RESUMO
The characteristics of conductive-bridging random access memory (CBRAM) with amorphous indium-tungsten-zinc-oxide (a-InWZnO) switching layer and copper (Cu) ion-supply layer were prepared by sputtering. It was found that the doping ratio of tungsten has a significant effect on the memory characteristics of the CBRAM, and the doping of tungsten acts as a suppressor of oxygen vacancies in the InWZnO film. The O 1s binding energy associated with the oxygen-deficient regions in the α-InWZnO thin film decreases with increasing tungsten doping ratio, which can be demonstrated by x-ray photoelectron spectroscopy. When the tungsten doping ratio is 15%, the a-InWZnO CBRAM can achieve the excellent memory characteristics, such as high switching endurance (up to 9.7 × 103 cycling endurance), low operating voltage, and good retention capability. Moreover, the electrical uniformity and switching behavior of InWZnO device are evidently improved as the doping ratio of tungsten in the switching layer increases. These results suggest that CBRAM based on novel material InWZnO have great potential to be used in high-performance memory devices.
RESUMO
A solution-grown subwavelength antireflection coating has been investigated for enhancing the photovoltaic efficiency of thin film solar cells. The 100-nm-height ZnO nanorods coating benefited the photocurrent of Cu(In,Ga)Se2 solar cells from 31.7 to 34.5 mA/cm2 via the decrease of surface light reflectance from 14.5% to 7.0%, contributed by the gradual refractive index profile between air and AZO window layer. The further reduction of surface reflectance to 2.3% in the case of 540-nm-height nanorods, yet, lowered the photocurrent to 29.5 mA/cm2, attributed to the decrease in transmittance. The absorption effect of hydrothermal grown ZnO nanorods was explored to optimize the antireflection function in enhancing photovoltaic performances.
RESUMO
In this work, the authors demonstrate a novel vertically-stacked thin film transistor (TFT) architecture for heterogeneously complementary inverter applications, composed of p-channel polycrystalline silicon (poly-Si) and n-channel amorphous indium tungsten oxide (a-IWO), with a low footprint than planar structure. The a-IWO TFT with channel thickness of approximately 3-4 atomic layers exhibits high mobility of 24 cm2 V-1 s-1 , near ideally subthreshold swing of 63 mV dec-1 , low leakage current below 10-13 A, high on/off current ratio of larger than 109 , extremely small hysteresis of 0 mV, low contact resistance of 0.44 kΩ-µm, and high stability after encapsulating a passivation layer. The electrical characteristics of n-channel a-IWO TFT are well-matched with p-channel poly-Si TFT for superior complementary metal-oxide-semiconductor technology applications. The inverter can exhibit a high voltage gain of 152 V V-1 at low supply voltage of 1.5 V. The noise margin can be up to 80% of supply voltage and perform the symmetrical window. The pico-watt static power consumption inverter is achieved by the wide energy bandgap of a-IWO channel and atomically-thin channel. The vertically-stacked complementary field-effect transistors (CFET) with high energy-efficiency can increase the circuit density in a chip to conform the development of next-generation semiconductor technology.
RESUMO
This work presents a novel method to form polycrystalline Cu(In(1-x)Ga(x))Se(2) (CIGS) thin film by co-sputtering of InâSe and CuâGa alloy targets without an additional selenization process. An attempt was also made to thoroughly elucidate the surface morphology, crystalline phases, physical properties, and chemical properties of the CIGS films by using material analysis methods. Experimental results indicate that CIGS thin films featured densely packed grains and chalcopyrite phase peaks of (112), (220), (204), (312), and (116). Raman spectroscopy analysis revealed chalcopyrite CIGS phase with Raman shift at 175 cm(-1), while no signal at 258 cm(-1) indicated the exclusion of Cu(2-x)Se phase. Hall effect measurements confirmed the polycrystalline Cu(In,Ga)Se2 thin film to be of p type semiconductor with a film resistivity and mobility of 2.19×10(2) Ω cm and 88 cm(2)/V s, respectively.
RESUMO
In this study, the influence of oxygen concentration in InWZnO (IWZO), which was used as the switching layer of conductive bridge random access memory, (CBRAM) is investigated. With different oxygen flow during the sputtering process, the IWZO film can be fabricated with different oxygen concentrations and different oxygen vacancy distribution. In addition, the electrical characteristics of CBRAM device with different oxygen concentration are compared and further analyzed with an atomic force microscope and X-ray photoelectron spectrum. Furthermore, a stacking structure with different bilayer switching is also systematically discussed. Compared with an interchange stacking layer and other single layer memory, the CBRAM with specific stacking sequence of bilayer oxygen-poor/-rich IWZO (IWZOx/IWZOy, x < y) exhibits more stable distribution of a resistance state and also better endurance (more than 3 × 104 cycles). Meanwhile, the memory window of IWZOx/IWZOy can even be maintained over 104 s at 85 °C. Those improvements can be attributed to the oxygen vacancy distribution in switching layers, which may create a suitable environment for the conductive filament formation or rupture. Therefore, it is believed that the specific stacking bilayer IWZO CBRAM might further pave the way for emerging memory applications.
RESUMO
The integration of 4 nm thick amorphous indium tungsten oxide (a-IWO) and a hafnium oxide (HfO2) high-κ gate dielectric has been demonstrated previously as one of promising amorphous oxide semiconductor (AOS) thin-film transistors (TFTs). In this study, the more positive threshold voltage shift (∆VTH) and reduced ION were observed when increasing the oxygen ratio during a-IWO deposition. Through simple material measurements and Technology Computer Aided Design (TCAD) analysis, the distinct correlation between different chemical species and the corresponding bulk and interface density of states (DOS) parameters were systematically deduced, validating the proposed physical mechanisms with a quantum model for a-IWO nanosheet TFT. The effects of oxygen flow on oxygen interstitial (Oi) defects were numerically proved for modulating bulk dopant concentration Nd and interface density of Gaussian acceptor trap NGA at the front channel, significantly dominating the transfer characteristics of a-IWO TFT. Furthermore, based on the studies of density functional theory (DFT) for the correlation between formation energy Ef of Oi defect and Fermi level (EF) position, we propose a numerical methodology for monitoring the possible concentration distribution of Oi as a function of a bias condition for AOS TFTs.
RESUMO
In this work, we have successfully demonstrated the junctionless (JL) transistors with two-dimensional-like (2D-like) nano-sheet (NS) material, amorphous indium tungsten oxide (a-IWO), as an active channel layer. The influences of the different gate insulator (GI) materials and the scalings of GI thickness, a-IWO channel thickness, and channel lengths on the a-IWO NS JL transistors (a-IWO NS-JLTs) have been studied for the purposes of low operation voltage (gate voltage ≤2V) and high performance. The 2D-like a-IWO NS-JLTs exhibit low operation voltage, low source/drain (S/D) contact resistance (RC) and other key electrical characteristics, such as high field-effect mobility (µFE), near ideal subthreshold swing (S.S.), and large ON/OFF currents ratio (ION/IOFF). The remarkable device characteristics also make the proposed 2D-like a-IWO NS-JLTs promising for system-on-panel (SoP) and vertically stacked (VS) hybrid CMOS applications.
RESUMO
The flexible conductive-bridging random access memory (CBRAM) device using a Cu/TiW/Ga2O3/Pt stack is fabricated on polyimide substrate with low thermal budget process. The CBRAM devices exhibit good memory-resistance characteristics, such as good memory window (>105), low operation voltage, high endurance (>1.4 × 102 cycles), and large retention memory window (>105). The temperature coefficient of resistance in the filament confirms that the conduction mechanism observed in the Ga2O3 layer is similar with the phenomenon of electrochemical metallization (ECM). Moreover, the performance of CBRAM device will not be impacted during the flexibility test. Considering the excellent performance of the CBRAM device fabricated by low-temperature process, it may provide a promising potential for the applications of flexible integrated electronic circuits.
RESUMO
In this study, hydrogen peroxide (H2O2) cosolvent, which was dissolved into supercritical-phase carbon dioxide fluid (SCCO2), is employed to passivate excessive oxygen vacancies of the high-mobility tungsten-doped indium oxide without any essential thermal process. With the detailed material analysis, the internal physical mechanism of the cosolvent effect or the interaction between the cosolvent solution and supercritical-phase fluid is well discussed. In addition, the optimized result has been applied for the thin film transistor device fabrication. As a result, the device with SCCO2 + H2O2 treatment exhibits the lowest subthreshold swing of 82 mV/dec, the lowest interface trap density of 8.76 × 1011 eV-1 cm-2, the lowest hysteresis of 47 mV, and an excellent reliability and uniformity characteristic compared with any other control groups. Besides, an extremely high field-effect mobility of 98.91 cm2/V s can also be observed, while there is even a desirable positive shift for the threshold voltage. Notably, compared with the untreated sample, the highest on/off current ratio of 5.11 × 107 can be achieved with at least four orders of magnitude enhancement by this unique treatment.
RESUMO
A single layer of amorphous InZnO is chosen as the channel material for a thin film transistor (TFT)-based driver and sensing layer for a blue-light sensor, respectively, with a completely compatible process integrated into in-cell embedded photo sensor architecture. The photo sensor exhibits a high optical responsivity (1280 A/W) and excellent signal to noise ratio (~105) under the blue light illumination. Afterwards, the detail studies and important issues about the sensing and material characteristics of a-IZO thin film in the TFT sensor are well discussed. The results suggest that the numbers of the deep, neutral oxygen vacancy are the key factors for carrier generation under illumination. In addition, a positive gate pulse is applied on the devices to eliminate persistent photoconductivity in order to ensure the recover ability for the photo sensor application. The practical concepts of a sensor circuit, which can be integrated on RGB pixel with interactive display, are also proposed on the basis of photo sensor TFT.
RESUMO
This study investigates the electrical characteristics and physical analysis for an amorphous tungsten-doped indium-zinc oxide thin film transistor with different backchannel passivation layers (BPLs), which were deposited by an ion bombardment-free process. A 10 times increase in mobility was observed and attributed to the generation of donor-like oxygen vacancies at the backchannel, which is induced by the oxygen desorption and Gibbs free energy of the BPL material. The mechanism was well studied by XPS analysis. On the other hand, a HfO2 gate insulator was applied for the InWZnO TFT device to control the extremely conductive channel and adjust the negative threshold voltage. With both a HfO2 gate insulator and a suitable BPL, the InWZnO TFT device exhibits good electrical characteristics and a remarkable lifetime when exposed to the ambient air.
RESUMO
In this study, a non-selenized CuInGaSe2 (CIGS) solar device with textured zinc oxide (ZnO) antireflection coatings was studied. The ZnO nanostructure was fabricated by a low-temperature aqueous solution deposition method. With controlling the morphology of the solution-grown tapered ZnO nanorod coatings, the average reflectance of the CIGS solar device decreased from 8.6% to 2.1%, and the energy conversion efficiency increased from 9.1% to 11.1%. The performance improvement in the CuInGaSe2 thin-film solar cell was well explained due to the gradual increase of the refractive index between air and the top electrode of solar cell device by the insertion of the ZnO nanostructure. The results demonstrate a potential application of the ZnO nanostructure array for efficient solar device technology.
RESUMO
Supercritical fluid (SCF) technology is employed at low temperature as a postgate dielectric treatment to improve gate SiO(2)germanium (Ge) interface in a Ge-based metal-oxide-semiconductor (Ge-MOS) device. The SCF can transport the oxidant and penetrate the gate oxide layer for the oxidation of SiO(2)Ge interface at 150 degrees C. A smooth interfacial GeO(2) layer between gate SiO(2) and Ge is thereby formed after SCF treatment, and the frequency dispersion of capacitance-voltage characteristics is also effectively alleviated. Furthermore, the electrical degradation of Ge-MOS after a postgate dielectric annealing at 450 degrees C can be restored to a extent similar to the initial state.