Reactions of permethyltitanocene tucked-in derivatives with carbon dioxide.

Both single tucked-in permethyltitanocene 1 and double tucked-in permethyltitanocene 2 react with excess CO2 by insertion into their Ti-CH2 bonds. The former one precipitates instantly a yellow carboxylate-tethered oligomer [3]n which is insoluble in aprotic solvents and in a vacuum it sublimes as a monomer without decomposition. Computations for n ≤ 4 optimised the structure of the monomer [3] and showed that open chain oligomers bound by dative O → Ti bonds were not sterically hindered. The latter bond dissociates when [3]n is oxidized by chlorination with CDCl3 or CD2Cl2 to give Ti(IV) chloride 4 or upon metathesis of [3]n with Me3SiCl yielding Ti(III) chloride 5. Oxidative addition of MeCN affords a C-C coupled dinuclear titanocene diimine 6. Compound [3]n also reacts with 1 to give the tethered carbodiolate 8 or with [Cp*2TiH] (where Cp* = η5-C5Me5) to give the half-tethered carbodiolate 10. The non-tethered carbodiolate 12 was obtained from [Cp*2TiH] and CO2 yielding titanocene formate by reaction of the latter with another equivalent of [Cp*2TiH]. All these carbodiolates contain Ti(III) metal atoms forming electronic triplet states of axial or orthorhombic symmetry. In contrast to the rapidly reacting 1 compound 2 reacts with excess CO2 slowly in m-xylene at 100 °C using only one of its two Ti-CH2 moieties. The structure of the obtained carbodiolate 13 indicates that the primary product analogous to 3 reacts with 2 more rapidly than with CO2.

Hydrogenation of titanocene and zirconocene bis(trimethylsilyl)acetylene complexes.

Reactions following the addition of dihydrogen under maximum atmospheric pressure to bis(trimethylsilyl)acetylene (BTMSA) complexes of titanocenes, [(η5-C5H5-nMen)2Ti(η2-BTMSA)] (n = 0, 1, 3, and 4) (1A-1D), and zirconocenes, [(η5-C5H5-nMen)2Zr(η2-BTMSA)] (n = 2-5) (4A-4D), proceeded in diverse ways and, depending on the metal, afforded different products. The former complexes lost, in all cases, their BTMSA ligand via its hydrogenation to bis-1,2-(trimethylsilyl)ethane when reacted at 80 °C for a prolonged reaction time. For n = 0, 1, and 3, the titanocene species formed in situ dimerised via the formation of fulvalene ligands and two bridging hydride ligands, giving known green dimeric titanocenes (2A-2C). For n = 4, a titanocene hydride [(η5-C5HMe4)2TiH] (2D) was formed, similarly to the known [(η5-C5Me5)2TiH] (2E) for n = 5; however, in contrast to this example, 2D in the absence of dihydrogen spontaneously dehydrogenated to the known Ti(iii)-Ti(iii) dehydro-dimer [{Ti(η5-C5HMe4)(µ-η1:η5-C5Me4)}2] (3B). This complex has now been fully characterised via spectroscopic methods, and was shown through EPR spectroscopy to attain an intramolecular electronic triplet state. The zirconocene-BTMSA complexes 4A-4D reacted uniformly with one hydrogen molecule to give Zr(iv) zirconocene hydride alkenyls, [(η5-C5H5-nMen)2ZrH{C(SiMe3)[double bond, length as m-dash]CH(SiMe3)}] (n = 2-5) (5A-5D). These were identified through their 1H and 13C NMR spectra, which show features typical of an agostically bonded proton, [double bond, length as m-dash]CH(SiMe3). Compounds 5A-5D formed equilibria with the BTMSA complexes 4A-4D depending on hydrogen pressure and temperature.

Decamethyltitanocene hydride intermediates in the hydrogenation of the corresponding titanocene-(η2-ethene) or (η2-alkyne) complexes and the effects of bulkier auxiliary ligands.

1H NMR studies of reactions of titanocene [Cp*2Ti] (Cp* = η5-C5Me5) and its derivatives [Cp*(η5:η1-C5Me4CH2)TiMe] and [Cp*2Ti(η2-CH2[double bond, length as m-dash]CH2)] with excess dihydrogen at room temperature and pressures lower than 1 bar revealed the formation of dihydride [Cp*2TiH2] (1) and the concurrent liberation of either methane or ethane, depending on the organometallic reactant. The subsequent slow decay of 1 yielding [Cp*2TiH] (2) was mediated by titanocene formed in situ and controlled by hydrogen pressure. The crystalline products obtained by evaporating a hexane solution of fresh [Cp*2Ti] in the presence of hydrogen contained crystals having either two independent molecules of 1 in the asymmetric part of the unit cell or cocrystals consisting of 1 and [Cp*2Ti] in a 2 : 1 ratio. Hydrogenation of alkyne complexes [Cp*2Ti(η2-R1C[triple bond, length as m-dash]CR2)] (R1 = R2 = Me or Et) performed at room temperature afforded alkanes R1CH2CH2R2, and after removing hydrogen, 2 was formed in quantitative yields. For alkyne complexes containing bulkier substituent(s) R1 = Me or Ph, R2 = SiMe3, and R1 = R2 = Ph or SiMe3, successful hydrogenation required the application of increased temperatures (70-80 °C) and prolonged reaction times, in particular for bis(trimethylsilyl)acetylene. Under these conditions, no transient 1 was detected during the formation of 2. The bulkier auxiliary ligands η5-C5Me4tBu and η5-C5Me4SiMe3 did not hinder the addition of dihydrogen to the corresponding titanocenes [(η5-C5Me4tBu)2Ti] and [(η5-C5Me4SiMe3)2Ti] yielding [(η5-C5Me4tBu)2TiH2] (3) and [(η5-C5Me4SiMe3)2TiH2] (4), respectively. In contrast to 1, the dihydride 4 did not decay with the formation of titanocene monohydride, but dissociated to titanocene upon dihydrogen removal. The monohydrides [(η5-C5Me4tBu)2TiH] (5) and [(η5-C5Me4SiMe3)2TiH] (6) were obtained by insertion of dihydrogen into the intramolecular titanium-methylene σ-bond in compounds [(η5-C5Me4tBu)(η5:η1-C5Me4CMe2CH2)Ti] and [(η5-C5Me4SiMe3)(η5:η1-C5Me4SiMe2CH2)Ti], respectively. The steric influence of the auxiliary ligands became clear from the nature of the products obtained by reacting 5 and 6 with butadiene. They appeared to be the exclusively σ-bonded η1-but-2-enyl titanocenes (7) and (8), instead of the common π-bonded derivatives formed for the sterically less congested titanocenes, including [Cp*2Ti(η3-(1-methylallyl))] (9). The molecular structure optimized by DFT for compound 1 acquired a distinctly lower total energy than the analogously optimized complex with a coordinated dihydrogen [Cp*2Ti(η2-H2)]. The stabilization energies of binding the hydride ligands to the bent titanocenes were estimated from counterpoise computations; they showed a decrease in the order 1 (-132.70 kJ mol-1), 3 (-121.11 kJ mol-1), and 4 (-112.35 kJ mol-1), in accordance with the more facile dihydrogen dissociation.

Displacement of ethene from the decamethyltitanocene-ethene complex with internal alkynes, substituent-dependent alkyne-to-allene rearrangement, and the electronic transition relevant to the back-bonding interaction.

The titanocene-ethene complex [Ti(II)(η(2)-C2H4)(η(5)-C5Me5)2] (1) with simple internal alkynes R(1)C≡CR(2) gives complexes [Ti(II)(η(2)-R(1)C≡CR(2))(η(5)-C5Me5)2] {R(1), R(2): Ph, Ph (3), Ph, Me (4), Me, SiMe3 (5), Ph, SiMe3 (6), t-Bu, SiMe3 (7), and SiMe3, SiMe3 (8). In contrast, alkynes with R(1) = Me and R(2) = t-Bu or i-Pr afford allene complexes [Ti(II)(η(2)-CH2=C=CHR(2))(η(5)-C5Me5)2] (11) and (12), whereas for R(2) = Et a mixture of alkyne complex (13A) and minor allene (13) is obtained. Crystal structures of 4, 6, 7 and 11 have been determined; the latter structure proved the back-bonding interaction of the allene terminal double bond. Only the synthesis of 8 from 1 was inefficient because the equilibrium constant for the reaction [1] + [Me3SiC≡CSiMe3] ⇌ [8] + [C2H4] approached 1. Compound 9 (R(1), R(2): Me), not obtainable from 1, together with compounds 3­6 and 10 (R(1), R(2): Et) were also prepared by alkyne exchange with 8, however this reaction did not take place in attempts to obtain 7. Compounds 1 and 3­9 display the longest-wavelength electronic absorption band in the range 670-940 nm due to the HOMO → LUMO transition. The assignment of the first excitation to be of predominantly a b2 → a1 transition was confirmed by DFT calculations. The calculated first excitation energies for 3­9 followed the order of hypsochromic shifts of the absorption band relative to 8 that were induced by acetylene substituents: Me > Ph ≫ SiMe3. Computational results have also affirmed the back-bonding nature in the alkyne-to-metal coordination.

[Mu-1kappa2O,O':2(eta5)-Cyclopentadienylcarboxylato][2(eta5)-diphenylphosphinocyclopentadienyl]bis[1,1(eta5)-tetramethylcyclopentadienyl]iron(II)titanium(III).

Reacting stoichiometric amounts of 1-(diphenylphosphino)ferrocenecarboxylic acid and [Ti(eta(5)-C(5)HMe(4))(2)(eta(2)-Me(3)SiC[triple-bond]CSiMe(3))] produced the title carboxylatotitanocene complex, [[mu-1kappa(2)O,O':2(eta(5))-C(5)H(4)CO(2)][2(eta(5))-C(5)H(4)P(C(6)H(5))(2)][1(eta(5))-C(5)H(CH(3))(4)](2)Fe(II)Ti(III)] or [FeTi(C(9)H(13))(2)(C(6)H(4)O(2))(C(17)H(14)P)]. The angle subtended by the Ti/O/O' plane, where O and O' are the donor atoms of the kappa(2)-carboxylate group, and the plane of the carboxyl-substituted ferrocene cyclopentadienyl is 24.93(6) degree.