Effectiveness Analysis for Smart Construction Safety Technology (SCST) by Test Bed Operation on Small- and Medium-Sized Construction Sites.

In the global construction industry, government policies have recently focused on smart construction technologies, such as those concerning the "smartization" of construction, improvements of productivity, and automation technologies. In addition, smart construction safety technologies (SCSTs) have been developed to ensure workers' safety, under the initiative of the private sector. In regards to overseas occupational safety, wearable technologies have been developed for various types of industries, and the integrated platform developments needed to link them have become mainstream. In South Korea, individual companies are focusing on developing basic SCSTs and platforms for integrated control, aiming to prevent accidents in the construction field. The goal of this study was to identify the pros and cons of SCSTs through test bed operation and to derive improvement directions. Therefore, a test bed embedded with SCSTs was built and operated to provide effective safety management for small- and medium-sized sites exposed to fatal accidents. From analyzing the data from the test bed, it was found that it is difficult to change the tendencies of workers' behaviors based solely on the introduction of SCSTs. This indicates that the effects of SCSTs are insignificant without the cooperation of workers. In addition, technical problems in field application were identified for each sensor and equipment, and the necessity, problems, and effectiveness of SCSTs were analyzed. As a result, both the installation and attachment types were found to be effective; however, workers avoided wearing certain attachment types. Based on the results derived through analysis of the pros and cons of SCSTs, the directions and guidelines were suggested for future use. This result can be used for future technology development directions, and policy establishment. Additionally, for the activation of SCSTs in the field, the cooperation of workers and the interest of managers remain essential factors, and improvements to the equipment are required.

Dilute sulfuric acid fractionation of Korean food waste for ethanol and lactic acid production by yeast.

Fermentation of food waste biomass can be used to produce biochemicals such as lactic acid and ethanol in a cost-effective manner. Korean food waste (KFW) dewatered by a screw press contains 23.1% glucan on a dry basis and is a potential raw material for the production of ethanol and lactic acid through fermentation. This study was conducted to optimize the dilute acid fractionation conditions for KFW fermentation with respect to the H2SO4 concentration (0-0.8% w/v), temperature (130-190 °C), and residence time (1-128 min) using response surface methodology. Dilute sulfuric acid fractionation was carried out using a 30-mL stainless steel reactor under conditions, and then the dilute acid fractionation was scaled-up in 1-L and 7-L stainless steel reactors under the optimal conditions. The hydrolysate was concentrated, liquid-liquid extracted and neutralized for lactic acid and ethanol production. The highest concentration of glucose obtained from the KFW was 26.4 g/L using fractionation with 0.37% w/v H2SO4 at 156 °C for 123.6 min. Using recombinant Saccharomyces cerevisiae containing a codon-optimized lactate dehydrogenase, the yield of lactic acid and ethanol was 77% of the theoretical yield for 17.4 g/L of fermentable sugar at pH 5.5. Additionally, the yield of ethanol produced by Issatchenkia orientalis was 89% of the theoretical yield for 25 g/L of fermentable sugar at pH 3.