En masse retraction of anterior teeth through rapid periodontal distraction by a retraction screw: A randomized control trial.

BACKGROUND: Rapid distraction of the periodontal ligament is an effective method to shorten the orthodontic treatment time. The objectives of the present study were to assess the effects of an HYCON device (Adenta GmbH, Germany) on the rate of en masse retraction of the anterior teeth, duration of retraction, anchorage loss, root resorption, and soft tissue changes. METHODS: This study was conducted on 60 female patients aged >18 years, divided randomly into two equal groups: Group 1 comprised 30 patients with HYCON, and group 2 comprised 30 patients with nickel-titanium closed coil springs. Skeletal, dental, and soft tissue changes were evaluated on pre- and post-retraction lateral cephalograms, and the rates of anterior tooth movement and anchorage loss were assessed monthly on the dental casts of the patients. Root resorption was assessed using intraoral periapical radiograph. Student's t test was used for the analysis of parametric data, and the Mann-Whitney U test was used for nonparametric data. RESULTS: HYCON significantly shortened the retraction duration by 3 months. The rate of anterior teeth retraction was two times faster in group 1, compared with group 2. There was a significant difference in the anchorage loss between the groups in only first 2 months of treatment. Group 2 showed significantly more root resorption and soft tissue changes than group 1 (P < 0.05). CONCLUSIONS: HYCON is an effective device for significantly shortening the duration of retraction with anchorage loss of 2 to 2.5 mm. However, careful monitoring for possible root resorption should be performed.

Comparison of gingival thickness by CBCT versus transgingival probing and estimation of cut-off values for gingival phenotype - A cross-sectional study in adults.

AIM: Gingival phenotype (GP) is regarded as a valuable indicator for forecasting the probability of attaining favourable aesthetic and functional results with orthodontic treatment. This study aimed to investigate the accuracy and reproducibility of cone beam computed tomography (CBCT) for assessing gingival thickness (GT) in both arches compared to the transgingival probing method. The secondary objective was to determine the optimal cut-off values for GT using CBCT. METHODS: This cross-sectional study was conducted where GP was determined based on the probe transparency method (TRAN). The GT measurements were obtained by both methods at 2mm from the free gingival margin (FGM) for all teeth anterior to the first molar. The data was statistically analysed using intraclass correlation coefficient (ICC), Bland-Altman plots, and receiver operating characteristic (ROC) curves. The statistical significance level was set at a P-value<0.05. RESULTS: The study included 60 subjects (1200 teeth). The mean GT in both the maxillary (1.14±0.17mm) and mandibular (0.94±0.15mm) arches was significantly greater (P<0.05) for the transgingival probing method than for the CBCT method. As shown in the Bland-Altman plot, the bias between the two methods was greater in the maxillary jaw (0.060; 95% CI: 0.044 to 0.076) and in individuals with a thick GP (0.096; 95% CI: 0.082 to 0.109). The optimal values for GT measurements were 1.15mm for the maxillary jaw, 1.02mm for the mandibular jaw, 1.02mm for males, and 1.09mm for females. CONCLUSIONS: CBCT exhibited notable precision in diagnosing GT, while demonstrating minimal disparities compared to the conventional transgingival probing technique, particularly evident in thin GPs, and in the mandibular dental arch. The constraints associated with the utilization of CBCT were observed in the maxillary arch and in cases with thick GP.