RESUMO
The conversion of methane, CH4, into higher value chemicals using low temperature plasmas is challenged by both improving efficiency and selectivity. One path toward selectivity is capturing plasma-produced methyl radicals, CH3, in a solvent for aqueous processing. Due to the rapid reactions of methyl radicals in the gas phase, the transport distance from the production of the CH3 to its solvation should be short, which then motivates the use of microplasmas. The generation of CH3 in Ar/CH4/H2O plasmas produced in nanosecond pulsed dielectric barrier discharge microplasmas is discussed using results from a computational investigation. The microplasma is sustained in the channel of a microfluidic chip in which the solvent flows along one wall or in droplets. CH3 is primarily produced by electron-impact of and dissociative excitation transfer to CH4, as well as CH2 reacting with CH4. CH3 is rapidly consumed to form C2H6 which, in spite of being subject to these same dissociative processes, accumulates over time, as do other stable products including C3H8 and CH3OH. The gas mixture and electrical properties were varied to assess their effects on CH3 production. CH3 production is largest with 5% CH4 in the Ar/CH4/H2O mixture due to an optimal balance of electron-impact dissociation, which increases with CH4 percentage, and dissociative excitation transfer and CH2 reacting with CH4, which decreases with CH4 percentage. Design parameters of the microchannels were also investigated. Increasing the permittivity of the dielectrics in contact with the plasma increased the ionization wave intensity, which increased CH3 production. Increased energy deposition per pulse generally increases CH3 production as does lengthening pulse length up to a certain point. The arrangement of the solvent flow in the microchannel can also affect the CH3 density and fluence to the solvent. The fluence of CH3 to the liquid solvent is increased if the liquid is immersed in the plasma as a droplet or is a layer on the wall where the ionization wave terminates. The solvation dynamics of CH3 with varying numbers of droplets was also examined. The maximum density of solvated methyl radicals CH3aq occurs with a large number of droplets in the plasma. However, the solvated CH3aq density can rapidly decrease due to desolvation, emphasizing the need to quickly react with the solvated species in the solvent.
RESUMO
Gas hydrates form at high pressure and low temperatures in marine sediments and permafrost regions of the earth. Despite forming in nanoporous structures, gas hydrates have been extensively studied only in bulk. Understanding nucleation and growth of gas hydrates in nonporous confinement can help create ways for storage and utilization as a future energy source. Herein, we introduce a new method for studying crystal orientation/tilt during tetrahydrofuran (THF) hydrate crystallization under the influence of nano-confinement using polarized Raman spectroscopy. Uniform cylindrical nanometer size pores of anodic aluminum oxide (AAO) are used as a model nano-confinement, and hydrate experiments are performed in a glass microsystem for control of the flash hydrate nucleation kinetics and analysis via in situ polarized Raman spectroscopy. The average THF hydrate crystal tilt of 56 ± 1° and 30.5 ± 0.5° were observed for the 20 nm and 40 nm diameter pores, respectively. Crystal tilt observed in 20 and 40-nanometer-size pores was proportional to the pore diameter, resulting in lower tilt relative to the axis of the confinement at larger diameter pores. The results indicate that the hydrates nucleation and growth mechanism can depend on the nanoconfinement size. A 1.6 ± 0.01 °C to 1.8 ± 0.01 °C depression in melting point compared to the bulk is predicted using the Gibbs-Thomson equation as a direct effect of nucleation in confinement on the hydrate properties.