Impaired Capillary Recruitment Capacity in Obesity: A Subgroup Analysis of Prospective Observational Study on Anesthesia Effects.

BACKGROUND This subgroup analysis of prospective observational research, involving 71 participants, compared the effects of anesthesia on microvascular reactivity in obese vs lean individuals using near-infrared spectroscopy and vascular occlusion tests. The correlation between the body mass index (BMI) and microvascular reactivity under general anesthesia was also investigated. MATERIAL AND METHODS This study enrolled adult patients classified as American Society of Anesthesiologists physical status I or II, undergoing elective surgery under general anesthesia. The microcirculatory variables measured before (Tpre) and 30 min following the induction of anesthesia (Tpost) were as follows: baseline tissue oxygen saturation (StO2), occlusion slope (∇occl), and recovery slope (∇recov). The patients were grouped according to their BMI (lean [BMI <25 kg/m²] vs obese [BMI ≥25 kg/m²]). Data are presented as medians and interquartile ranges. RESULTS There were 43 patients in the lean group and 28 in the obese group. At Tpre, baseline StO2, ∇occl, and ∇recov were not different between the 2 groups (P=0.860, 0.659, and 0.518, respectively). At Tpost, the baseline StO2 and ∇occl were not different between the 2 groups (P=0.343 and 0.791); however, the ∇recov was lower in the obese group than in the lean group (3.245 [2.737, 3.977] vs 4.131 [3.491, 4.843], P=0.003). At Tpost, BMI showed a moderate correlation with ∇recov (correlation coefficient: -0.319, P=0.007). CONCLUSIONS In obese patients, capillary recruitment capacity during general anesthesia is compromised compared to lean patients.

Impact of Nonselective and Selective α-1 Adrenergic Blockers on the Sedative Efficacy of Dexmedetomidine in Urologic Surgery: A Prospective, Observational Study.

BACKGROUND This study aimed to compare the impact of a-1 adrenergic blockers - nonselective (alfuzosin, doxazosin, and terazosin) and selective (silodosin and tamsulosin) - on the sedative effects of the alpha-2 adrenergic agonist dexmedetomidine (DMT) in patients undergoing urologic surgery. The primary outcome was the sedative effect of DMT as determined by the bispectral index (BIS) and Modified Observer's Assessment of Alertness/Sedation (MOAA/S) scale scores. MATERIAL AND METHODS One hundred eighteen patients undergoing elective urologic surgery with spinal anesthesia were recruited. Patients were assigned based on their medication status to group N (no medication; n=33), group NS (nonselective alpha-1 blocker; n=27), or group S (selective alpha-1 blocker; n=58). Mean blood pressure (MBP), heart rate (HR), oxygen saturation (SpO2), BIS, and MOAA/S scale scores were recorded at 5-minute (min) intervals after DMT administration. RESULTS Group NS had significantly higher BIS scores than groups N and S at 25 min (P=0.045) and 30 min (P=0.030) after DMT administration, indicating lower sedation levels. MBP significantly differed between the 3 groups at all time points, with group N experiencing a lower MBP than groups NS and S. No significant differences were found between the groups in MOAA/S scale scores, SpO2, or HR. CONCLUSIONS Nonselective alpha-1 adrenergic blockers can reduce the sedative effects of DMT. Consequently, there may be a need for individualized anesthesia management considering the specific subtype of alpha-1 adrenergic blocker medication.

A Study of 57 Patients with Prostate Cancer to Compare Outcomes of Estimated Blood Loss and Postoperative Pain Between Robot-Assisted Laparoscopic Radical Prostatectomy and Standard Laparoscopic Radical Prostatectomy.

BACKGROUND Robot-assisted radical prostatectomy (RARP) is becoming an increasingly common method for treatment of prostate cancer. This study aimed to compare outcomes of estimated blood loss and postoperative pain, determined by patient-controlled analgesia (PCA), between RARP and standard laparoscopic radical -prostatectomy (LRP). MATERIAL AND METHODS We enrolled 57 patients who had localized prostate cancer (28 patients in RARP, 29 patients in LRP). Primary outcomes were estimated blood loss (EBL) measured by gravimetric method for gauze and visual estimation for suction bottle, and PCA bolus count that the bolus doses were injected at the 1st, the 6th, the 24th, and the 48th hour after the operation. We recorded anesthesia and operation time, pneumoperitoneum duration, vital signs, fluid volume, and remifentanil use. Using the numeric rating scale (NRS), adverse effects were checked at the 1st, the 6th, the 24th, and the 48th hour and patient satisfaction was assessed at the 48th hour after the operation. RESULTS Anesthesia time, operation time, and gas insufflation time were longer (P=0.001, P=0.003, P=0.021), and patient-controlled analgesia (PCA) bolus counts at the 1st hour after the operation and volumes of administered crystalloid and remifentanil were higher in the RARP group than in the LRP group (P=0.013, P=0.011, P=0.031). There were no significant differences in EBL. CONCLUSIONS The RARP group required longer anesthetic time and more analgesics during the acute postoperative period compared to the LRP group. Regarding anesthesia, LRP is as good a surgical procedure as RARP until the operation time and the number of ports are reduced.

Highly efficient hybrid energy generator: coupled organic photovoltaic device and randomly oriented electrospun poly(vinylidene fluoride) nanofiber.

A hybrid architecture consisting of an inverted organic photovoltaic device and a randomly-oriented electrospun PVDF piezoelectric device was fabricated as a highly-efficient energy generator. It uses the inverted photovoltaic device with coupled electrospun PVDF nanofibers as tandem structure to convert solar and mechanical vibrations energy to electricity simultaneously or individually. The power conversion efficiency of the photovoltaic device was also significantly improved up to 4.72% by optimized processes such as intrinsic ZnO, MoO3 and active layer. A simple electrospinning method with the two electrode technique was adopted to achieve a high voltage of - 300 mV in PVDF piezoelectric fibers. Highly-efficient HEG using voltage adder circuit provides the conceptual possibility of realizing multi-functional energy generator whenever and wherever various energy sources are available.

A technique for the non-destructive EUV mask sidewall angle measurement using scanning electron microscope.

EUV mask absorber sidewall angle should be measured for mask Optical Proximity Correction and shadow effect estimation. Hence, verifying the three-dimensional profile of mask topography has become a challenge in EUV mask inspection. This paper evaluates EUV mask sidewall angle measurement by Field-Emission Critical Dimension (CD)-Scanning Electron Microscope (SEM) using JEOL JSM-7401F. SEM only produces two-dimensional gray images. Forming three-dimensional profiles from these images is a critical requirement for the sidewall angle measurement. To obtain three-dimensional information, absorber edge width has to be measured first to measure sidewall angle. We can calculate absorber sidewall angle with the exactly measured edge width and absorber height. Edge width narrows with steeper sidewall angle. We used the image processing function of Matlab to obtain absorber edge width accurately. In the end, every measured sidewall angle was compared to Transmission Electron Microscope (TEM) images to evaluate the validity of SEM results. Measured sidewall angles by SEM and TEM cross-section images have average tolerances of 0.62 degrees.

Effect of glycerol on retention time and electrical properties of polymer bistable memory devices based on glycerol-modified PEDOT:PSS.

The addition of glycerol to Poly(3,4-ethylenedioxythiophene):Poly(styrene sulfonate) (PEDOT:PSS) films affected the bipolar switching characteristics of nonvolatile polymer memory devices (PMDs). Increasing the glycerol/PEDOT:PSS ratio caused increase in the OFF-current of the PMDs, but did not affect the ON-current levels. This result demonstrates that highly-conductive current paths occur in the ON-state. The write-read-erase-read cycle test was operated > 10(5) times. And, the ON-retention time is largely dependent on the glycerol to PEDOT:PSS ratio and annealing temperature. In addition, AFM analysis on the G-PEDOT:PSS films to see how the surface morphology of G-PEDOT:PSS layer influences the retention time properties was carried out.

New analytical drain current model for the sub-linear region of output characteristics of graphene field-effect transistors in the low carrier density limit.

A new analytical drain current model for a quantitative description of output characteristics of graphene field-effect transistors (GFETs) in the sub-linear region is derived from a previously-developed diffusion-drift theory for GFETs. To simplify calculation, the diffusion-to-drift current ratio is assumed to be constant along the graphene channel, and a reasonable representative value of the ratio is used instead. In addition, the analytical modeling is conducted in the low-carrier-density limit where carrier velocity at the source end is lower than saturation velocity caused by optical phonon emission. This limit facilitates correct explanation of the peculiar behavior of output characteristics that has been attributed to an ambipolar property of graphene. For realistic simulation, extrinsic series resistances are considered, and carrier mobility degraded by vertical electric field is calculated from a modified classical formula. The output characteristics of GFETs in the sub-linear region can properly be reproduced by the new model, and good agreement between simulation results and several sets of experimental data taken from previous literatures is obtained in this region.

Effects of substrate on piezoelectricity of electrospun poly(vinylidene fluoride)-nanofiber-based energy generators.

We report the effects of various substrates and substrate thicknesses on electrospun poly(vinylidene fluoride) (PVDF)-nanofiber-based energy harvesters. The electrospun PVDF nanofibers showed an average diameter of 84.6 ± 23.5 nm. A high relative ß-phase fraction (85.2%) was achieved by applying high voltage during electrospinning. The prepared PVDF nanofibers thus generated considerable piezoelectric potential in accordance with the sound-driven mechanical vibrations of the substrates. Slide glass, poly(ethylene terephthalate), poly(ethylene naphthalate), and paper substrates were used to investigate the effects of the intrinsic and extrinsic substrate properties on the piezoelectricity of the energy harvesters. The thinnest paper substrate (66 µm) with a moderate Young's modulus showed the highest voltage output (0.4885 V). We used high-performance 76, 66, and 33 µm thick papers to determine the effect of paper thickness on the output voltage. The thinnest paper substrate resulted in the highest voltage output (0.7781 V), and the numerical analyses of the sound-driven mechanical deformation strongly support the hypothesis that substrate thickness has a considerable effect on piezoelectric performance.

Novel electrical properties of nanoscale thin films of a semiconducting polymer: quantitative current-sensing AFM analysis.

Thin films (20-150 nm thickness) of poly(o-anthranilic acid) with various doping levels were prepared on silicon substrates with deposited indium tin oxide, and their topography and current-voltage (I-V) characteristics were quantitatively investigated using current-sensing atomic force microscopy with a platinum-coated tip. The films were found to have a surface morphology like that of orange peel, with a periodic modulation and a surface roughness. The films exhibited nonuniform current flows and I-V characteristics that depended on the doping level as well as on the film thickness. Films with a high doping level were found to exhibit Zener diode switching behavior, whereas the films with a very low doping level (or that were dedoped) exhibited no current flow at all, and so are insulators. Interestingly, self-doped films (which are at an intermediate doping level) were found to have a novel electrical bistability, i.e., a switching characteristic like that of Schottky diodes, and increasingly insulating characteristics as the film thickness was increased. The films with thickness < or =62 nm, which exhibited this novel and stable electrical bistability, can potentially be used in the fabrication of high-density, stable, high-performance digital nonvolatile memory devices based only on transistors. The measured current images and I-V characteristics indicate that the electrical switching and bistability of the films are governed by local filament formation and charge traps.