RESUMO
BACKGROUND: The thermal stability of viruses in gelatin liquid formulations for medical research and application is poorly understood and this study aimed to examine the thermal stability of 4 enveloped and nonenveloped DNA and RNA viruses in hydrolyzed gelatin liquid formulations. METHODS: Bovine herpesvirus (BHV) was used as a model virus to examine the molecular weight (MW), concentration and gelatin type and to optimize virus stability in liquid formulations at 25 °C and 4 °C. Using the model virus liquid formulation, the stability of multiple enveloped and nonenveloped RNA and DNA viruses, including parainfluenza virus, reovirus (RV), BHV, and adenovirus (AdV), was monitored over up to a 30-week storage period. RESULTS: The BHV model virus was considered stable after 3 weeks in hydrolyzed gelatin (MW: 4000) with a 0.8 LRV (log10 reduction value) at 25 °C or a 0.2 LRV at 4 °C, compared to the stabilities observed in higher MW gelatin (60,000 and 160,000) with an LRV above 1. Based on the gelatin type, BHV in alkaline-treated hydrolyzed gelatin samples were unexpectantly more stable than in acid-treated hydrolyzed gelatin sample. All four viruses exhibited stability at 4 °C for at least 8 weeks, BHV or AdV remained stable for over 30 weeks of storage, and at 25 °C, AdV and RV remained stable for 8 weeks. CONCLUSION: The results demonstrated that 5% of 4000 MW hydrolyzed gelatin formulation can act as a relevant stabilizer for the thermal stability of viruses in medical research and application.
Assuntos
Vírus de RNA , Vírus , Adenoviridae , Vírus de DNA , GelatinaRESUMO
The local injection of therapeutic drugs, including cells, oncolytic viruses and nucleic acids, into different organs is an administrative route used to achieve high drug exposure at the site of action. However, after local injection, material backflow and side effect reactions can occur. Hence, this study was carried out to investigate the effect of gelatin on backflow reduction in local injection. Gelatin particles (GPs) and hydrolyzed gelatin (HG) were injected into tissue models, including versatile training tissue (VTT), versatile training tissue tumor-in type (VTT-T), and broiler chicken muscles (BCM), using needle gauges between 23 G and 33 G. The backflow material fluid was collected with filter paper, and the backflow fluid rate was determined. The backflow rate was significantly reduced with 35 µm GPs (p value < .0001) at different concentrations up to 5% and with 75 µm GPs (p value < .01) up to 2% in the tissue models. The reduction in backflow with HG of different molecular weights showed that lower-molecular-weight HG required a higher-concentration dose (5% to 30%) and that higher-molecular-weight HG required a lower-concentration dose (7% to 8%). The backflow rate was significantly reduced with the gelatin-based formulation, in regard to the injection volumes, which varied from 10 µL to 100 µL with VTT or VTT-T and from 10 µL to 200 µL with BCM. The 35 µm GPs were injectable with needles of small gauges, which included 33 G, and the 75 µm GPs and HG were injectable with 27 G needles. The backflow rate was dependent on an optimal viscosity of the gelatin solutions. An optimal concentration of GPs or HG can prevent material backflow in local injection, and further studies with active drugs are necessary to investigate the applicability in tumor and organ injections.