-effect relationship of near-infrared (NIR) light-emitting diode (LED) light therapy in promoting bone defect repair in the rat model for osteoporosis (OP). Background: Low-intensity laser therapy has been shown to promote bone regeneration in OP rats. However, its integrated dose-effect relationship is not clear. Methods: Twenty-week-old male Sprague-Dawley rats were randomly assigned to 11 groups: (1) no-treatment control group (C group), (2) tail suspension (TS)-induced disuse OP experimental group (TS-OP group), and (3) OP rats with LED light treatment at nine dosages (L1-L9 groups). The tail of the rat was tied and suspended on the beam of the cage to suspend their hind limbs to induce bone loss for 4 or 7 weeks. The rats were then released and returned to their regular positions. An NIR LED at 810 nm was used on the bilateral hind limbs daily for 4 weeks. The C group rats were not given any treatment. The TS-OP group rats were subjected to identical procedures with L groups, with the exception that the light power was not turned on. After the experiment, the dual-energy X-rays or the microcomputed tomography scan analysis was performed to evaluate bone tissue status. Data analysis was done using SPSS and the health scale. Results: The trabecular thickness, trabecular number, bone volume/total volume, and connectivity density of cancellous bone and the biomechanical properties of femur in light groups were significantly increased compared with the TS-OP group, while the trabecular separation and structure model index were significantly decreased. Conclusions: NIR LED light therapy may promote trabecular bone repair of TS-OP rats. Light intensity influences photobiomodulation. In our dose levels, the greater the light intensity, usually the more effective.

Haploid Bio-Induction in Plant through Mock Sexual Reproduction.

Haploidization is invaluable for basic genetic research and crop breeding. The haploid bio-induction principle is an important topic that remains largely unexplored. In this study, both CenH3 RNAi and in vitro inhibition were used to simulate and induce haploids in allopolyploid crop. Notably, in vitro CenH3 inhibition showed that the results were much the same to that of RNAi in phenotype, chromosome behavior, microspore production, and haploid induction. Cytological analyses of RNAi and inhibitor-treated progenies revealed elimination of chromosomes, defective microspores with empty nuclei, thereby giving rise to pseudo male gametes, and haploid parthenogenesis induction. We found distinct defective empty microspores that were positively correlated with the decrease of CenH3 during RNAi manipulation. Investigation through both in vivo and in vitro studies revealed that haploidization was induced through the pseudo male gamete-mediated mock sexual reproduction. The present results provide insights for the haploid parthenogenesis induction process.

Arbuscular mycorrhizal fungi (AMF) enhanced the growth, yield, fiber quality and phosphorus regulation in upland cotton (Gossypium hirsutum L.).

We previously reported on the strong symbiosis of AMF species (Rhizophagus irregularis CD1) with the cotton (Gossypium hirsutum L.) which is grown worldwide. In current study, it was thus investigated in farmland to determine the biological control effect of AMF on phosphorus acquisition and related gene expression regulation, plant growth and development, and a series of agronomic traits associated with yield and fiber quality in cotton. When AMF and cotton were symbiotic, the expression of the specific phosphate transporter family genes and P concentration in the cotton biomass were significantly enhanced. The photosynthesis, growth, boll number per plant and the maturity of the fiber were increased through the symbiosis between cotton and AMF. Statistical analysis showed a highly significant increase in yield for inoculated plots compared with that from the non inoculated controls, with an increase percentage of 28.54%. These findings clearly demonstrate here the benefits of AMF-based inoculation on phosphorus acquisition, growth, seed cotton yield and fiber quality in cotton. Further improvement of these beneficial inoculants on crops will help increase farmers' income all over the world both now and in the future.