Copper release rate needed to inhibit fouling on the west coast of Sweden and control of copper release using zinc oxide.

How zinc oxide influences copper release has been tested and the lowest release rate of copper from various combinations of copper and zinc in a paint matrix evaluated, whilst still deterring macrofouling, including barnacles and bryozoans. Copper (I) oxide was added to a generic AF paint in 0, 8.5, 11.7 or 16.3 wt% copper oxide in combination with 0, 10 or 20 wt% zinc oxide and applied on PMMA panels. The results show that zinc influences the release rate of copper. When 10 and 20 wt% zinc was added, the total amount of copper released significantly increased by on average 32 and 47% respectively. All treatments that included copper were successful in deterring macrofouling, including the treatment with the lowest average Cu release rate, ie 4.68 µg cm-2 day-1.

Oxygen-depleted surfaces: a new antifouling technology.

A novel, non-toxic strategy to combat marine biofouling is presented. The technology is paint with additions of up to 43% of industrial protein. Through microbial degradation of the protein component, an oxygen-depleted layer rapidly forms in a 0.2 mm layer close to the paint surface. With the present paint formulations, a stable, O(2)-depleted layer can persist for 16 weeks. Barnacle larvae (cyprids) did not settle on panels where oxygen saturation was <20%, and cyprids were killed when exposed to O(2)-free water for more than 1 h. It is also shown that the O(2)-depleted layer will rapidly reform (within 15 min) after exposure to turbulent flow. Field exposure of panels for 16 weeks showed that paint with protein reduced fouling by barnacles and bryozoans by 80% and close to 100%, respectively. The results suggest that this novel technology may be developed into a non-toxic alternative to copper-based antifouling paints, especially for pleasure boats in sensitive environments. There is clearly potential for further development of the paint formulation, and a full-scale test on a boat-hull suggested that service-life under realistic operations needs to be improved.

A state-of-the-art model for spatial and stochastic oil spill risk assessment: A case study of oil spill from a shipwreck.

Oil spills are serious environmental issues that potentially can cause adverse effects on marine ecosystems. In some marine areas, like the Baltic Sea, there is a large number of wrecks from the first half of the 20th century, and recent monitoring and field work have revealed release of oil from some of these wrecks. The risk posed by a wreck is governed by its condition, hazardous substances contained in the wreck and the state of the surrounding environment. Therefore, there is a need for a common standard method for estimating the risks associated with different wrecks. In this work a state-of-the-art model is presented for spatial and stochastic risk assessment of oil spills from wrecks, enabling a structured approach to include the complex factors affecting the risk values. A unique feature of this model is its specific focus on uncertainty, facilitating probabilistic calculation of the total risk as the integral expected sum of many possible consequences. A case study is performed in Kattegat at the entrance region to the Baltic Sea to map the risk from a wreck near Sweden. The developed model can be used for oil spill risk assessment in the marine environment all over the world.

In situ release rates of Cu and Zn from commercial antifouling paints at different salinities.

Antifouling paints are environmentally risk assessed based on their biocidal release rates to the water phase. In situ release rates of copper (Cu) and zinc (Zn) were derived for five commercial paints in two recreational marinas with different salinities (5 and 14 PSU) using an X-Ray Fluorescence spectrometer (XRF). Salinity was found to significantly affect the Cu release, with twice the amount of Cu released at the higher salinity, while its influence on the Zn release was paint-specific. Site-specific release rates for water bodies with salinity gradients, e.g. the Baltic Sea, are therefore necessary for more realistic risk assessments of antifouling paints. Furthermore, the in situ release rates were up to 8 times higher than those generated using standardized laboratory or calculation methods. The environmental risk assessment repeated with the field release rates concludes that it is questionable whether the studied products should be allowed on the Swedish market.

Induced tolerance in situ to chronically PAH exposed ammonium oxidizers.

Sediment was sampled in the vicinity of a long-term source of Polycyclic Aromatic Hydrocarbons (PAHs) to evaluate whether tolerance can be induced in situ. Total PAH concentrations as well as the bioavailable PAHs were measured, and for nine PAHs the pore water concentration could be calculated. An induced tolerance in the ammonium oxidizing community was detected at the site with highest PAH concentration and tolerance was strongest, although not significantly, correlated to bioavailable alkylated PAHs. In addition, the tolerant microbial community showed a significant lower baseline capability for nitrification with an on average 35% reduction compared to the other sites. Meiofaunal community structure differed between all sites, and the difference was significantly correlated to bioavailable alkylated PAHs and PAH31 concentrations. The results suggest that in order to judge magnitude of long-term effects, the bioavailable fraction is to be preferred, and when possible as estimation of the freely dissolved concentration.

PAH effects on meio- and microbial benthic communities strongly depend on bioavailability.

The effects of anthropogenic pollutants in dissimilar habitats can vary depending on differences in bioavailability. The factors determining bioavailability are not yet fully understood. This study was performed to evaluate whether analysis of total PAH concentrations in sediments is a satisfactory measurement to indicate environmental effects or if bioavailability is needed to be taken into account. We have here performed a 60-day experiment, where nominal PAH concentrations of 1,300 µg/kg sediment were added to three different marine sediments. Meiofaunal and microbial communities were analyzed for alterations in community response at 30 and 60 days. Results showed that bioavailability of PAHs varied between the three different sediments. Nonetheless, the petroleum addition gave rise to significant negative effects on all three sediments at both time points. The two direct measurements of toxicity on the microbial community, potential nitrification and denitrification, displayed a lower effect of the PAH addition in the muddy sediment at both time points, compared to the other two sediment types. No effects were seen in the analysis of meiofaunal community structure. Measurements of PAH bioavailability in the three sediment types concurred with the results from the microbial community, revealing a lower bioavailability in the muddy sediment compared to the other two sediment types, 34% compared to sandy and 18% compared to organic at day 0. At day 60 it was 61% lower compared to sandy and 20% lower compared to organic. The negative effects of the PAH addition on the microbial nitrogen cycle were in six out of eight cases best correlated to the amount of alkylated bioavailable PAH in the sediments, and thus microbial nitrogen cycle is a possible good indicator for assessing PAH-induced stress. The results presented here have implications for risk analysis studies of petroleum-contaminated marine sediments; consequently, sediment characteristics and its effects on bioavailability are important to include. In addition, these results add to the understanding that bioavailability measurements of PAHs are a more correct assessment compared to measurements of total PAH concentrations, and need to be included when estimating effects of PAHs in marine benthic communities.

Meiofaunal and bacterial community response to diesel additions in a microcosm study.

Effects of low PAH-containing diesel were studied in a 60-day microcosm experiment at PAH concentrations 130, 1300 and 13,000µg/kg sediment. Nutrient fluxes, potential nitrification and meiofaunal community composition were analysed at three time points. Changed ∑NOx-fluxes indicated reduced sediment nitrification in Medium and High with time, in agreement with lowered potential nitrification rates in all treatments. Reduction in silicate and phosphate fluxes over time suggested severe effects on activity of meiofauna. Reduced activity increased the anoxic sediment layer, which could have contributed to the changed ∑NOx-fluxes. There were significant differences in meiofaunal community composition after 30 and 60days in Medium and High. Changes were due to increasing numbers of harpacticoids and the foraminiferan group Rotaliina, as well as decreasing numbers of Nematodes and the foraminiferan group Reophax. In spite of the low PAH-level, small additions of this diesel can still have pronounced effects on meiofaunal and bacterial communities.